Instrukcja obsługi Audiovox remote AVX01BT3CL3

Streszczenie treści zawartej na stronie nr. 1

Model AVX01BT3CL3
TRANSMITTER PROGRAMMING GUIDE
The transmitters included with the system have been pre-programmed at
the factory, with each button pre-assigned to control a specific function of
the system. Although the system in the vehicle has either a 3, 4, or 5 channel
RECEIVER, depending on the model, the transmitters included with the
system are 7 channel transmitters. This allows you to program each
transmitter to more than one vehicle in two car families and also allows you
to change whi

Streszczenie treści zawartej na stronie nr. 2

PROGRAMMING TRANSMITTERS: It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically exit program mode. This is indicated by a long "chirp" from the siren. Additionally, any time the ignition key is turned off while programming, the system will immediately exit program mode. This is also indicated by a long "chirp" from the

Streszczenie treści zawartej na stronie nr. 3

The chirp tone confirms that programming of channel 1 was successful. Up to 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp tone is heard, or move to step #5 (b) You can assign the Lock/Unlock, Arm/Disarm button, by pressing and holding the lock/unlock button until the siren emits a long chirp tone. The chirp tone confirms that programming of channel 1 was successful. Up to 4 transmitters can be programmed, press and hold the se

Streszczenie treści zawartej na stronie nr. 4

10. Press and release the valet/override switch one time to advance to channel 4 if so equipped. If your system does not have a 4th channel, a long chirp followed by a short chirp tone will indicate that the program mode has been exited. 11. The dash mounted LED will flash 4 times and siren will "chirp" 4 times indicating that the system is ready to accept programming of channel 4. 12. (a)Press and hold any combination of two buttons simultaneously, until the siren emits a long chirp tone. Th

Streszczenie treści zawartej na stronie nr. 5

BATTERY REPLACEMENT: The transmitter incorporates a small red LED visible through the case. This LED can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. Transmitter battery replacement is recommended at least every 10 to 12 months, depending upon how frequently the transmitter is used. To replace the battery... 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case. 2.

Streszczenie treści zawartej na stronie nr. 6

               01333 01333 01333 01333 01333      60 60 60 60 60 61 61 61 61 61 IMPORTANT: To help us expedite your order, please print all of the information legibly, and mail this form and your payment according to the instructions below. Please