Instrukcja obsługi DVS 99000153

Streszczenie treści zawartej na stronie nr. 1

Blower, DVS Gas (Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance) Part # 99000153
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on the carrier's freight
receipt. Any damage claims as a result of shipping must be handled through the shipper. Travis Industries will provide assistance
in resolving shipping claims or replacing items not included in the package. Please report any missing items immediate

Streszczenie treści zawartej na stronie nr. 2

Blower, DVS Gas (Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance) Part # 99000153 2 Place the blower near the rear of the stove. Attach the wiring in grommets following the directions below. Remove one of the screws holding a the mounting bracket in place. Insert the screw through the eyelet on the green ground wire and replace. 1/4" Nutdriver Attach the black and white wires b labeled “Blower” to the blower (orientation does not matter). f Route the wires labeled “Valve on/of

Streszczenie treści zawartej na stronie nr. 3

Blower, DVS Gas (Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance) Part # 99000153 3 Slide the left side of the blower mounting bracket over the grommets on the left mounting bracket attached to the stove (see the illustration below). Then insert the stud plate through the right side grommets and through the right mounting bracket on the stove. Secure the stud plate with the included washers and nuts Make sure the bracket Left Mounting slides into the groove on Bracket (on stove)

Streszczenie treści zawartej na stronie nr. 4

Blower, DVS Gas (Berkshire, Tree of Life, Prairie, Cedar, 2001 Allegiance) Part # 99000153 5 Open the control cover following the directions below. Remove the button plug and install the rheostat. Loosen the two screws holding the control Attach the rheostat wires to the two NOTE: make sure the b box in place. This allows access to the quick connects inside the control fiberglass heat shield is in a back of the control box. box (orientation does not matter). place when re-attaching the