Instrukcja obsługi Sanyo RCS-KS2432AWD

Streszczenie treści zawartej na stronie nr. 1

03-242.Sanyo.85464359404000 8/21/03 9:17 AM Page 1
INSTALLATION INSTRUCTIONS
RCS-KS2432AWD
Table 1
Parts supplied with remote controller
No. Supplied parts Q’ty No. Supplied parts Q’ty
See Table 1.
Remote Wire joints
controller
Remote controller installation guidelines
➀ 1 ➄ 6
(comes with
Installation location
200mm wire)
Machine screws Harness
• Mount the remote controller 1 to 1.5 meters off the
M4 × 25
floor where it can sense the average temperature of
➁ 2 ➅ 1
the room.
• Do not moun

Streszczenie treści zawartej na stronie nr. 2

03-242.Sanyo.85464359404000 8/21/03 9:17 AM Page 2 • For surface mounting on the wall, see Fig. 2. Under-case (back case) 1. Insert a screwdriver or the like in the groove on the Remote controller lower side of the remote controller to pry off the Lead back case. (See Fig. 3) Wall wires (3) 2. Use the 2 supplied M4 × 25 machine screws for embeded mounting or M4 × 25 tapping screws for surface mounting to secure the remote controller back case. Prior to mounting, clear the cutouts in the back

Streszczenie treści zawartej na stronie nr. 3

03-242.Sanyo.85464359404000 8/21/03 9:17 AM Page 3 • Electric Wiring Diagram TERMINAL PLATE WHT FAN MOTOR 1 GRN / YEL BLK 2 G GRN G FMI G RED 4 G GRN CONNECTOR 135 87654321 [WHT] 135 w 87654321 SUP CAPACITOR G 5P [WHT] PNK PRY BRN 1 1 WHT 3P [RED] 3 3 WHT w FM P GRY w WHT HH w VLT H ORG w M SEC S 1 1 BRN YEL w L 2P [WHT] 2 2 BRN w BLK LL 3 3 CONNECTOR RECEIVER WHT CN11 2 2 1 1 [WHT] [WHT] [WHT] 3P [WHT] 1 1 GRY WHT 2 2 1 1 1 1 GRY BLU 3 3 2 2 2 2 FLAP1 WHT 1 1 4 4 3 3 BLU 3 3 FLP 5P [WHT] GR

Streszczenie treści zawartej na stronie nr. 4

03-242.Sanyo.85464359404000 8/21/03 9:17 AM Page 4 How to test run the air conditioner INDOOR UNIT 1. Switch on the power source. 2. Press the ON/OFF button on the remote control unit ON once. OFF TEST 3. Set the operation selector switch of the indoor unit to the TEST position. This starts the fan, producing Operation selector uncooled forced air. (Fig. 7) OPERATION lamp Remote control TIMER lamp receiver 4. After 3 minutes, the system shifts into cooling oper- ation, and cool air will sta