Instrukcja obsługi Abocom SW800AI

Streszczenie treści zawartej na stronie nr. 1

8-Port Fast Ethernet
10/100Mbps N-Way Switch



User’s Guide
M73-APO09-200

Streszczenie treści zawartej na stronie nr. 2

FCC REGULATORY STATEMENTS Part15, Class B This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interface, and 2. This device must accept any interface received, including interface that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable prot

Streszczenie treści zawartej na stronie nr. 3

INTRODUCTION The 8-Port Fast Ethernet 10/100Mbps N-Way Switch provides you a flexible, reliable, and affordable solution of the Ethernet network. It comes with eight independent 10BASE-T /100BASE-TX ports. Each port delivers up to 200Mbps throughput, and is able to operate in either half or full-duplex modes. The 8-Port Fast Ethernet 10/100Mbps N-Way Switch also processes a N-Way auto-negotiation function, which automatically adjusts the device for optimum operation; “Store-and-Forwar

Streszczenie treści zawartej na stronie nr. 4

Each Ethernet port supports MDI/MDIX auto crossover capacity 2K MAC Address with automatic learning and 5-minute aging 8 (Eight) 10/100Mbps Auto-Detection ports Dimension (WxDxH): 190mm x 78mm x 32mm Automatic power saving 8 x RJ45 STP/UTP network ports on rear panel Maximum 100m per port Hub-to-Hub or Node- to-Hub cable length Emission Certification: FCC/CE Class B Operating Environment: o Temperature: 0 ~ 40 C; Humidity: 5 ~ 90 % RH Built in Universal Power Supply: 100

Streszczenie treści zawartej na stronie nr. 5

PARTS NAMES AND FUNCTIONS Front Panel LED Indications LED Status Description POWER ON Power On ON A valid connection LINK/ACT Blinks Receives packets Connects to a 100Mbps ON Fast Ethernet connection SPD Connects to a 10Mbps OFF Ethernet connection Ethernet Ports (1-8) Ethernet Ports with MDI/MDIX auto crossover capacity. Power Port Connect to the External power cord. - 3 -

Streszczenie treści zawartej na stronie nr. 6

HARDWARE INSTALLATION Hub installation The hub is considered as a “plug and play” network device and requires no special setup except for plugging the appropriate power cord and cables. 1. Put the hub on the appropriate location. When you install the hub, there are two things needed to be considered: Location: Your hub should be located in a place that is central to your home/office space and allows all computers and networked devices connected to your hub. Power: Remember to loca