Instrukcja obsługi Sony MDS-E11

Instrukcja obsługi dla urządzenia Sony MDS-E11

Urządzenie: Sony MDS-E11
Kategoria: Magnetofon
Producent: Sony
Rozmiar: 0.8 MB
Data dodania: 7/28/2014
Liczba stron: 40
Drukuj instrukcję

Pobierz

Jak korzystać?

Naszym celem jest zapewnienie Ci jak najszybszego dostępu do treści zawartych w instrukcji obsługi urządzenia Sony MDS-E11. Korzystając z podglądu online możesz szybko przejrzeć spis treści i przejść do strony, na której znajdziesz rozwiązanie swojego problemu z Sony MDS-E11.

Dla Twojej wygody

Jeżeli przeglądanie instrukcji Sony MDS-E11 bezpośrednio na tej stornie nie jest dla Ciebie wygodne, możesz skorzystać z dwóch możliwych rozwiązań:

  • Przeglądanie pełnoekranowe - Aby wygodnie przeglądać instrukcję (bez pobierania jej na komputer) możesz wykorzystać tryp przeglądania pełnoekranowego. Aby uruchomić przeglądanie instrukcji Sony MDS-E11 na pełnym ekranie, użyj przycisku Pełny ekran.
  • Pobranie na komputer - Możesz również pobrać instrukcję Sony MDS-E11 na swój komputer i zachować ją w swoich zbiorach. Jeżeli nie chcesz jednak marnować miejsca na swoim urządzeniu, zawsze możesz pobrać ją w przyszłości z ManualsBase.
Sony MDS-E11 Instrukcja obsługi - Online PDF
Advertisement
« Page 1 of 40 »
Advertisement
Wersja drukowana

Wiele osób woli czytać dokumenty nie na ekranie, lecz w wersji drukowanej. Opcja wydruku instrukcji również została przewidziana i możesz z niej skorzystać klikając w link znajdujący się powyżej - Drukuj instrukcję. Nie musisz drukować całej instrukcji Sony MDS-E11 a jedynie wybrane strony. Szanuj papier.

Streszczenia

Poniżej znajdziesz zajawki treści znajdujących się na kolejnych stronach instrukcji do Sony MDS-E11. Jeżeli chcesz szybko przejrzeć zawartość stron znajdujących się na kolejnych strinach instrukcji, możesz z nich skorzystać.

Streszczenia treści
Streszczenie treści zawartej na stronie nr. 1

2-346-664-12(1)
MiniDisc Recorder
Operating Instructions
MDS-E11
ª 1998 by Sony Sound Tec Corporation

Streszczenie treści zawartej na stronie nr. 2

INFORMATION On operation WARNING This equipment has been tested and If the recorder is brought directly from a found to comply with the limits for a cold to a warm location, or is placed in a Class A digital device, pursuant to Part very damp room, moisture may Notice for the Customers in the 15 of the FCC Rules. These limits are condense on the lenses inside the United Kingdom designed to provide reasonable recorder. Should this occur, the protection against harmful interference recorder may n

Streszczenie treści zawartej na stronie nr. 3

TABLE OF CONTENTS Getting Started Unpacking ........................................................................................................................... 4 Connection .......................................................................................................................... 4 Basic Operations Recording on an MD ......................................................................................................... 6 Playing an MD ....................................

Streszczenie treści zawartej na stronie nr. 4

Getting Started Getting Started Unpacking Connection Check that you received the following items: • Remote commander (remote) RM-D7M (1) Overview • R6 (size AA) batteries (2) This section describes how to hook up the MD recorder to other components such as a mixer, CD player or DAT recorder. Be sure to turn off the power of each Inserting batteries into the remote component before connection. You can control the recorder using the supplied remote. Insert two R6 (size AA) batteries by matching t

Streszczenie treści zawartej na stronie nr. 5

Getting Started What cords will I need? Switch setting Output level • Audio connecting cords (pin type) +4dBu Signals having a metered level of –20 dB White White are generated at a +4 dBu level. (L) (L) –10dBu Signals having a metered level of –20 dB Red Red are generated at a –10 dBu level. (R) (R) • Audio connecting cords (XLR type) The BALANCE I/O connector specifications are as follows: Input terminal XLR-3-31 Output terminal XLR-3-32 • Coaxial digital connecting cable equivalent equivalent

Streszczenie treści zawartej na stronie nr. 6

Basic Operations Basic Operations Recording on an MD 23 54 8 6 7 Turn on the mixer and program source. 1 Press U. 2 Insert a recordable MD. 3 With the label side up With the arrow pointing this way If the MD has a recorded material on it, the recorder will automatically start recording from the end of the last recorded track. Analog input Set INPUT to the corresponding input connector. When using the analog input, 4 switch the rear-panel ANALOG To record through Set INPUT to INPUT (BAL or UNBAL)

Streszczenie treści zawartej na stronie nr. 7

Basic Operations Basic Operations Press r. 6 The recorder stands by for record. When recording the analog input signal, adjust the recording 7 level with REC LEVEL. The fourth dot is satisfactory for most purposes. For details, refer to “Adjusting the Recording Level” on page 11. Press á or P. 8 Recording starts. Start playing the program source. 9 When ”TOC“ indicator flashes in Do not turn off the power or disconnect the recorder from the power source the display immediately after recording.

Streszczenie treści zawartej na stronie nr. 8

Basic Operations Playing an MD 23 4 Turn on the mixer and adjust the fader or level control of the 1 corresponding channel. Press U. 2 Insert an MD. 3 With the label side up With the arrow pointing this way Press á. z You can locate and play back a track while the recorder is 4 The recorder starts playing. stopped 1 Turn AMS (or press = or + on the remote) until the number of the Do the following: To desired track appears. 2 Press AMS or á. Stop playing Press p. Pause playing Press P. Press the

Streszczenie treści zawartej na stronie nr. 9

Basic Operations Recording on MDs Recording on MDs If “Cannot Copy” appears in the display The recorder uses the SCMS (Serial Copy Management Notes on Recording System). MDs recorded through digital input connector cannot be If “Protected” appears in the display copied onto other MDs or DAT tapes through the digital The MD is record-protected. Close the slot to record on the output connector (see page 38). disc (see “To protect an MD against accidental erasure” on page 7). When recording digita

Streszczenie treści zawartej na stronie nr. 10

Recording on MDs Monitoring the input signal (Input Monitor) If “Smart Space” appears in the display (Smart Space) Before starting recording, you can monitor the selected input signal through the recorder’s output connectors. When there has been an extended silence of up to 30 seconds in length, and the signal is input again, the 1 Press ¤EJECT to remove the MD. silence is replaced by a blank of about 3 seconds and the recorder continues recording. 2 Set INPUT according to the input signal you w

Streszczenie treści zawartej na stronie nr. 11

Recording on MDs Recording Over Existing Tracks Adjusting the Recording Level Follow the procedure below to record over existing When recording with INPUT set to ANALOG and the material just as you would on an analog cassette tape. signal input through LINE (ANALOG) IN jacks, use REC LEVEL to adjust the recording level before starting recording. 6 You cannot adjust the recording level during digital ­ AMS ± recording. REC LEVEL á P p = + r =/+ 0 ) 1 Carry out Steps 1 to 6 in “Recording on an MD”

Streszczenie treści zawartej na stronie nr. 12

Recording on MDs To Cancel Auto Track Marking 1 While the recorder is stopped, press EDIT/NO twice to Marking Track Numbers While display “Set up Menu”. Recording (Track Marking) 2 Turn AMS until “Level Sync” appears in the display, then press AMS. You can mark track numbers either manually or 3 Turn AMS until “Level Sync OFF” appears in the display, then press AMS. automatically. By marking track numbers at specific 4 Press EDIT/NO. points, you can quickly locate the points later using the AMS

Streszczenie treści zawartej na stronie nr. 13

Recording on MDs 6 Synchro-Recording With Audio ­ AMS ± Equipment of Your Choice Z By using the MUSIC SYNC button on the remote, you can automatically start a Synchronized recording with the signal input from the program source through the input jacks. á P p The method of marking track numbers differs, = + r depending on the program source being recorded and 0 ) T.REC how the recorder is connected to the program source. (See “Notes on Recording” on page 9.) 1 Carry out Steps 1 to 6 in “Recording

Streszczenie treści zawartej na stronie nr. 14

Recording on MDs 6 Press START. The recorder starts recording and the CD player Synchro-Recording With a Sony starts playback. CD Player Z The track number and elapsed recording time of the track appear in the display. By connecting your recorder to a Sony CD player, you If the CD player does not start playing can easily dub CDs onto MDs using the CD synchro Some CD player models may not respond when you buttons on the remote. If your recorder is connected to press START on the remote of the r

Streszczenie treści zawartej na stronie nr. 15

Recording on MDs Recording Using a Timer A commercially available timer connected to the recorder allows it to start or stop recording at a preappointed time. For additional information, refer to the information manual for the timer. 1 Turn on the timer. 2 Perform steps 1 to 5 in “Recording on an MD” (see page 6). 3 Choose “Timer REC” from the Setup Menu. 1. While the recorder is stopped, press EDIT/NO twice to display “Setup Menu.” 2. Turn AMS until “Timer” appears in the display, then press AM

Streszczenie treści zawartej na stronie nr. 16

Playing MDs Playing MDs Disc name Using the Display Z You can use the display to check disc and track information such as the total track number, total playing time of the tracks, remaining recordable time Total number of tracks Total disc playing time of the disc and disc name. 6 DISPLAY SCROLL To label a recordable disc and its tracks, see “Labeling Recordings” on page 26. Note When you insert a new MD or turn off the recorder and turn á P p it on again, the last item displayed will reappear.

Streszczenie treści zawartej na stronie nr. 17

Playing MDs Playing MDs z You can check the track name at any time while z When you directly locate a track with a number over playing an MD Z 25 Z You must press >25 first, before entering the Press SCROLL on the remote. corresponding digits. Since the display shows up to 12 characters at a time, Press >25 once if it is a 2-digit track number, and twice press SCROLL again to see the rest of the track title if if it is a 3-digit track number. the title has 13 characters or more. To enter “0,” pr

Streszczenie treści zawartej na stronie nr. 18

Playing MDs Locating a Particular Point in a Playing Tracks Repeatedly Z Track You can play tracks repeatedly in any play mode. You can also use 0 and ) to locate a particular point in a track during playback or playback pause. 6 0/) REPEAT A÷B á P p = + r To locate a point Press 0 ) ) While monitoring the ) (forward) or 0 (backward) sound and keep pressing until you find the desired point. Quickly by observing ) or 0 and hold until you the display during find the desired point. There is playba

Streszczenie treści zawartej na stronie nr. 19

Playing MDs Playing MDs Repeating a specific portion (A-B Repeat) Playing Tracks in Random Z You can play a specific portion of a track repeatedly. Order (Shuffle Play) Z This might be useful when you want to memorize lyrics. You can have the recorder “shuffle” tracks and play Note that you can only repeat a portion within the them in random order. boundaries of a single track. 6 1 While playing a disc, press A÷B at the starting CONTINUE point (point A) of the portion to be played SHUFFLE repeat

Streszczenie treści zawartej na stronie nr. 20

Playing MDs z You can program the same track repeatedly Press the appropriate number button as many times as Creating Your Own Program you want to repeat. (Program Play) Z z The program remains even after Program Play ends You can specify the playback order of the tracks on an When you press á, you can play the same program MD and create your own programs containing up to 25 again. tracks. Notes • The program created by the Program Play Function is lost 6 when you press ¤EJECT to take out the MD


Podobne instrukcje
# Instrukcja obsługi Kategoria Pobierz
1 Sony Cassette-Corder TCM-20DV Instrukcja obsługi Magnetofon 63
2 Sony 30TW Instrukcja obsługi Magnetofon 3
3 Sony cCFD-S20CP Instrukcja obsługi Magnetofon 5
4 Sony CFD-E55L Instrukcja obsługi Magnetofon 95
5 Sony CFD-646 Instrukcja obsługi Magnetofon 18
6 Sony 5500 Instrukcja obsługi Magnetofon 3
7 Sony 453V Instrukcja obsługi Magnetofon 7
8 Sony Cassette-Corder TCM-22DV Instrukcja obsługi Magnetofon 10
9 Sony CFD-Z501 Instrukcja obsługi Magnetofon 0
10 Sony CFM-20 Instrukcja obsługi Magnetofon 16
11 Sony CFD-S100 Instrukcja obsługi Magnetofon 64
12 Sony CFD-C646 Instrukcja obsługi Magnetofon 13
13 Sony CC-222 Instrukcja obsługi Magnetofon 0
14 Sony CFD-S350 Instrukcja obsługi Magnetofon 15
15 Sony CFS-717S Instrukcja obsługi Magnetofon 168
16 Dynabrade 400 RPM Instrukcja obsługi Magnetofon 0
17 Sony Cassette-Corder TCM-20DV Instrukcja obsługi Magnetofon 63
18 Sony 30TW Instrukcja obsługi Magnetofon 3
19 Sony cCFD-S20CP Instrukcja obsługi Magnetofon 5
20 Sony CFD-E55L Instrukcja obsługi Magnetofon 95