Instrukcja obsługi PYLE Audio View Series PLVW1345R

Streszczenie treści zawartej na stronie nr. 1

1

Streszczenie treści zawartej na stronie nr. 2

TABLE OF CONTENT 1. INSTALLATION GUIDE 2. FUNCTION KEYS 2.1 FUNCTIONS OF FRONT PANEL 2.2 FUNCTIONS OF REMOTE CONTROL 3. TROUBLE SHOOTING 3.1 NO POWER 3.2 NO FUNCTION OF REMOTE CONTROL 3.3 NO DISPLAY OR NOT CLEAR 4. ACCESSORIES 5. SPECIFICATIONS 2

Streszczenie treści zawartej na stronie nr. 3

1. INSTALLATION GUIDE 1. On a towel or soft cloth, gently place the monitor unit "facedown" on a stable work surface. 2. Locate the pigtail with the DIN connector. 3. Connect the DIN connector to the interface cable provided. 4. Connect the RED wire to the positive (+) battery terminal. 5. Connect the Black wire to a chassis electrical ground point. 6. Connect the cable with YELLOW RCA jack to Video Input sources for your Video Program material. 7. Connect the cable with RED and WHITE

Streszczenie treści zawartej na stronie nr. 4

2. FUNCTION KEYS 2.1 FUNCTIONS OF FRONT PANEL POWER: 1. Press the "POWER" button once; it will be "POWER ON." Press it again; it will be "POWER OFF." MENU: 1. Pop up the OSD menus. Press the "Menu" button again to enter the OSD menus. When in sub-menu, press. "EXIT" to go back to the main menu. UP/DN: 1. Press the "UP/DOWN" key to increase or decrease value 2. Make item selection in OSD menus to increase or decrease

Streszczenie treści zawartej na stronie nr. 5

Brightness: → Brightness adjustment Contrast: → Contrast adjustment Display adjust: → Sharpness hue, saturation adjustment OSD display: → OSD adjustment and display methods Input select: → Switch the source of signal AV1 and AV2 Inputs. Audio: → Only control Mute Recall: → Return to the initiatives Exit: → Exit Press "Menu key", it will display a crosswise bar with digits. To use U/D key to adjust value and press "Menu key" to confirm the adjustment and the

Streszczenie treści zawartej na stronie nr. 6

3.1 NO POWER 1. Make sure the power cable has been pluged in. 2. Make sure the plug has 12V~14V, may use another electrical appliance to test it. 3.2 NO FUNCTION OF REMOTE CONTROL 1. Make sure the batteries are in good condition and installed properly. 2. Make sure the remote control is aiming at the receiver, and there are no obstacles in between. 3. Perhaps, it is too far away from the receiver. Normal distance is within 7 meters. 3.2 NO DISPLAY OR NOT CLEAR 1. Check the video

Streszczenie treści zawartej na stronie nr. 7

ITEM DESCRIPTION LCD Panel 13.3" TFT Active Area: 270.3 (W) x 202.8 (H) mm Resolution: 1024(H) x 3(RGB) x 768(V) Display Colors: 262,144 colors Pixel Pitch (mm): 0.264 (H) x 0.264 (V) mm Backlight Unit: CCFL Side-light type (single lamp) Contrast Ratio: 200 : 1 Brightness (cd/m2): 180 O O Viewing Angle: Horizontal:60 (typ.,Lift side), 60 (typ.,right side) O O Vertical: 30 (typ.,up side), 45 (typ.,down side) Power Supply: DC12V + 10% less than 1.3A IR Transmitter: Yes Power man