Streszczenie treści zawartej na stronie nr. 1
FCC Notice
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference
in a residential installation.
Trademarks
Trademarks are the rights of their respective owners.
Streszczenie treści zawartej na stronie nr. 2
1 English Table of Contents Usage Notice Precautions .......................................................................................... 2 Introduction Product Features .................................................................................. 3 Package Overview ............................................................................... 4 Product Overview ................................................................................. 5 Installation Connecting the Projector .
Streszczenie treści zawartej na stronie nr. 3
2 English Usage Notice Warning- Do not look into the lens. The bright light may hurt your eyes. Warning- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. Warning- Please do not open or disassemble the product as this may cause electric shock. Warning- When changing the lamp, please allow unit to cool down, and follow all changing instructions. Warning- This product will detect the life of the lamp itself. Please be sure to change the lamp when it sh
Streszczenie treści zawartej na stronie nr. 4
3 English Introduction Product Features This product, is an SVGA single chip 0.7” DLP Projector. The outstanding features of it are listed as follows: True SVGA, 800 x 600 addressable pixels 3.3 lbs. (1.5 kgs) lightweight compact design Single chip DLP technology XGA compression and VGA, SVGA re-sizing 130 Watts user replaceable P-VIP lamp Mac/NEC PC-98/FM Towns compatible NTSC/NTSC4.43/PAL/PAL-M/PAL-N/SECAM and HDTV (720P,480i/P) compatible Full function remote control High
Streszczenie treści zawartej na stronie nr. 5
4 English Package Overview This projection display comes with all the items shown below. Check to make sure your unit is complete. Contact your dealer immediately if anything is missing. Projection Display Power Cord VGA Signal Cable RCA Audio Cable S-Video Cable Composite Video Cable RCA to D-Sub Cable Carrying Case Remote Control User’s Guide Quick Start Card Battery x 2 Warranty Card
Streszczenie treści zawartej na stronie nr. 6
5 English Product Overview Panel Control Enter / Lamp Volume Mute Source Resync Warning LED Temperature Warning LED Four Directional Menu Power On / Standby Select Keys (On/Off) Main Unit Elevator Button Panel Control Speaker Remote Control Receiver Focus Ring Zoom Lens Power Connector Zoom Ring Connection Ports HDTV/Component Video & Computer Audio Input S-video Input Input Connector Connector Connector Composite Video Input Connector
Streszczenie treści zawartej na stronie nr. 7
6 English Remote Control Source Power / Standby Reset Resync Freeze Mute Menu Keystone Correction Volume ( + / - ) Four Directional Select Keys Enter Zoom In / Zoom Out
Streszczenie treści zawartej na stronie nr. 8
7 English Installation Connecting the Projector Power Cord Digital Tuner Output Antenna RCA to D-Sub Cable RGB Port VGA Signal Cable Composite Video Cable RCA Audio Cable S-Video Output RGB Port S-Video Cable VGA Signal Cable Video Output Audio Output To ensure the projector works well with your computer, please configure the display mode of your graphic card to make it less than or equal to 800 X 600 resolution. Make sure timimg of the display mode is compatible with the projector. Refer to t
Streszczenie treści zawartej na stronie nr. 9
8 English Power On/Off the Projector Powering On the Projector 1. Remove the lens cap. 2. Ensure that the power cord and signal cable are securely connected. 3. The “Power/Standby” indicator will flash. And press the “Power/Standby” button again to start on your projector. The startup screen will display for 20 seconds and the Power/Standby indicator will light solid amber. 4. Turn on your source (computer, notebook, or video player ,etc.). The projector will detect your source auto
Streszczenie treści zawartej na stronie nr. 10
9 English Powering Off the Projector 1. Press the “Power/Standby” button to turn off the projector lamp. 2. After pressing the “Power/Standby” button, you will see a message “Power off the lamp?” on the on-screen display. Press the “Power/Standby” button again to confirm. Otherwise the message will disappear after 5 seconds. 3. “Power/Standby” LED indicator will flash amber for about 30 seconds. 4. Disconnect the power cord from the electrical outlet and the projector. * When the “LAMP
Streszczenie treści zawartej na stronie nr. 11
10 English Adjusting the Projected Image Adjusting the Projector Height The projector is equipped with an elevator foot for adjusting the projector height. To raise the projector: 1. Press the elevator button . 2. Raise the projector to the desired display angle , then release the button to lock the elevator foot into position. 3. Use to fine-tune height adjustment. To lower the projector: 1. Press the elevator button. 2. Lower down the projector, then release the button to lock th
Streszczenie treści zawartej na stronie nr. 12
11 English Adjusting the Projector Zoom / Focus You may adjust zoom ring to zoom in / out. Rotate the zoom ring counter-clockwise to zoom in and clockwise to zoom out. To focus the image, rotate the focus ring until the image is clear. The projector will focus at distances from 3.3 feet to 39.4 feet (1m to 12m). Zoom Ring Focus Ring Adjusting Projection Image Size Screen Max. 25" 98" 123" 197" 246" 300" (Diagonal)M" in. 2" 0 8" 2 1" 02 1" 63 2" 04 245 Max.(WxH) 20.0" x 15.
Streszczenie treści zawartej na stronie nr. 13
12 English User Controls Panel Control & Remote Control There are two ways for you to control the functions: Remote Control and Panel Control. Panel Control Remote Control Power / Standby Refer to the “Power On/Off the Projection Display” section on page 8~9. Source Press “Source” to choose RGB, Digital RGB, S-Video and Composite sources. Reset When you press the “Reset” button, the OSD menus displays a message “Reset All Yes/NO ? ”. Select “Yes” to confirm or select “ No” to cancel.This f
Streszczenie treści zawartej na stronie nr. 14
13 English Use the Panel Control Automatically synchronizes the projector to the input source, when you press this button while the OSD isn’t displayed. Four Directional Select Keys Use or to select items. Use or to make adjustments for your selection. Menu Press “Menu” to open the on-screen display (OSD) menus and press key to select main menu . To exit OSD, press the “ Menu” button again. The projector saves any changes you made automatically. Freeze Press the “Freeze” button
Streszczenie treści zawartej na stronie nr. 15
14 English On-Screen Display Menus How to operate The Projector has a multilingual On-Screen Display(OSD) menu that allows you to make image adjustments and change a variety of settings. In computer source, the OSD will be the “Computer OSD”. In video source, the OSD will be the “ Video OSD”. The projector will detect the source automatically. To open the OSD menu, press the “Menu” button on the Remote Control or Panel Control. When OSD is displayed, press key to select main menu. E.g.
Streszczenie treści zawartej na stronie nr. 16
15 English Computer mode Language Management Image-I Image-II Audio Brightness Zoom Contrast Keystone Color Temp. Image-I (Computer mode) Brightness Adjusting the brightness of the image. Press the to darken the image. Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image. Press the to decrease the contrast. Pres
Streszczenie treści zawartej na stronie nr. 17
16 English Video mode Language Management Image-I Image-II Audio Brightness Sharpness Contrast Tint Color Image-I (Video mode) Brightness Adjusting the brightness of the image. Press the to darken the image. Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image. Press the to decrease the contrast. Press the to
Streszczenie treści zawartej na stronie nr. 18
17 English Computer mode Language Management Image-I Image-II Audio Frequency H. Position Tracking V. Position 16:9 / 4:3 Reset Yes No Image-II (Computer mode) Frequency “Frequency” is for changing the display data frequency to match the frequency of your computer’s graphic card. When you experience a vertical flickering bar, use this function to make an adjustment. Tracking Choose “ Tracking” item to synchronize the signal timing of the display with that of the graphic card. When you experi
Streszczenie treści zawartej na stronie nr. 19
18 English Video mode Language Management Image-I Image-II Audio Keystone Color Temp. 16:9 / 4:3 Reset Yes No Image-II (Video mode) Keystone Correction Adjusts image distortion caused by tilting the projector. 16 : 9 / 4 : 3 You can select this function to fit your desired aspect ratio type. Color Temperature Adjusts the color temperature. The range is from 6500K to 9000K . The factory default is 7750K . With the higher temperature, the screen looks colder; with the lower temperature,
Streszczenie treści zawartej na stronie nr. 20
19 English Computer / Video mode Computer / Video mode Language Management Image-I Image-II Audio Image-I Image-II Audio Language Management Volume Stereo / Mono Treble Mute Bass Audio Volume Press the to decrease the volume. Press the to increase the volume. Treble The treble setting controls the higher frequencies of your audio source. Press the to decrease the treble. Press the to increase the treble. Bass The Bass setting controls the lower frequencies of your audio
