Instrukcja obsługi Casio DQR-300U

Streszczenie treści zawartej na stronie nr. 1

SNZ
ON
SNZ
OFF
ON
ALM OFF
ALM
MA0402-EB
Operation Guide DQR-300U
Main unit Sub-unit
1
F
SELECT °C/ °F
C
°C/ °F
SELECT
CASIO
RESET TEST
RESET TEST
D
E
HUMIDITY TEMP.
7
8 MAX/MIN MAX/MIN
SET CLEAR
9
5 3
UP( )
+ DOWN(—)
2
HUMIDITY TEMP.
MAX/MIN MAX/MIN
RE-SYNC WAVE
CLEAR 4
SET A
UP(+) DOWN(—)
SELECT °C/ °F
B 0
RE-SYNC WAVE
6
SELECT °C/ °F RESET
RESET
SELECT °C/ °F SELECT °C/ °F
RESET TEST RESET TEST
¡
™
¡ ™
1

Streszczenie treści zawartej na stronie nr. 2

Operation Guide DQR-300U • A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the GENERAL GUIDE clock. • Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the Main unit illustration. 1SNOOZE/LIGHT button • Press this button to illuminate the display for about four seconds. Alarm Off Alarm On • Pressing this button while the alarm is sounding stops the alarm. Current time 2Alarm Time S

Streszczenie treści zawartej na stronie nr. 3

Operation Guide DQR-300U TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS USING THE CLOCK • This clock is able to receive the time calibration signal transmitted from Any of the following procedures can be used to set current date and time. Rugby, England. Signal reception is possible within approximately Rugby • Auto receive of the time calibration signal 1,000 kilometers 1,000 km of the transmitter. • Manual receive of the time calibration signal • Even when the clock is within the reception rang

Streszczenie treści zawartej na stronie nr. 4

Operation Guide DQR-300U 2. While the screen you want is on the display, use the Alarm Time Set buttons (2) to change the digits that are BATTERY REPLACEMENT flashing. Low Battery Warning A indicator appears on the display to let you know when battery power is low. Replace the batteries as soon Press + to increase Press — to decrease UP( ) + DOWN(—) the flashing digits. the flashing digits. as possible. Note that the indicator appears on both the main unit and sub-unit when sub-unit battery p

Streszczenie treści zawartej na stronie nr. 5

Operation Guide DQR-300U Switching between Main Unit and Sub-unit Temperature Data HYGROMETER FUNCTIONS • Press the SELECT button (B) to toggle the display between the main unit (INDOOR) temperature and the sub- Both the main unit and the sub-unit are equipped with their own humidity sensors. Humidity data measured by the unit (OUTDOOR) temperature. sub-unit is sent by wireless transfer to the main unit. You can toggle the main unit display between the main unit Main unit temperature: INDOOR in

Streszczenie treści zawartej na stronie nr. 6

Operation Guide DQR-300U • To clear the high humidity and low humidity data memory, press the CLEAR button (9). USING THE WEATHER FORECAST FEATURE New data starts to be stored after memory is cleared. A built in pressure sensor makes it possible to forecast upcoming weather over the next 12 hours based on changes in barometric pressure. Note that these forecasts are not absolutely accurate, and are intended for general reference only. Weather Forecasts • Barometric pressure readings are taken ev