Instrukcja obsługi Beverage-Air

Streszczenie treści zawartej na stronie nr. 1

Beverage Air
IMPORTANT
INFORMATION
FOR
H SERIES
HR/HF/HPR/HPF
This cooler has passed the
QUALITY CONTROL INSPECTION
And meets the high standards at Beverage-Air
This inspection includes complete refrigeration
System, cabinet construction & finish.


IMPORTANT
PLEASE RETAIN FOR YOUR RECORDS

SALES OFFICE: P.O. BOX 5932 SPARTANBURG, S.C. 29304-5932
PHONE: (864) 582-8111 TOLL FREE 1-800-845-9800
TECHNICAL SERVICE: 1-800-684-1199, PARTS ORDER FAX: 1-800-262-9381
OFFICE: SPAR

Streszczenie treści zawartej na stronie nr. 2

BEVERAGE-AIR® INSTALLATION AND OPERATING INSTRUCTIONS 1. INSTALLATION a. Receiving Inspection: Upon receipt, check all packages for accessories or optional components, including legs, caster, shelves or pan slides. Keys for door locks are attached to one of the doors. (When lock is installed.) b. Legs & Casters: Each cabinet is provided with four threaded legs or casters shipped separately. Legs and casters screw directly into the weld nut provided in each corner of the base.

Streszczenie treści zawartej na stronie nr. 3

e. Temperature Control, Defrost System and Condensate Disposal: All H series are equipped with an electronic control. This control is located on right hand side of the cabinet above the door. The control has four buttons as shown in the picture below. Freezers are shipped from the factory with control set at -3 °F and refrigerators are shipped with control set 34 °F. To change the temp. control setting, press and hold the Set button for 3 seconds. The set value will be displayed and °F w

Streszczenie treści zawartej na stronie nr. 4

Figure 1.

Streszczenie treści zawartej na stronie nr. 5

Bi-pin Florescent Lamp Installation / Verification (Only Glass Door Models) Prior to applying power to the unit, verify that all lamps are properly installed and fully engaged in the lamp holders. Proper lamp engagement is achieved by rotating the lamp 90 degree from its insertion position until it snaps or clicks into place. Visual verification can be made on units without safety shields by using the identification mark on the end of the bulb. Properly installed bulbs will have the

Streszczenie treści zawartej na stronie nr. 6

SERVICE RECORD