Instrukcja obsługi Addonics Technologies ZESSIU3CS

Streszczenie treści zawartej na stronie nr. 1

Enclosure Overview
Screw 1 Switch Screw 2
Addonics
TE C H N O L OG IE S
Power
Fan
eSATA Port
Connector
Removing the front panel
Z USB3.0 / eSATA Combo Drive Enclosure
You can remove the front panel of the enclosure to
for SATA or IDE Hard drive or Optical drive
access the drive drawer of the optical drive.
Model: ZESSIU3CS
Step 1
User’s Guide
Loosen the two screws from the rear panel. Pull out the interior tray from the
enclosure.
Step 2
FCC Warning Statement
A. Installing a 3.5” SATA hard dr

Streszczenie treści zawartej na stronie nr. 2

B. Installing a 3.5” IDE hard drive 4. At the other end of the Y-power cable is the 4-pin floppy power connector The Z USB3.0 / eSATA combo drive enclosure comes with an IDE to which you connect to the converter. Now connect the SATA cable to the SATA converter. SATA port on the converter. 40-pin IDE Connector SATA Port 4-Pin Floppy Power 5. Disconnect the SATA board from the drive enclosure. Then connect the Note: It is required to set up the IDE hard drive you are connecting to SATA cable