Instrukcja obsługi RCA WSP150

Streszczenie treści zawartej na stronie nr. 1

RF 900 MHz
STEREO WIRELESS
SPEAKER SYSTEM
(WSP150)
TABLE OF CONTENTS
Introduction ....................................................................................2
Features ............................................................................................2
Care and Maintaince ......................................................................2
Parts ..................................................................................................3
Instillation ..................

Streszczenie treści zawartej na stronie nr. 2

INTRODUCTION This WSP150 Wireless Speaker system uses the latest 900 MHz RF technology that enables you to enjoy stereo sound anywhere around your home - even outside on your deck or patio! Just follow the simple instructions to connect the transmitter to any audio source (CD, DSS, VCR, Stereo, Radio or TV) for full stereo sound without the need to run wires to your speakers. You may place the speakers anywhere within range (approx. 150 feet) of the transmitter to receive the stereo signal. FEAT

Streszczenie treści zawartej na stronie nr. 3

TRANSMITTER FREQ. ADJUST POWER ON / SIGNAL INDICATOR (GREEN) AUDIO INPUT PLUG Front Back SPEAKER RECEIVER WALL MOUNT HOLE DC INPUT 6V 800mA POWER STEREO LED (ST.) STAND BY LED TUNING VOLUME ON/OFF BATTERY DOOR NORMAL/BOOST CONTROL BASS Back Front

Streszczenie treści zawartej na stronie nr. 4

INSTALLATION TRANSMITTER 1. Plug the supplied AC power adapter into an electrical outlet near your audio source. Make sure it is the one for the transmitter ("DC 19V") - the two for the speakers are marked accordingly. 2. Connect the plug end of the power adapter to the DC jack located on the back of the transmitter (see diagram). 3. Locate the audio input cord on the back of the transmitter. The 3.5 mm standard plug can be used to fit most headphone output jacks in audio equipment. If you are

Streszczenie treści zawartej na stronie nr. 5

INSTALLATION (cont.) AUDIO STANDARD RCA OUT CONNECTOR TRANSMITTER (AUDIO CORD) NOISE FILTER SPEAKER RECEIVER 1. You may use either the AC adapter or 4 - "D" size alkaline batteries (not included) to power the speaker. Make sure the "Volume On/Off Control" knob is turned to the off position. 2. If you are using the AC adapter, locate the ones marked "For Speaker" on the label and plug them into an electrical outlet located near the location for each speaker. Then insert the plug end into the DC I

Streszczenie treści zawartej na stronie nr. 6

INSTALLATION (cont.) 5 The BASS BOOST switch can be used to enhance the sound depending on your own music preferences. To improve the bass response of the speaker, simply slide the switch to the right position. Once you have properly followed the setup procedure, you may position the speakers in any location within approximately 150 feet of the transmitter to enjoy quality stereo sound. OPERATION NOTES If you notice a disruption of the sound or the signal breaks up, adjust the speakers tuning co

Streszczenie treści zawartej na stronie nr. 7

SPECIFICATIONS Transmission Mode UHF stereo Carrier Frequency 900 MHz Operation Voltage Transmitter, 19V 200mA Speaker, 6V (8 x “D” size Alkaline batteries) 6V 800mA adapter (optional) Frequency Response 20 Hz - 15 KHz Distortion 1.5% S/N ratio 60dB Separation 30 dB Operation distance 50 M WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Operation is subject to the following two