Streszczenie treści zawartej na stronie nr. 1
8-Port 10/100/1000 Gigabit Switch
with WebView
User Guide
WIRED
Model No.
SRW2008/SRW2008P/SRW2008MP
Streszczenie treści zawartej na stronie nr. 2
WebView Switches Copyright and Trademarks Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2006 Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, a
Streszczenie treści zawartej na stronie nr. 3
WebView Switches Table of Contents Chapter 1: Introduction 1 Welcome 1 What’s in this User Guide? 3 Chapter 2: Getting to Know the Switch 4 Overview 4 SRW2008 - Front Panel 4 SRW2008P, SRW2008MP - Front Panel 6 The Back Panel 7 Chapter 3: Connecting the Switch 8 Overview 8 Before You Install the Switch... 9 Placement Options 9 Connecting the Switch 12 Chapter 4: Using the Console Interface for Configuration 13 Overview 13 Configuring the HyperTerminal Application 13 Connecting to the Switch thro
Streszczenie treści zawartej na stronie nr. 4
WebView Switches VLAN Management Tab - GVRP 40 Statistics Tab - RMON Statistics 40 Statistics Tab - RMON History 42 Statistics Tab - RMON Alarm 44 Statistics Tab - RMON Events 45 Statistics Tab - Port Utilization 46 Statistics Tab - 802.1x Statistics 47 Statistics Tab - GVRP Statistics 47 ACL Tab - IP Based ACL 48 ACL Tab - MAC Based ACL 51 Security Tab - ACL Binding 52 Security Tab - RADIUS 52 Security Tab - TACACS+ 53 Security Tab - 802.1x Settings 54 Security Tab - Port Security 55 Security T
Streszczenie treści zawartej na stronie nr. 5
WebView Switches SNMP Tab - Views 75 SNMP Tab - Group Profile 76 SNMP Tab - Group Membership 77 SNMP Tab - Communities 78 SNMP Tab - Notification Filter 79 SNMP Tab - Notification Recipient 80 Admin Tab - User Authentication 81 Admin Tab - Jumbo Frames 82 Admin Tab - Static Address 82 Admin Tab - Dynamic Address 83 Admin Tab - Logging 84 Admin Tab - Port Mirroring 85 Admin Tab - Cable Test 85 Admin Tab - Save Configuration 86 Admin Tab - Firmware Upgrade 87 Admin Tab - Reboot 87 Admin Tab - Fact
Streszczenie treści zawartej na stronie nr. 6
WebView Switches List of Figures Figure 2-1: Front Panel of the SRW2008 4 Figure 2-2: Front Panel of the SRW2008P 6 Figure 2-3: Back Panel of the SRW2008P 7 Figure 3-1: Typical Network Configuration for the SRW2008P 8 Figure 3-2: Attach the Brackets to the Switch 10 Figure 3-3: Mount the Switch in the Rack 10 Figure 3-4: Proper Wall-Mount Orientation (Horizontal) 11 Figure 3-5: Incorrect Wall-Mount Orientation (Vertical) 11 Figure 3-6: Wall-Mount Template 11 Figure 4-1: Finding HyperTerminal 13
Streszczenie treści zawartej na stronie nr. 7
WebView Switches Figure 4-20: Security Settings 21 Figure 4-21: SSL Certificate Generation 21 Figure 4-22: SSL Certificate 22 Figure 4-23: IP Configuration 22 Figure 4-24: IP Address Configuration 23 Figure 4-25: HTTP 23 Figure 4-26: HTTPS Configuration 23 Figure 4-27: Network Configuration 24 Figure 4-28: Ping Test 24 Figure 4-29: TraceRoute Test 24 Figure 4-30: File Management 25 Figure 4-31: Restore System Default Settings 25 Figure 4-32: Reboot System 25 Figure 4-33: Port Status 26 Figure 4-
Streszczenie treści zawartej na stronie nr. 8
WebView Switches Figure 5-16: VLAN Management - GVRP 40 Figure 5-17: Statistics - RMON Statistics 41 Figure 5-18: Statistics - RMON History 42 Figure 5-19: RMON History Table 43 Figure 5-20: Statistics - RMON Alarm 44 Figure 5-21: Statistics - RMON Events 45 Figure 5-22: RMON Events - Events Log 46 Figure 5-23: Statistics - Port Utilization 46 Figure 5-24: Statistics - 802.1x Statistics 47 Figure 5-25: Statistics - GVRP Statistics 47 Figure 5-26: ACL - IP Based ACL 49 Figure 5-27: ACL - Mac Base
Streszczenie treści zawartej na stronie nr. 9
WebView Switches Figure 5-46: Spanning Tree - STP Status 64 Figure 5-47: Spanning Tree - Global STP 65 Figure 5-48: Spanning Tree - STP Port Settings 66 Figure 5-49: Spanning Tree - RSTP Port Settings 67 Figure 5-50: Spanning Tree - MSTP Properties 69 Figure 5-51: Spanning Tree - MSTP Instance Settings 69 Figure 5-52: Spanning Tree - MSTP Interface Settings 70 Figure 5-53: Multicast - IGMP Snooping 72 Figure 5-54: Multicast - Bridge Multicast 73 Figure 5-55: Multicast - Bridge Multicast Forward
Streszczenie treści zawartej na stronie nr. 10
WebView Switches Figure C-1: Startup Menu 92 Figure C-1: Auto-Boot Message 92 Figure C-2: Send File 93 Figure C-3: Download 93
Streszczenie treści zawartej na stronie nr. 11
WebView Switches Chapter 1: Introduction Welcome This guide covers three product models. SRW2008 - 8-port 10/100/1000 Ethernet Switch with WebView. Includes 8 10/100/1000 RJ-45 ports and 2 shared MiniGBIC slots. SRW2008MP - 8-port 10/100/1000 Ethernet Switch with WebView and Maximum POE (Power over Ethernet) Includes 8 10/100/1000 RJ-45 ports and 2 shared MiniGBIC slots. SRW2008P - 8-port 10/100/1000 Ethernet Switch with WebView and POE (Power over Ethernet) Includes 8 10/100/1000 RJ-45
Streszczenie treści zawartej na stronie nr. 12
WebView Switches The SRW2008P and SRW2008MP support Automatic Load Sensing - Power control circuitry automatically detects Power over Ethernet on access point before providing power. Power feeding of Ethernet limited for fixed 10/100/1000 Base-T/TX ports. The SRW2008MP can provide maximum output power per PoE port up to 15.4W on 8 ports simultaneously. while the SRW2008P can provide maximum output power on 4 ports simultaneously or 8 ports at half power. Chapter 1: Introduction 2 Welcome
Streszczenie treści zawartej na stronie nr. 13
WebView Switches What’s in this User Guide? This user guide covers the steps for setting up and using the Switch. Chapter 1: Introduction This chapter describes the Switch’s applications and this User Guide. Chapter 2: Getting to Know the Switch This chapter describes the physical features of the Switch. Chapter 3: Connecting the Switch This chapter explains how to install and connect the Switch. Chapter 4: Using the Console Interface for Configuration This chapter instructs you on how t
Streszczenie treści zawartej na stronie nr. 14
WebView Switches Chapter 2: Getting to Know the Switch Overview The Switches differ in number and types of LEDs and ports. The front panel of each Switch is displayed on one of the following pages. The back panel is the same on all five models. SRW2008 - Front Panel The Switch's LEDs and ports are located on the front panel. Figure 2-1: Front Panel of the SRW2008 LEDs System Green. The SYSTEM LED lights up to indicate that the Switch is powered on. Link/Act Green. The LINK/ACT LED lights up to
Streszczenie treści zawartej na stronie nr. 15
WebView Switches Ports 1-8 The Switch is equipped with 8 auto-sensing, Ethernet network ports, which use RJ-45 connectors. The Fast Ethernet ports support network speeds of 10Mbps, 100Mbps, or 1000Mbps. They can operate in half and full-duplex modes. Auto-sensing technology enables each port to automatically detect the speed of the device connected to it (10Mbps, 100Mbps, or 1000Mbps), and adjust its speed and duplex accordingly. Console The Console port is where you can connect a serial cab
Streszczenie treści zawartej na stronie nr. 16
WebView Switches SRW2008P, SRW2008MP - Front Panel The Switch's LEDs and ports are located on the front panel. Figure 2-2: Front Panel of the SRW2008P LEDs System Green. The SYSTEM LED lights up to indicate that the Switch is powered on. Link/Act Green. The LINK/ACT LED lights up to indicate a functional network link through the corresponding port (1 through 8) with an attached device. It flashes to indicate that the NOTE: The SRW2008P supports up to 4 ports at 15.4W Switch is actively sendin
Streszczenie treści zawartej na stronie nr. 17
WebView Switches Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1 requires a Category 5e Ethernet cable with an RJ-45 connector. Console The Console port is where you can connect a serial cable to a PC’s serial port for configuration using your PC’s HyperTerminal program. Refer to Chapter 4: Using the Console Interface for Configuration for more information. The Back Panel The power
Streszczenie treści zawartej na stronie nr. 18
WebView Switches Chapter 3: Connecting the Switch Overview This chapter will explain how to connect network devices to the Switch. For an example of a typical network configuration, see the application diagram shown below. Cable/DSL 10/100/1000 10/100 Wireless Uplink via Fiber to Administrator’s Modem Router Desktop Notebook Access Point Switch Notebook Internet Figure 3-1: Typical Network Configuration for the SRW2008P When you connect your network devices, make sure you don’t exceed the maxi
Streszczenie treści zawartej na stronie nr. 19
WebView Switches Before You Install the Switch... When you choose a location for the Switch, observe the following guidelines: Make sure that the Switch will be accessible and that the cables can be easily connected. Keep cabling away from sources of electrical noise, power lines, and fluorescent lighting fixtures. Position the Switch away from water and moisture sources. To ensure adequate air flow around the Switch, be sure to provide a minimum clearance of two inches (50 mm). Do no
Streszczenie treści zawartej na stronie nr. 20
WebView Switches Rack-Mount Placement IMPORTANT: Make sure you use the screws supplied with the mounting brackets. Using the To mount the Switch in any standard-sized, 19-inch wide, 1U high rack, follow these instructions: wrong screws could damage the Switch and would invalidate your warranty. 1. Place the Switch on a hard flat surface with the front panel facing you. 2. Attach a rack–mount bracket to one side of the Switch with the supplied screws. Then attach the other bracket to the othe
