Instrukcja obsługi Vision Fitness X6600HR

Streszczenie treści zawartej na stronie nr. 1

VISION FITNESS
Assembly
Guide
MODEL X6600HRC ELLIPTICAL TRAINER

Streszczenie treści zawartej na stronie nr. 2

Before you begin… To avoid possible damage to this Elliptical Trainer, please follow these assembly steps in the correct order. Before proceeding though, enter your new Elliptical Trainer’s serial number here: Refer to this number when calling for service, and also enter this serial number on your Warranty Card and in your own records. Be sure to read your Owner’s Guide before using your new Elliptical Trainer. If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12

Streszczenie treści zawartej na stronie nr. 3

TOOLS & HARDWARE INCLUDED MM MM 5 Allen Wrench 4 Allen Wrench MM 5 L-Shaped Wrench MM Screwdriver 13 Wrench BLUE BAG MM MM 20 L x 8 D Bolt Quantity: 6 ORANGE BAG MM MM 55 L x 8 D Bolt NyLock Nut Quantity: 2 Quantity: 2

Streszczenie treści zawartej na stronie nr. 4

STEP 1 ORANGE BAG STEP 1 • Slide the rubber cover onto the console mast. • Unfold the console cable and attach it to the string located inside the console mast. Guide the wire up through the mast while simultaneously sliding the console mast onto the frame bracket. • Bolt the mast to the frame using the two bolts and two nuts; make sure these are tight! • Slide the rubber cover down over the bolt heads. STEP 2 STEP 2 RUBBER BOOT • Install the rubber boot over the top of the lower right handleba

Streszczenie treści zawartej na stronie nr. 5

STEP 4 STEP 4 BLUE BAG • Mount the upper right handlebar to the frame and lower portion of handlebar using two of the bolts in the bag. STEP 5 RUBBER BOOT STEP 5 • Install the rubber boot over the top of the lower left handlebar and slide to the bottom corner. STEP 6 STEP 6 BLUE BAG • Mount the lower left handlebar to the frame tube using one of the bolts in the bag. 5

Streszczenie treści zawartej na stronie nr. 6

STEP 7 STEP 7 BLUE BAG • Mount the upper left handlebar to the frame and lower portion of handlebar using two of the bolts in the bag. STEP 8 CONSOLE STEP 8 • Remove the four screws from the back of the console. Plug the wire connectors from inside the mast into the console. The cable connectors are slotted, so do not force the connection! • Mount the console to the mast using the four screws. Do not pinch the cable! 621-D East Lake Street • P.O. Box 280 • Lake Mills. WI 53551 toll free