Instrukcja obsługi Dimplex XLS6N

Streszczenie treści zawartej na stronie nr. 1

XLS6N AUTOMATIC XL6N MANUAL
ULTRA-SLIM STORAGE HEATER
MODELS: XLS6N - 6kWh
IPX2
XL6N - 6kWh
INSTALLATION AND OPERATING
INSTRUCTIONS
IMPORTANT
PLEASE READ THIS LEAFLET CAREFULLY AND
RETAIN FOR FURTHER USE. NOTE ALSO THE
INFORMATION GIVEN ON THE HEATER
The installation must be carried out by a competent electrician and should be in accordance with I.E.E.
Regulations.
A Double Pole Switch with a contact separation of at least 3mm on each pole must be provided in the
installation.
The heater is

Streszczenie treści zawartej na stronie nr. 2

INSTALLATION INSTRUCTIONS XLS6N MODEL ONLY - The Room Sensor is located at 3. the rear of the right hand side of the heater. Remove sensor PREPARATION from plate, carefully slide the sensor plate down from its transit position to its operational position. Refit sensor to plate. The heater will arrive separately from its storage bricks, 4 bricks will be required. 3. (2 Packs) Catalogue No. XT8300 Place the heater on its feet and in the desired position 4. against the wall. Ensure the heater is b

Streszczenie treści zawartej na stronie nr. 3

THE FOLLOWING MUST BE APPLIED WHEN 7. 12. FIXING THE HEATER TO THE WALL BRACKET i) If no skirting board is present secure the heater through the wall bracket slots closest to the wall. ii) If 100mm (4in.) skirting is present secure the heater through the outer slots. iii)If skirting taller than 150mm (6in.) is present this must be reduced to 150mm (6in.) over the entire width of the heater plus 25mm (1in.) at each end. Do not fully tighten these screws until the bricks are loaded into the heater

Streszczenie treści zawartej na stronie nr. 4

However, if the cutout has Thermal overload protection operated before following the This appliance is protected by a instructions below determine thermal safety cutout which will the cause of the cutout operating. If the heater has not operate to isolate the electricity obviously or inadvertently been supply if, for example, the heater misused - e.g. covered - it will surfaces or grille are obstructed be necessary to have the appliance fully checked by a to cause overheating. Dimplex Service A