Instrukcja obsługi Talk electronic VOIP-RF-900

Streszczenie treści zawartej na stronie nr. 1

VOIP-RF-900 Installation Instructions
I. Introduction
Talk-A-Phone's 900Mhz radios are shipped as matched pairs and require no programming or dipswitch
adjustments. The output is IP, which requires a Talk-A-Phone VOIP-1 (or equivalent) to communicate with a
Talk-A-Phone Emergency Phone.

NOTE: The VOIP-RF-900 ship as matched pairs that are hard linked. Please do not mix paired units since a
mismatched pair will NOT work as expected.

II. Contents
Before beginning installatio

Streszczenie treści zawartej na stronie nr. 2

VOIP-RF-900 Installation Instructions V. Manual Frequency Selection To restrict the operation of the VOIP-RF-900 to a specific channel or center frequency, you may wish to select a specific channel by setting DIP switches 5 to 8 on the “master” radio as shown in the table below (set DIP #2 and DIP #3 to the OFF position). In order to gain access to the DIP switches you will need to open the NEMA box cover on the “master” radio. Table 1. VOIP-RF-900 DIP Switch Settings. Channel DIP #5 Se

Streszczenie treści zawartej na stronie nr. 3

VOIP-RF-900 Installation Instructions VI. LED Display Legend The “master” radio has an array of LEDs that provide various status indicators. Table 2 provides a legend or key for these various indicators. In order to gain access to the LED array, you will need to open the NEMA box cover on the “master” radio. Table 2. VOIP-RF-900 LED Display Legend. Name Function Color Power Unit has power and has successfully booted RED RF Link The radio has successfully synchronized with its GREEN m

Streszczenie treści zawartej na stronie nr. 4

VOIP-RF-900 Installation Instructions