Instrukcja obsługi Antec PERFORMANCE PLUS PLUS1000

Streszczenie treści zawartej na stronie nr. 1

User’s Manual
PLUS1000 Series
SOHO File Server Case

Streszczenie treści zawartej na stronie nr. 2

Set Up Disclaimer 1. Take the case out of the box. This manual is intended only as a guide for Antec's Computer Enclosures. For more 2. Remove the Styrofoam. comprehensive instructions on installing your motherboard and peripherals, please refer 3. Remove the plastic bag. to the user's manuals which come with your components and drives. 4. Place the case upright on a stable flat surface with the power supply fan at the back facing you . 5. Remove the screws from the side panel with the latch

Streszczenie treści zawartej na stronie nr. 3

4. Power Switch (labeled POWER SW) connects to the PWR connector on the 3.5" Device Installation motherboard. With the front bezel facing you, swing the plastic bezel cover out. You can see there are 5. Speaker (labeled SPEAKER) connector is behind the PWR connector. four 5.25" and two 3.5" external drive bays. 6. Hard Drive LED (labeled H.D.D. LED) connects to the IDE connector. Inside the case there are two 3.5" drive cages. 7. LED I, LED II connectors: This case comes with two extra LED

Streszczenie treści zawartej na stronie nr. 4

Optional Cooling fans: The case has two optional 80mm cooling fans that can be installed in the front of the case. One of the optional fans is located inside the 3.5" drive cage. You should install the fan first before you mount your drives into the cage. Install the fans so that the air is blowing into the case from the front. 1. Drop the fan into the fan bracket and push it in until it snaps in. 2. Connect a large 4-pin white connector from the power supply to the male 4-pin connector on