Streszczenie treści zawartej na stronie nr. 1
9101429501
»
CD-302
Dual CD Player
BRAKE BRAKE
OWNER’S MANUAL
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
Ü
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure
ÿ
that may be of sufficient magnitude to constitute a risk of electric shock to
Streszczenie treści zawartej na stronie nr. 2
Important Safety Precautions Note for U.K. Customers TO THE USER DO NOT cut off the mains plug from this This equipment has been tested and found to comply equipment. with the limits for a Class A digital device, pursuant to If the plug fitted is not suitable for the power points in Part 15 of the FCC Rules. These limits are designed your home or the cable is too short to reach a power to provide reasonable protection against harmful interference when the equipment is opera
Streszczenie treści zawartej na stronie nr. 3
IMPORTANT SAFETY INSTRUCTIONS CAUTION: "Note to CATV system installer: …Read all of these Instructions. This reminder is provided to call the CATV system installer’s attention to …Save these Instructions for later use. Section 820-40 of the NEC which provides guidelines for proper grounding …Follow all Warnings and Instructions marked on the audio and, in particular, specifies that the cable ground shall be connected to t
Streszczenie treści zawartej na stronie nr. 4
SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisi- ble laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown 1. C
Streszczenie treści zawartej na stronie nr. 5
TASCAM CD-302 — Table of Contents 2.5 Display .............................................15 1 - Before you start c TRACK indicator ............................................ 15 1.1 Main features ......................................7 d Bank indicators .............................................. 15 1.2 Environmental conditions .................7 e Loop mode indicator ................................
Streszczenie treści zawartej na stronie nr. 6
TASCAM CD-302 — Table of Contents 4.3.6 Setting the sampled data playback 4.11 Voice Reduce function .................... 26 tempo .........................................................21 4.12 Programmed playback ....................26 4.3.7 Setting the sampled data playback key .22 4.12.1 Setting the program steps .......................26 4.3.8 Looped playback of sampled data ..........22 4.12.2 Adding tracks to the middle of 4.3.9 Clearing the sampled data .......................22 a prog
Streszczenie treści zawartej na stronie nr. 7
1 - Before you start • Auto ready function to cue up following tracks 1.1 Main features • End of Message function (10, 15, 20, 30, 60, or 90 seconds). • Two high-quality precision CD decks in a single • Timer play for deck 1 followed by deck 2. rack-mountable unit. • Relay play allows consecutive playback using both • RCA unbalanced outputs for each deck decks (as one deck stops, the other can be set to • Dedicated per-deck remote control units start automatically). (detachable and
Streszczenie treści zawartej na stronie nr. 8
1 • Before you start—Backup memory • Wipe in a straight motion from the inside to the 1.2.1 Beware of condensation outside of the disc. Small dust particles and light If the player (or a compact disc) is moved from a stains will have absolutely no effect on reproduc- cold to a warm place, or used after a sudden tempera- tion quality. ture change, there is a danger of condensation; vapor • Never use such chemicals as record sprays, anti- in the air could condense on the int
Streszczenie treści zawartej na stronie nr. 9
1 • Before you start—Preset functions 1 Press the PRESET key I. 1.6 Preset functions 2 Select the name and number of the preset func- tion you want to set, with the JOG dial F or 2, 4 the number keys G. 3 Press the ENTER key L. 1 4 Set the function value using the JOG dial F. 5 Press the ENTER key L to confirm the entry. 3, 5 The way in which the parameters of the preset func- tions listed in 1.7, “Preset functions” are se
Streszczenie treści zawartej na stronie nr. 10
1 • Before you start—Displayed characters No. Display Description and explanation Default setting 18 I/PLAY I_PLAY Incremental Play (4.18, “Incremental Play”) OFF R_PLAY Relay Play (4.19, “Relay Play”) OFF 19 R/PLAY 20 DIRECT DIRECT Direct mode (4.20, “Direct mode”) OFF 21 CLOSE CLOSE Disc Tray auto close (4.21, “Disc Tray Auto Close”) ON SLEEP Sleep mode (4.22, “Sleep”) ON 22 SLEEP 23 F/PRE F_PRE Factory settings (4.24, “Factory Preset”) 24 ALL/CL ALL_CL Clear all mem
Streszczenie treści zawartej na stronie nr. 11
2 - Front and rear panels 33 12 4 5 6 4 5 6 TASCAM CD-302 11
Streszczenie treści zawartej na stronie nr. 12
2 • Front and rear panels—Main unit (front panel) NOTE 2.1 Main unit (front panel) This key cannot be used when the Direct mode (see 4.20, “Direct mode”) is off and a disc is being played Since you perform almost all control functions of the back. CD-302 from the remote control unit, the front panel 8 TIME key only contains the following features: Selects the time display type: ELAPSED, REMAIN or 1 POWER switch and indicator A-B loop duration (in A-B loop play mode). Turns the p
Streszczenie treści zawartej na stronie nr. 13
2 • Front and rear panels—Remote control unit (front panel) D CUE key M BPM counter If a cue point has been stored, the unit will play when Shows the tempo (in bpm—beats per minute—from the CUE key is pressed, and enter pause mode when 81 to 161) of the current track, or of the tapped this key is released. tempo input with the TAP key N (see 4.5, “BPM”). E PLAY/PAUSE key N TAP key Changes between playback and pause mode. Set the tempo in bpm manually by tapping the TAP key. The key lights st
Streszczenie treści zawartej na stronie nr. 14
2 • Front and rear panels—Remote control unit (rear) S A and B keys X + and – keys Use the A and B keys to set, edit and recall the start Changes the key. and end points of the loop, respectively. These keys have no effect in Original Key mode. When you have set a loop (start and end points have Y KEY ORIGINAL/RESET key been set), the A and B keys will light. Use to choose between the Original Key mode and T SAMPLE key and the Pitch Control mode (where the tempo or the This key lights when s
Streszczenie treści zawartej na stronie nr. 15
2 • Front and rear panels—Display 2.5 Display ,. !@# $% & )Q / ^ *( E W Each unit is fitted with a display, providing the fol- When remaining time mode is selected, indicators go lowing information: out from left to right. c TRACK indicator If an EOM (End of Message) time has been set, the bottom bar and the remaining segments will blink Shows the current track. when the EOM time is reached. d Bank indicators l TEMPO indicator Show the current memory bank. Displays the current tempo setting (
Streszczenie treści zawartej na stronie nr. 16
3 - Basic operations 3.2.1 Cross-play 3.1 Playback operations The term “cross-playing” refers to the stopping of one deck and automatic starting of the other deck. 3.1.1 Playback To start cross-playing: Load a disc in the player, and press the PLAY/PAUSE 1 With one deck playing, and the other stopped, key. press and hold down the ENTER key of the The PLAY/PAUSE key lights in playback mode. deck that is stopped. 3.1.2 Pause 2 Press the PLAY key of the stopped deck. If you press the PLAY/PAUSE
Streszczenie treści zawartej na stronie nr. 17
3 • Basic operations—Loop play 2 Select 02 CUE/P (CUE_P) using the dial or 2 Select 03 JOG (JOG) using the dial or numeric numeric keys. keys. 3 Press the ENTER key. 3 Press the ENTER key. 4 Select the cue point mode. 4 Select the value (frames per rotation). 5 Press the ENTER key. 5 Press the ENTER key. If you select the PLAY key mode (PLY (PLY) is cho- 3.3.4 Cueing using the SEARCH keys sen as the cue mode value), the last playback point is You can also cue to frame accuracy, using the capt
Streszczenie treści zawartej na stronie nr. 18
3 • Basic operations—Loop play and the LOOP key lights. If the A and B keys are not 3.4.2 A-B loop play mode lit, pressing the LOOP key will have no effect. The A-B loop mode allows seamless loop play between two points (A and B). The A and B points If the LOOP key is lit, and you press it again while should be in the same track. playing back between the loop points, looped play- back stops, but the unit continues to play past the end 1 Press the PRESET key. loop point. 2 Select 01 LOOP (LOO
Streszczenie treści zawartej na stronie nr. 19
3 • Basic operations—Loop play duration is shown for two seconds, and the display 6 Press the LOOP key. The LOOP key lights, and then returns to its previous state. the LOOP indicator in the display also lights. 3.4.8 SINGLE loop 3.4.9 ALL loop This plays back one track continuously, looping 1 Press the PRESET key. between the start and end of the track. 2 Select 01 LOOP (LOOP) using the dial or 1 Press the PRESET key. numeric keys. 2 Select 01 LOOP (LOOP) using the dial or 3 Press the ENTER
Streszczenie treści zawartej na stronie nr. 20
4 - Advanced Operations 2 Press the + and – keys to change the key. 4.1 Tempo (speed) control Display and change the key change either as a per- centage of the original, or in semitone steps. Follow the steps below to select either percentage or semi- tone key change control. Note that the KEY indicator m will show a total of the value shown in this way, together with any changes made using the slider (when percentage mode is selected). 4.2.1 Controlling the key change as a percentage 1 Pre
