Instrukcja obsługi Cadet EBKA-1-24

Streszczenie treści zawartej na stronie nr. 1

h
o
t
R
w
E
a
t
e
M
r
EBKA SoftHeat Thermostat
INSTALLATION INSTRUCTIONS
FOR EBHA SOFTHEAT BASEBOARD
Description
The EBKA-1-24 end cap thermostat kit is an accessory
for the EBHA Series of hydronic baseboard heaters.
This kit will provide thermostatic control of the heater
in place of a wall mounted thermostat.
Note: The EBKA-1-24 end cap thermostat can only
be installed on the left end of heater. It is designed
to control only one EBHA heater unit.
Tools Required: Phillips Screwdriver, Insulate

Streszczenie treści zawartej na stronie nr. 2

READ ALL Installation Instructions INSTRUCTIONS 1. Remove the heater front panel by lifting up and pulling out on the bottom edge of the front panel. AND SAFETY Set the front panel aside. INFORMATION. 2. Remove the junction box cover at the left end of the heater by removing the screw (See Figure 1). Keep screw for future use. 3. If you are installing the EBKA-1-24 thermostat kit as part of a new installation, proceed to Step 6. WARNING! 4. Disconnect the power supply wires and remove the wiring