Streszczenie treści zawartej na stronie nr. 1
TABLE OF CONTENTS
ABOUT THIS GUIDE .....................................................................5
INTRODUCTION .............................................................................6
SYSTEM REQUIREMENT ............................................................7
WIRELESS INTERNET CAMERA ............................................................7
Network:.........................................................................................7
Recommended PC or Notebook to
Streszczenie treści zawartej na stronie nr. 2
UNPACKING THE WIRELESS INTERNET CAMERA ... 18 GETTING STARTED .................................................................... 65 CONNECTING THE WIRELESS INTERNET CAMERA TO THE CAMERA IPVIEW SE ........................................................................................ 65 STAND............................................................................................... 19 IPView SE control panel.............................................................. 66 Minimize .....
Streszczenie treści zawartej na stronie nr. 3
D TIME ZONE TABLE......................................................................... 94 E XPLUG CONTROL INSTALLATION ................................................... 97 ABOUT THIS GUIDE F ADJUST INTERNET CAMERA FOCUS.............................................. 101 G SPECIFICATION ............................................................................ 102 HGLOSSARY OF TERMS ................................................................... 105 This manual describes the
Streszczenie treści zawartej na stronie nr. 4
1 2 INTRODUCTION SYSTEM REQUIREMENT Thank you for purchasing the Wireless Internet Camera, a camera device that can be connected directly to an Ethernet or Fast Ethernet network and also supported by the wireless transmission based on the IEEE 802.11b standard. Compared to the conventional PC Camera, the Wireless Internet Camera features a Wireless Internet Camera built-in CPU and web-based solutions that can provide a cost- effective solution to transmit real-time high-quality vid
Streszczenie treści zawartej na stronie nr. 5
• Internet Explorer 5.0 or above (ActiveX & JAVA Mode – Image View for Windows OS and JAVA Mode – Image 3 View for other OS) • Netscape 6.0 or above (JAVA Mode – Image View) IPView SE Application: FEATURES AND Support OS: Win 98 SE, Win 2000, Win Me, Win XP BENEFITS System requirement for IPView SE: CPU: Pentium III, 450 MHz or above Memory Size: 128 MB (256 MB recommended) VGA card resolution: 800x600 or above This section describes the features and benefits of the Wireless
Streszczenie treści zawartej na stronie nr. 6
Support Variety of Platforms Broad Range of Applications The Wireless Internet Camera supports TCP/IP networking, With today’s high-speed Internet services, the Wireless Internet SMTP e-mail, HTTP and other Internet related protocols, and can Camera can provide the ideal solution for live video images over be utilized in a mixed operating system environment such as the Intranet and Internet for remote monitoring. The Wireless Windows, Unix, and Mac. It can be integrated easily into other I
Streszczenie treści zawartej na stronie nr. 7
Power LED 4 The Power LED is positioned on the right side of the Wireless Internet Camera’s lens while facing the Wireless Internet Camera. A steady blue light confirms that the Wireless Internet Camera is PHYSICAL powered on. DESCRIPTION Link LED The Link LED is positioned on the right side of the Wireless Internet Camera’s lens while facing the Wireless Internet Camera. This section describes the externally visible features of the It is located right of the Power LED Wir
Streszczenie treści zawartej na stronie nr. 8
will be generated when the power supply is connected to a wall outlet. Rear Panel Reset Button Reset will be initiated when the reset button is pressed once, and 10/100 Ethernet Power LED begins to flash. ANT DC Power Reset Connector Factory Reset will be initiated when the reset button is pressed DC 5V continuously for three seconds or when Power LED begins to light up. Release the reset button and the Power LED will begin to flash, indicating the Wireless Internet Cam
Streszczenie treści zawartej na stronie nr. 9
Top Panel Bottom Panel Screw Hole Screw Hole Screw Hole Located on the top panel of the Wireless Internet Camera, the Screw Hole screw hole is used to connect the camera stand onto the Wireless Internet Camera by attaching the screw head on the camera stand into the screw hole of the Wireless Internet Camera. Located on the bottom panel of the Wireless Internet Camera, the screw hole is used to connect the camera stand onto the Wireless Internet Came
Streszczenie treści zawartej na stronie nr. 10
Connecting the Wireless Internet 5 Camera to the Camera Stand UNPACKING THE The Wireless Internet Camera comes with a camera stand (optional) with a WIRELESS INTERNET swivel ball screw head that can be attached to the Wireless Internet Camera's bottom CAMERA screw hole. Attach the camera stand to the Wireless Internet Camera and station it for your application. There are three holes located in the base of the camera stand allowing the Wireless Internet Camera to Carefully
Streszczenie treści zawartej na stronie nr. 11
2 Connect an Ethernet cable 6 Connect an Ethernet cable to the network cable connector located HARDWARE on the Wireless Internet Camera’s rear panel, and then attach it to INSTALLATION the network. This section describes the Hardware installation procedure for the Wireless Internet Camera. 3 Attach the external power supply 1 Attach Wireless Antenna Attach the external power From the rear panel of the Wireless supply to the DC power input Internet Camer
Streszczenie treści zawartej na stronie nr. 12
features with the Wireless Internet Camera will not be enabled until the "Admin ID" and "Admin Password" is defined. 7 SECURITY To ensure the highest security and prevent unauthorized usage of the Wireless Internet Camera the Administrator has the exclusive privilege to access the System Administration for settings and control requirements to allow users the level of entry and authorize the privileges for all users. The Wireless Internet Camera supports multi-level password protection
Streszczenie treści zawartej na stronie nr. 13
address box. The number is the default IP address of your Wireless Internet Camera. Then, press [Enter]. 8 SOFTWARE INSTALLATION Note: The PC’s IP address must correspond with the Wireless Internet Camera’s IP address in the same segment for the two devices to communicate. This section describes the Software installation procedure of the Wireless Internet Camera for Web Configuration and IPView SE application. Web Configuration The Wireless Internet Camera must be
Streszczenie treści zawartej na stronie nr. 14
Main Menu Image System Administration After the default IP address is entered from the browser, the Click “System Administration” from the Welcome screen to Wireless Internet Camera Welcome screen will appear with a still access the settings required for the Wireless Internet Camera. image. There will be three options to choose from to set-up and view your Wireless Internet Camera, including: There will be several options in the System menu bar to choose from to set your
Streszczenie treści zawartej na stronie nr. 15
Click "System" in the system administration menu bar, and the System screen will appear as illustrated below: Click “Home” to return to Welcome Screen Camera Name: This field is used to enter a descriptive name for the device. The default setting for the Camera Name is CS-xxxxxx, where xxxxxx is the last six digit of the MAC Address. The maximum length is 32 (Printable ASCII). Location: This field is used to enter a descriptive name for the location used by the Wir
Streszczenie treści zawartej na stronie nr. 16
The default setting for Admin is blank space (Null String), and Assign Automatically Using you need to key in the Admin ID with a maximum length of 12 If your network is using RARP, BOOTP or DHCP server, you (Printable ASCII) characters and enter the Admin Password with can click “Assign Automatically Using” and then click a maximum length of 8 (Printable ASCII) characters. “RARP”, “BOOTP” or “DHCP”. Under this setting the Wireless Internet Camera will automatically assign an IP addr
Streszczenie treści zawartej na stronie nr. 17
Wireless Interface: Wireless Channel: Connection Mode: The pull down menu provides the wireless channel for Use the Connection Mode to determine the type of wireless communication. A "channel" is a range of frequencies to be used communication for the Wireless Internet Camera. There are three in communication between the Wireless Internet Camera and choices of Infrastructure mode, and Adhoc mode. The default Access Point in infrastructure mode or the Wireless Internet setting for the Con
Streszczenie treści zawartej na stronie nr. 18
HEX input format: LED Control: Hex format causes each pair of characters you type to be The LED control allows user to setup the LED illumination as interpreted as an eight-bit value in hexadecimal (base 16) notation. desired. This feature provides the flexibility when surveillance Only the digits 0 through 9 and the letters A through F (in upper activity is ON. or lower case) are valid. To setup 64-bit WEP key, input 10 HEX There are three options as follows: format, for example, ‘3
Streszczenie treści zawartej na stronie nr. 19
Loading ActiveX From: This field is used to specify the location of Xplug Control You also need to setup your DSL gateway for Port Mapping. (ActiveX) plug-in program. Enter the information as required in .ocx format, for example: Port 81 map to 192.168.0.101 http://www..com/xplug.ocx, where must be replaced with your company’s DNS server. Port 83 map to 192.168.0.103 Or it can be installed from the CD come with the internet camer
Streszczenie treści zawartej na stronie nr. 20
Frame Rate: System Administration - Image Select the frame rate desired with default setting at Auto for optimal frame rate. Image menu in the system administration contains commands to provide the settings for the images captured by the Wireless Internet Camera. Brightness Control: Adjust the brightness level with default setting at 64. Click “Image” in the system administration menu bar and the Image screen will appear as illustrated below: Contrast Control: Adjust the contra
