Instrukcja obsługi Hunter Fan

Streszczenie treści zawartej na stronie nr. 1

INSTALLATION INSTRUCTIONS FOR OUTDOOR USE
HUNTER CEILING FANS USING INSTALLER’S CHOICE MOUNTINGS
READ AND SAVE THESE INSTRUCTIONS
CAUTION:
Step 3: Installation
1. Read entire instructions carefully before beginning installation.
CAUTION: Your Hunter ceiling fan with accessories can weigh
2. To avoid possible shock, be certain electricity is shut off at
up to 35 lbs. The following precautions must be taken for safety
main panel before wiring.
and to ensure that your fan is securely mounted to the

Streszczenie treści zawartej na stronie nr. 2

SUPPORTING CEILING PLATE STRUCTURE HOOK NEOPRENE CEILING COVER PLATE GROUND CEILING WIRE PLATE RUBBER MOUNTING SPACERS CANOPY SCREWS (OPTIONAL) FIGURE 4 FIGURE 5A CAUTION: Use spacers only if fan is mounted to a flat ceiling. Hanging Fan Step 5: Fan Assembly CAUTION: Do not lift motor by wires. NOTE: Assembly Methods For A. Insert pipe nipple through canopy and feed wires from top Installer’s Choice Hanging System of motor through pipe nipple. Screw pipe nipple into fan until tight (at least 4

Streszczenie treści zawartej na stronie nr. 3

NOTE: Some Hunter fans require a special adaptor plate B. Position (2) slots in canopy directly under and in line with between the switch housing and the light kit. This plate is pro- (2) mounting screws in ceiling plate. Lift fan until ceiling plate vided with those fans which need it. It should be installed as mounting screws are seated in bottom of slots in canopy. Rotate shown in Figure 5C. If the switch housing on your fan is 3-1/4" fan counterclockwise until both mounting screws drop into

Streszczenie treści zawartej na stronie nr. 4

® Step 9: Operation of Fan A. Turn electrical service on at main panel. B. Switch operates in this sequence: “High,” “Medium,” “Low,” “Off.” Pull chain slowly to operate. Also, release the chain slowly so as to prevent chain from flying up into blades, possibly resulting in damage to blades, or pull chain. The break- PULL CHAIN away connector is designed to separate from the chain at a pre- SWITCH determined force. If this separation occurs, simply reinsert the BLADE MOUNTING SCREWS connector. I