Streszczenie treści zawartej na stronie nr. 1
North America’s Best
MODEL 800 NOVA FREESTANDING PELLET STOVE
INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS
CONGRATULATIONS—You are now the proud owner of one of the finest stoves in the world for your home—the QUADRA-
FIRE! Now before installing your stove and building your first fire, record the serial number on the warranty card. The serial
number is located on the safety label on the back wall of the hopper.
PLEASE READ ALL OF THE OWNERS MANUAL AND SAFETY NOTES
IMPORTANT SAFETY NOT
Streszczenie treści zawartej na stronie nr. 2
NOTES Page 2
Streszczenie treści zawartej na stronie nr. 3
TABLE OF CONTENTS Page Safety Label .............................................................................................................................................................. 4 Listing and Specifications ........................................................................................................................................ 5 Installation .....................................................................................................................
Streszczenie treści zawartej na stronie nr. 4
SAFETY LABEL (FOUND ON BACK WALL OF HOPPER) Page 4
Streszczenie treści zawartej na stronie nr. 5
LISTINGS AND SPECIFICATIONS QUADRA-FIRE 800 NOVA pellet stoves are safety tested and listed with Warnock Hersey International to ASTME 1509 and ULCS627. Also suitable for mobile home installation (see page 11 for details). HEAT INPUT*: 28,000 to 37,500 BTU per hour PARTICULATE EMISSIONS PER HOUR: 0.9 grams per hour DIMENSIONS: WIDTH-261/2" (673mm), DEPTH-24” (609mm), HEIGHT-291/2" (749mm) *BTU INPUT WILL V ARY , DEPENDING ON THE BRAND OF FUEL YOU USE IN YOUR STOVE. CONSULT YOUR QUADRA-FIRE DEALE
Streszczenie treści zawartej na stronie nr. 6
FLOOR PROTECTION MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS The floor protector must be noncombustible material, extending beneath heater and to the front, sides, and rear as indicated below. G = 2" (50mm) H = 6" (150mm) NOTE: In a corner installation, the floor protection must follow the above clearances. VENTING TERMINATION REQUIREMENTS 1. Do not terminate vent in any enclosed or semi-enclosed area such as a carport, garage, attic, crawl space, under a sun deck or porch, narrow walkway or cl
Streszczenie treści zawartej na stronie nr. 7
Page 7
Streszczenie treści zawartej na stronie nr. 8
Page 8
Streszczenie treści zawartej na stronie nr. 9
Page 9
Streszczenie treści zawartej na stronie nr. 10
TOP VENT FLUE ADAPTER INSTALLATION INSTRUCTIONS 3"-3" ADAPTER #811-0450 3"-6" COLLAR #812-2690 1) Put a layer of silicone on the 3" (76mm) exhaust outlet. 2) Slide the flue adapter onto the rear exhaust outlet. 3) Adjust the assembly to a vertical position. 4) Slide the outer shield up or down to mate evenly with the top of stove. 5) Tighten the adjusting screws (A) when the shield is in the proper position. 6) Drill two hole (B) with #26 drill bit (provided) into the back of the s
Streszczenie treści zawartej na stronie nr. 11
MOBILE HOME INSTALLATION OUTSIDE AIR KIT FOR 800 NOVA: PART #811-0420 (FLOOR) OR PART #811-0430 (REAR) 1 An outside air inlet must be provided for the combustion air and be unrestricted while the stove is in use. 2. The stove must be secured to the mobile home by bolting it to the floor (using lag bolts). 3. Do not install the stove in a sleeping room. 4. The structural integrity of the mobile home floor, walls and ceiling/roof must be maintained (i.e., do not cut through floor joists, wall stud
Streszczenie treści zawartej na stronie nr. 12
OPERATING INSTRUCTIONS 1. FUEL SIZE AND MATERIAL Fuel pellets are made from sawdust or wood byproducts. If the source material is hardwood, they will have a higher mineral content, creating a heavier ash. Minerals and other noncombustible materials, such as sand, will turn into glass when heated to the extreme temperatures our firepot reaches. This is what forms clinkers in the bottom of the firepot. Trees from different areas will vary in mineral content. That is why some fuels produce mo
Streszczenie treści zawartej na stronie nr. 13
Page 13
Streszczenie treści zawartej na stronie nr. 14
(N) COMBUSTION BLOWER (WHITE) Page 14
Streszczenie treści zawartej na stronie nr. 15
CLEANING AND MAINTENANCE NOTE: Unplug the stove before performing any cleaning or maintenance 1. FIREPOT A. It takes very little time to clean the firepot. We recommend that you clean the firepot at least once a week. However, if the fuel you are burning has a high dirt content, it will be necessary to clean the firepot more often. Dirty fuel will cause clinkers to form in the firepot. A clinker is formed when dirt or a nonburnable substance is heated to 2000° F (1093° C) and becomes glas
Streszczenie treści zawartej na stronie nr. 16
COMPONENT INFORMATION 1. POWER SUPPLY 6. JUNCTION BOX AND WIRING HARNESS A. Check the wall receptacle for 120 volt, 60 Hz (standard A. The junction box and the wiring harness are located current). Make sure the outlet is grounded and has on the left side of the stove. They are part of a the correct polarity. three piece set. The lower junction box contains both the capacitors, the thermocouple terminal block 2. FUSE and the computer card receptacle for the control box. The upper junctio
Streszczenie treści zawartej na stronie nr. 17
9. THERMOCOUPLE B. The blower is accessible by removing the left rear (facing A. The thermocouple is located on top of the firepot inside the the stove from the front) pedestal access door. You ceramic protection tube. Remove the ceramic tube and should inspect this blower at least once a year. If dust inspect the thermocouple for deterioration or breakage. buildup has accumulated, clean by simply brushing and B. Check the terminal block screws to see if they are tight and vacuuming dust
Streszczenie treści zawartej na stronie nr. 18
TROUBLESHOOTING NOTE: In order to identify the component location, refer to schematics on pages 13 and 14. CAUTION: UNPLUG STOVE BEFORE SERVICING 5. SLOW OR SMOKY START-UP 1. PLUG IN STOVE, NO RESPONSE A. Clean the firepot. Check the firepot gasket for a good A. Check the power supply for 120 volts AC. seal between the firepot and the firebox floor. B. Check the fuse in the junction box (7 amp, 120 volt fuse B. Check the combustion blower (make sure that it is AGC-7). starting when the t
Streszczenie treści zawartej na stronie nr. 19
8. THERMOSTAT WILL NOT START UNIT 13. LARGE FIRE, ASH BUILDUP AND DIRTY A. Check the power to the stove. GLASS 1. Unplug for 10 seconds and then plug in. The A. Clean the firepot. Check the firepot gasket for a good exhaust blower should come on. If it does, go seal between the firepot and firebox surfaces. to B. B. Visually check the cleanliness of the firebox, the heat B. The thermostat or the thermostat wiring maybe exchangers and venting system. faulty. C. Reduce the feed rate, i
Streszczenie treści zawartej na stronie nr. 20
North America’s Best lifetime warranty Aladdin Hearth Products, warrants their pellet heating appliances to the original purchaser for the lifetime of the appliance, to be free from defects in material and workmanship. This warranty gives you specific legal rights; you may have other rights which may vary from state to state. This limited Lifetime Warranty covers items such as but not limited to combustion chambers, heat exchanger systems, stainless steel firebox components, doors, gold p
