Instrukcja obsługi Kenyon B83213

Streszczenie treści zawartej na stronie nr. 1

:: rangehoods.com Call 1-800-667-8721 anywhere in the US and Canada - www.rangehoods.com
SUMMIT VENTILATION HOOD
OWNER’S GUIDE
READ AND SAVE THESE INSTRUCTIONS
Models B83211, B83212, B83213
B83221, B83222, B83223

Streszczenie treści zawartej na stronie nr. 2

Important Safety Instructions Take care when using cleaning agents or detergents. Select products suitable for use in household cooking area only. Certain locales require make-up air calculations for total airflow. Consult your local codes and an HVAC professional before installing or using this hood. CAUTION - To reduce risk of fire and to properly exhaust air, be sure to duct air outside – Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. CA

Streszczenie treści zawartej na stronie nr. 3

Installation FOR RESIDENTIAL USE ONLY NOT TO BE INSTALLED OVER GAS GRILLS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: Save these Instructions for the Local Electrical Inspector’s use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. SAFETY WARNING: Turn off power circuit at the service entrance and lock out panel, before wiring this appliance. Req

Streszczenie treści zawartej na stronie nr. 4

Installation Preparation of mounting surface (Drywall) 1. Select a mounting height comfortable for the user and mark on wall behind cooktop. Tools required for installation Screw driver 2. Mark center line of cooktop and draw vertical line from bottom of hood (flat head, philips n°2 and torx 10) to the ceiling. Allen spanner 4mm 3. Tape template, matching center-line and hood bottom as shown in 13 Electric drill with twist bit / ” Figure 2. 32 4. Mark centers of the 6 fastener locations through

Streszczenie treści zawartej na stronie nr. 5

Installation Appliance Installation: 11. Install transition on top of hood if removed for shipping. Mark onto exterior of transition the ‘V’ location of the damper within. Figure 4. Note: Duct screws can ONLY GO BELOW this line. For Filtering Function ONLY: Install filtering duct on top of hood instead of transition. Filtering duct is available only by ordering the conversion kit for filtering function. Kenyon Part # B80011 1" 12. Hang hood on 2 mounting hooks through the rectangular cutouts

Streszczenie treści zawartej na stronie nr. 6

Installation Wiring to Power Supply WARNING! ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE CUT OR REMOVED. Warning: Turn off power circuit at the service panel before wiring this unit. 120 VAC, 15 or 20 Am