Streszczenie treści zawartej na stronie nr. 1
IMPORTANT MANUAL Do Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
WARNING: ..................
Read the Owner's Manual and
follow all Warnings and Safety
96192001902
Instructions. Failure to do so
can result in serious injury.
SNOW THROWER
416804 09.20.07 SR
Always Wear Eye Protection During Operation Printed in U.S.A.
III I
Streszczenie treści zawartej na stronie nr. 2
IMPORTANT Safe Operation Practices for Walk-Behind Snow Throwers This snow thrower is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury. i i llnll, iHll null ,I,l,,,m,,,,H n,ll WARNING: Snow throwers have ex- Look for this symbol to point out im- posed rotating parts, which can cause portant safety precautions. It means severe injury from contact, or from ma- CAUTIONIH BECOMEALERT!H YOUR & terial thrown
Streszczenie treści zawartej na stronie nr. 3
6. When cleaning, repairingor inspectingthe snowthrower, 16. Never touch a hot engine or muffler. stop the engine and make certain the collector/impel- ler and all moving parts have stopped. Disconnect Clearing a Clogged Discharge Chute the spark plug wire and keep the wire away from the Hand contactwiththe rotatingimpellerinsidethe discharge plug to prevent someone from accidentally starting the chute isthe most common cause of injury associated with engine. snow throwers. Never use your hand t
Streszczenie treści zawartej na stronie nr. 4
(1) POWER (3) RETAINER SPRINGS (1) AUGER CONTROL ROD _-- (1) TRACTION DRIVE CONTROL ROD \_\ (1) DISCHARGE CHUTE I EXTRA SHEAR BOLTS AND NUTS 1 1 J I t O l I I I (2) SHEAR BOLTS 1/4-20 x 1-3f4 (2) SPACERS (2) LOCKNUTS I 114-20 I I I L f I I I J ROTATOR HEAD MOUNTING I t I I I I I ! I I SAFETY IGNITION KEY (1) WASHER 3/8 (1) LOCKNUT 318 I I I J I CHUTE DEFLECTOR REMOTE CONTROL I l I I (1) LOCKNUT (1) CARRIAGE (1) LOCKNUT (1)NYLON (1)SHOULDER I 1/4=20 WASHER 5/16-18 BOLT 5/16-18 x 5/8 BOLT 1_-20 (1
Streszczenie treści zawartej na stronie nr. 5
ASSEMBLY / PRE-OPERATION Read these instructions and this manual in its entirety before you attempt to assemble or operate your new SPEED snow thrower. Reading the entire manual will familiar- CONTROL ize you with the unit, which will assist you in assembly, operation and maintenance of the product. PLASTIC TIE "Your new snow thrower hasbeen assembled at the factory with the exception of those parts left unassembled for ship- UPPER ping purposes. All parts such as nuts, washers, bolts, etc., HAN
Streszczenie treści zawartej na stronie nr. 6
ASSEMBLY / PRE-OPERATION |lHmlllllnUl ,n,,,,,im,,ll,lll,ll inl nlnll n I n i I ii I I I INSTALL TRACTION DRIVE CONTROL ROD INSTALL AUGER CONTROL ROD (See Figs. 5 and 6) (See Figs. 3 and 4) The auger controlrod has the short looponthe endof the The tractiondrive controlrodhas the longlooponthe end springas shown. of the spring as shown. 1. Slide rubbersleeve uprodand hookend of springinto 1. Slide rubber sleeve up rodand hookendof springinto controlarm withloopopeningup as shown. pivot bracketwit
Streszczenie treści zawartej na stronie nr. 7
BLY / PRE-OPERATION INSTALL DISCHARGE CHUTE / CHUTE ROTATOR SPRING HEAD (See Fig. 7) 1/4-20 CHUTE SHOULDER NOTE: The multi-wrench provided inyour parts bag may be used to install the chute rotator head. HOOK 1. Place discharge chute assembly on top of chute base BETWEEN HEX NYLON with discharge opening toward front of snow thrower. NUTS WASHER ON CHUTE 2. Positionchuterotatorheadoverchutebracket. Ifneces- ROTATER HEAD 1/4-20 sary,rotatechuteassemblyto alignsquare and pinonun- LOCKNUT derside of
Streszczenie treści zawartej na stronie nr. 8
KNOW YOUR SNOW THROWER RF_.AD THIS OWNER'S MANUAL AND ALLSAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrationswithyour snowthrowerto familiarizeyourselfwiththe locationof variouscontrolsand adjustments. Save this manual forfuture reference. I II IIII III These symbols may appear on your snow thrower or in literature supplied with the product. Learn and understand their meaning. I'.,i FAST SLOW CHOKE PRIMER DANGER ENGINE ENGINE OR WARNING ON OFF READ AND FOLLOW ALL SAFETY INF
Streszczenie treści zawartej na stronie nr. 9
OPERATION SPARK ENGINE OIL CAP AUGER DISCHARGE CHUTE CONTROLLEVER DIPSTICK CONTROL PLUG. SAFETY DEFLECTOR REMOTE LEVER DRIVE SPEED IGNITION CONTROLLEVER FILLERcAP \-\\\_NTROL LEVER CHUTE CHOKE DRIVE DEFLECTOR CON- CONTROL LEVER OIL PLUG TURN TRIGGER THROTTLE / ENGINE CONTROL DISCHARGE CHUTE RECOIL POWER (AUXIL_R_ CORD STARTER LIGHT PLUG ELECTRIC HANDLE START FUEL BUTTON SHUT-OFF HANDLE PRIMER VALVE OUT KNOB TOOL MUFFLER NOTE: ITEMS ABOVE ARE SHOWN IN THEIR TYPICAL TOOLBOX LOCATION ON THE ENGINE.
Streszczenie treści zawartej na stronie nr. 10
OP The operation ofany snow thrower canresult TO USE CHOKE CONTROL (See Fig. 13) inforeign objects thrown intothe eyes, which The chokecontrolislocated on the engine. Use the choke canresultinsevere eyedamage. Always wear control whenever you are starting a cold engine. Do not safetyglassesoreye shields whileoperating use to start a warm engine. yoursnowthrower orperformingany adjust- , To engage choke, turn knob clockwise. Slowly turn ments or repairs. We recommendstandard safety glasses knob c
Streszczenie treści zawartej na stronie nr. 11
HII,IHll I II I ,ll IHlll Illll I Ill OPERATION 1 ...=..,..,.,., ,.,,..,,,,,,, ,, , , , , ,, ,, ,,,,..,,,. ,,,.., ,, ,,,, ,, TO THROW SNOW (See Fig. 15) • Squeezetraction drive control leverto handleto engage the drive system. The auger rotationis controlledby the auger controllever locatedon the right side handle, Release traction drive control lever to stop the forward or reverse movement of the snow thrower. • Squeeze auger control lever to handle to engage the auger and throw snow. SPEED and
Streszczenie treści zawartej na stronie nr. 12
OPERATION BEFORE STARTING THE ENGINE ground surface. Adjust skid plates evenly to proper height for current surface conditions. For removal of snow in CHECK ENGINE OIL LEVEL (See Fig. 21) normal conditions, such as a paved driveway or sidewalk, place skid plates in the highest position (lowest scraper The engine on your snow thrower has been shipped, from clearance) to give a !/8" clearance between the scraper the factory, already filled with oi!. bar and the ground. Use a middle position if the
Streszczenie treści zawartej na stronie nr. 13
OPERATION TO START ENGINE 6. When the engine starts, releasethe recoil starter handle and slowly move the choke control to the "OFF" posi- • Be sure fuel shut-off valve is in the "OPEN" position. tion. Your snow thrower engine is equipped with both a 120 Volt Allow the engineto warm up for a few minutes. Engine will A.C. electric starter and a recoil starter. The electric starter not develop full power until it has reached normal operat- is equipped with a three-wire power cord and plug and is i
Streszczenie treści zawartej na stronie nr. 14
i ill iinlllll, n I iii II iiiiiii1,1 MAINTENANCE iiii i i ilia,,II,,,HHIIII,,,,I MAINTENANCE sc. LE ............ / J.Y FILL IN DATES AS YOU COMPLETE REGULAR SERVICE ./_£,_/" _ DATES Check for Loose Fasteners V' R =z v' Clean / Inspect Snow Thrower O v' W Check / Replace V-Belts Lubrication Chart v' v' Check Engine Oil Level v' E v' N Change Engine Oil i,,' Inspect Muffler .......... N Check !Replace Spark Plug v' E Empty Fuel Tank GENERAL RECOMMENDATIONS LUBRICATION CHART The warranty on this s
Streszczenie treści zawartej na stronie nr. 15
MAINTENANCE i i i i i i i i i i ii ii illllllllllllll AUGER GEAR CASE • Oil will drain more freely when warm. • Catch oil in a suitable container. • The gear case was filled with lubricantto the proper level at the factory.The only time the lubricantneeds NOTE: The left side wheel may be removed from snow attention is if service has been performedonthe gear thrower for easier access to the oil drain plug and place- case. ment of a suitable container. The unit tilted, resting on the • If lubrican
Streszczenie treści zawartej na stronie nr. 16
SERVICE AND ADJUSTMENTS , ,, ,,,,,,,,,,,,,,,,,,,,,, i llllllllll, WARNING: To avoid serious injury, before performing any service or adjustments: Remove safety ignition key. 1. Be sure throttle is in STOP position. 3_ Make sure the augers and all moving parts have completely stopped. 4. Disconnect spark plug wire from spark plug and place wire where it cannot contact plug. ,,,,,llm SNOW THROWER 3. Align holes in impellerhub withholes inimpeller shaft and install two (2) new 1/4-20 x 1-5/8" capsc
Streszczenie treści zawartej na stronie nr. 17
SERVICE AND ADJUSTMENTS ill lllll 10. Install clutch rod inswing plate; secure with hairpin. be replaced. Itis recommended thatthe belt(s) be replaced by a qualified service center. 11. Place auger belt around and inside the groove of auger pulley only. NOTE: It is recommended that both the auger and traction 12. While your assistant slowly raises handles to rejoin drive belt be replaced at the same time. the auger housing and frame assembly, pull up on the TheV-belts onyour snowthrower are of s
Streszczenie treści zawartej na stronie nr. 18
i i ii ii SERVICE AND ADJUSTMENTS CARBURETOR KLIK PIN (INSTALL OUTER HOLE IN OUTER HOLE Your carburetor is not adjustable. Engine performance OF AXLE ONLY) should not be affected at altitudesupto 7,000 feet (2,134 meters), if your engine does not operate properly due to suspected carburetor problems, take your snow thrower to a qualified service center. ENGINE SPEED AXLE Nevertamperwith theengine governor, whichisfactory set for proper engine speed. Overspeeding the engine above the factory high
Streszczenie treści zawartej na stronie nr. 19
i i,illUllllllll,ii ,11 i i HH lUII Illll, lUul,,ll II ,,,IIIIIH TROUBLESHOOTING See appropriate section in manual unless directed to a qualified service centre. PROBLEM CAUSE CORRECTION ........................ Does not start 1, Fuel shut-off valve (if so 1. Turnfuel shut_offvalve to OPEN position. equipped) in OFF position. 2, Safety ignitionkey 2. Insert safety ignitionkey. is not inserted. 3. Out of fuel. 3, Fill fuel tank. 4. Throttle in STOP position. 4. Move throttleto FAST position. 5. C
Streszczenie treści zawartej na stronie nr. 20
REPAIR PARTS SNOW THROWER - MODEL PP11530ES (96192001902) AUGER HOUSING / IMPELLER ASSEMBLY 16 4 15 / 10 ( \ 5 7 \ 36 \ 11 // 44 45 •"/ 50 42 4 / 41 46 / /-- I 21 \40 39 10 49 53 54 34 32 %58 26 48 19 33 18 35 20 29 25 55 10 53 31 17 52 24 57 54 30 56 1 \ 7 20
