Streszczenie treści zawartej na stronie nr. 1
OWNERS MANUAL FOR
CRAFTSMAN
PERMANENTLY LUBRICATED
Model No.
TANK MOUNTED
919.727121
AIR COMPRESSOR
Record in the spaces provided.
(1) The Model Number can be found on the
maintenance label on top of the motor
shroud or on the bar code label on the
� SAFETY GUIDELINES
rear of air tank.
ASSEMBLY
(2) The Date Code Number can be found on
the bar code label on the rear of the air
OPERATION
tank.
(3) The Serial Number can be found on the
MAINTENANCE
bar code label on the rear of the tank.
TRO
Streszczenie treści zawartej na stronie nr. 2
TABLE OF CONTENTS Page Page WARRANTY .............................................................2 Extension Cords ...................................................8 SAFETY GUIDELINES-DEFINITIONS ......................2 Grounding Instructions .........................................9 SAFETY GUIDELINES .......................................... 3-5 Break-in Procedure...............................................9 GENERAL INFORMATION .......................................6 OPERATING PROCEDUR
Streszczenie treści zawartej na stronie nr. 3
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAM- AGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. HAZARD RISK OF EXPLOSION OR FIRE WHAT CAN HAPPEN HOW TO PREVENT IT IT IS NORMAL FOR ELECTRICAL CONTACTS WITHIN THE ALWAYS OPERATE THE COMPRESSOR IN A WELL VENTI- MOTOR AND PRESSURE SWITCH TO SPARK. LATED AREA FREE OF COMBUSTIBLE MATERIALS, GASO- LINE
Streszczenie treści zawartej na stronie nr. 4
HAZARD RISK FROM FLYING OBJECTS WHAT CAN HAPPEN HOW TO PREVENT IT THE COMPRESSED AIR STREAM CAN CAUSE SOFT TISSUE ALWAYS WEAR ANSI Z87.1 APPROVED SAFETY GLASSES WITH DAMAGE TO EXPOSED SKIN AND CAN PROPEL DIRT, CHIPS, SIDE SHIELDS WHEN USING THE COMPRESSOR. LOOSE PARTICLES AND SMALL OBJECTS AT HIGH SPEED, NEVER POINT ANY NOZZLE OR SPRAYER TOWARD ANY PART RESULTING IN PROPERTY DAMAGE OR PERSONAL INJURY. OF THE BODY OR AT OTHER PEOPLE OR ANIMALS. ALWAYS TURN THE COMPRESSOR OFF AND BLEED PRESSURE FR
Streszczenie treści zawartej na stronie nr. 5
HAZARD RISK FROM MOVING PARTS WHAT CAN HAPPEN HOW TO PREVENT IT MOVING PARTS SUCH AS THE PULLEY, FLYWHEEL AND BELT NEVER OPERATE THE COMPRESSOR WITH GUARDS OR CAN CAUSE SERIOUS INJURY IF THEY COME INTO CONTACT COVERS WHICH ARE DAMAGED OR REMOVED. WITH YOU OR YOUR CLOTHING. ATTEMPTING TO OPERATE COMPRESSOR WITH DAMAGED ANY REPAIRS REQUIRED ON THIS PRODUCT SHOULD BE OR MISSING PARTS OR ATTEMPTING TO REPAIR COMPRES- PERFORMED BY AUTHORIZED SERVICE CENTER PERSONNE
Streszczenie treści zawartej na stronie nr. 6
GENERAL INFORMATION Your air compressor can be used for operating paint You have purchased an air compressor unit consist- spray guns, air tools, blow guns, nailers/staplers, air ing of a one cylinder, single-stage air compressor brushes, and inflator kits. An air pressure regulator is pump and air tank. Included are wheels, regulator, required for most of the applications. and gauges. An in-line air filter which removes moisture and dirt This air compressor requires no oil. Now you can from co
Streszczenie treści zawartej na stronie nr. 7
DESCRIPTION OF OPERATION Air Compressor Pump: To compress air, the piston Safety Valve: If the pressure switch does not shut moves up and down in the cylinder. On the down- off the air compressor at its cut-out pressure setting, stroke, air is drawn in through the air intake valves. the safety valve will protect the tank against high The exhaust valves remain closed. On the upstroke of pressure by “popping out” at its factory set pressure the piston, air is compressed. The intake valves clo
Streszczenie treści zawartej na stronie nr. 8
ASSEMBLY Installing Wheels, Handles, Molded Foot Bumpers It will be necessary to brace or support one side of the outfit when installing the wheels because the compressor will have a ten- THE WHEELS AND HANDLE DO NOT dency to tip over. PROVIDE ADEQUATE CLEARANCE, 2. Install one shoulder bolt and one nut for each STABILITY OR SUPPORT FOR PULLING wheel. Tighten securely. The outfit will sit level if the THE UNIT UP AND DOWN STAIRS OR wheels are properly installed. STEPS. THE UNIT MUST BE LIFTED,
Streszczenie treści zawartej na stronie nr. 9
If repairing cord or plug, the grounding wire must be GROUNDING INSTRUCTIONS kept separate from the current-carrying wires. Never connect the grounding wire to a flat blade plug terminal. The grounding wire has insulation with an RISK OR ELECTRICAL SHOCK. In the event outer surface that is green - with or without yellow of a short circuit, grounding reduces the risk stripes. of shock by providing an escape wire for the If these grounding instructions are not completely electric current. This ai
Streszczenie treści zawartej na stronie nr. 10
OPERATING PROCEDURES 1. Before attaching air hose or accessories, make 6. Always operate the air compressor in well-venti- sure the OFF/AUTO lever is set to “OFF” and the lated areas; free of gasoline or other solvent air regulator is closed. vapors. 2. Attach hose and accessories. Do not operate the compressor near the spray area. When you are finished: TOO MUCH AIR PRESSURE CREATES A 7. Set the “OFF/AUTO” lever to “OFF”. HAZARDOUS RISK OF BURSTING. CARE- 8. Turn the regulator counterclockwise
Streszczenie treści zawartej na stronie nr. 11
MAINTENANCE UNIT CYCLES AUTOMATICALLY WHEN POWER IS ON. WHEN DOING MAINTENANCE, YOU MAY BE EXPOSED TO VOLTAGE SOURCES, COMPRESSED AIR OR MOVING PARTS. PERSONAL INJURIES CAN OCCUR. BEFORE PERFORMING ANY MAINTENANCE OR REPAIR, UNPLUG THE COMPRESSOR AND BLEED OFF ALL AIR PRESSURE. ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED MUST BE DONE BY QUALIFIED SERVICE PERSONNEL. Safety Valve - Inspection Check Valve - Replacement If the safety valve does not work properly, Before servicing: over-pre
Streszczenie treści zawartej na stronie nr. 12
TROUBLESHOOTING GUIDE PERFORMING REPAIRS MAY EXPOSE VOLTAGE SOURCES, MOVING PARTS OR COMPRESSED AIR SOURCES. PERSONAL INJURY MAY OCCUR. PRIOR TO ATTEMPTING ANY REPAIRS, UN- PLUG THE COMPRESSOR AND BLEED OFF TANK AIR PRESSURE. PROBLEM CAUSE CORRECTION Pressure switch does not shut off Move the pressure switch lever to the “OFF” Excessive tank pressure - motor when compressor reaches position. If the outfit doesn’t shut off, and the safety valve pops off. “cut-out” pressure. electrical contacts
Streszczenie treści zawartej na stronie nr. 13
TROUBLESHOOTING GUIDE (Continued) CORRECTION PROBLEM CAUSE Air leak from safety valve. Operate safety valve manually by pulling on ring. If Possible defect in safety valve. valve still leaks, it should be replaced. Defective check valve. Have checked at local Sears Service Center. Knocking Noise Compressor is not supplying Prolonged excessive use of air. Decrease amount of air usage. enough air to operate accessories. Check the accessory air requirement. If it is higher Compressor is not large
Streszczenie treści zawartej na stronie nr. 14
OWNERS MANUAL FOR PERMANENTLY LUBRICATED TANK MOUNTED AIR COMPRESSOR Model No. The model number of your Sears Air Compressor can be found 919.727121 on the maintenance label on the top of the shroud or on the bar code label on the rear of the air tank. SERVICE SERVICE AND REPAIR PARTS CALL 1-800-665-4455* Keep this number handy should you require a service call or need to order repair parts. If ordering parts make sure you have the name, make and model no. of the merchandise and the name and num
Streszczenie treści zawartej na stronie nr. 15
GUIDE DE L’UTILISATEUR POUR LE COMPRESSEUR D’AIR À LUBRIFICATION PERMANENTE MONTÉ SUR RÉSERVOIR DE CRAFTSMAN o Modèle n . 919.727121 Inscrivez dans l’espace réservé à cette fin 1) Le numéro du modèle se trouve sur l’étiquette d’entretien qui est sur le dessus du carter du moteur ou sur l’étiquette de caractères à bâtonnets située à l’arrière du réservoir d’air. 2) Le numéro de code daté se trouve sur l’étiquette de caractères à bâtonnets située à l’arrière du MESURES DE SÉCURITÉ réservoir d’ai
Streszczenie treści zawartej na stronie nr. 16
TABLE DES MATIÈRES GARANTIE ....................................................................... 2 Tension et protection du circuit ................................... 8 MESURES DE SÉCURITÉ - DÉFINITIONS ................... 2 Rallonges ...................................................................... 8 MESURES DE SÉCURITÉ .......................................... 3-5 Directives de mise à la terre ......................................... 9 RENSEIGNEMENTS GÉNÉRAUX .......................
Streszczenie treści zawartej na stronie nr. 17
MESURES DE SÉCURITÉ IMPORTANTES CONSERVER CES DIRECTIVES AVERTISSEMENT UN EMPLOI OU UN ENTRETIEN NON APPROPRIÉS DE CE PRODUIT PEUT CAUSER DES BLESSURES GRAVES ET DES DOMMAGES À LA PROPRIÉTÉ. LIRE ATTENTIVEMENT TOUS LES AVERTISSEMENTS ET LES DIRECTIVES D’UTILISATION AVANT D’UTILISER CET APPAREIL. DANGER RISQUE D’EXPLOSION OU D’INCENDIE RISQUE PRÉVENTION LES ÉTINCELLES QUI PROVIENNENT DES CONTACTS ÉLECTRIQUES DU TOUJOURS UTILISER LE COMPRESSEUR DANS UN ENDROIT BIEN AÉRÉ, MOTEUR ET DU MANOSTAT SONT
Streszczenie treści zawartej na stronie nr. 18
DANGER RISQUE DE PROJECTION D’OBJETS RISQUE PRÉVENTION LE JET D’AIR COMPRIMÉ PEUT CAUSER DES LÉSIONS AUX TISSUS DE LA PORTER TOUJOURS DES LUNETTES DE PROTECTION HOMOLOGUÉES PEAU EXPOSÉE ET PEUT PROJETER DE LA SALETÉ, DES COPEAUX, DES ANSI Z87.1 AVEC DES ÉCRANS LATÉRAUX LORS DE L’UTILISATION DU PARTICULES LIBRES ET DE PETITS OBJETS À HAUTE VITESSE, CE QUI COMPRESSEUR. RISQUE DE CAUSER DES DOMMAGES À LA PROPRIÉTÉ OU DES BLESSURES. NE JAMAIS DIRIGER LA BUSE OU LE PULVÉRISATEUR VERS SOI, VERS D’AUTR
Streszczenie treści zawartej na stronie nr. 19
DANGER RISQUE RELIÉ AUX PIÈCES MOBILES RISQUE PRÉVENTION LES PIÈCES MOBILES TELLES QUE LA POULIE, LE VOLANT-MOTEUR ET LA NE JAMAIS FAIRE FONCTIONNER LE COMPRESSEUR SANS LES COURROIE PEUVENT ENTRAÎNER DES BLESSURES GRAVES SI ELLES GARDES OU LES COUVERCLES OU LORSQUE CEUX-CI SONT ENTRENT EN CONTACT AVEC UNE PARTIE DU CORPS OU DES ENDOMMAGÉS. VÊTEMENTS. EN TENTANT DE FAIRE FONCTIONNER LE COMPRESSEUR AVEC DES TOUTE RÉPARATION REQUISE SUR CET APPAREIL DEVRAIT ÊTRE PIÈCES MANQUANTES OU ENDOMMAGÉES, OU
Streszczenie treści zawartej na stronie nr. 20
RENSEIGNEMENTS GÉNÉRAUX Vous avez fait l’achat d’un compresseur d’air de 1 cylindre Votre compresseur d’air peut être utilisé avec des pistolets à muni d’une pompe de compresseur d’air à phase unique et peindre, des outils pneumatiques, des pistolets à calfeutrer, d’un réservoir d’air. Cet appareil comprend aussi des des cloueuses/agrafeuses, des pinceaux vaporisateurs, ainsi roues, un régulateur et des manomètres. que des trousses pour le gonflage. Un régulateur de pression d’air est requis pou
