Streszczenie treści zawartej na stronie nr. 1
USER’S
MANUAL
PMB-601LF
®
Intel Core 2 Duo
ATX Motherboard
With VGA/Sound/2LAN
PMB-601LF M1
Streszczenie treści zawartej na stronie nr. 2
Copyright Notice PMB-601LF Intel® Core 2 Duo ATX Motherboard With VGA/ Sound/ 2LAN OPERATION MANUAL COPYRIGHT NOTICE This operation manual is meant to assist both Embedded Computer manufacturers and end users in installing and setting up the system. The information contained in this document is subject to change without any notice. This manual is copyrighted in January, 2007. You may not reproduce or transmit in any form or by any means, electronic, or mechan
Streszczenie treści zawartej na stronie nr. 3
Copyright Notice FCC NOTICE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interfer
Streszczenie treści zawartej na stronie nr. 4
Contents TABLE OF CONTENTS CHAPTER 1 INTRODUCTION 1-1 About This Manual ........................................................ 1-2 1-2 System Specification ...................................................... 1-3 1-3 Safety Precautions ......................................................... 1-6 CHAPTER 2 HARDWARE CONFIGURATION 2-1 Jumper & Connector Quick Reference Table ................ 2-2 2-2 Component Locations ..................
Streszczenie treści zawartej na stronie nr. 5
Contents CHAPTER 3 SOFTWARE UTILITIES 3-1 Introduction …………..........................................…....... 3-2 3-2 VGA Driver Utility ……………………………….…… 3-3 3-3 Flash BIOS Update ..............................................…....... 3-4 3-4 LAN Driver Utility …...........................................…...... 3-6 3-5 Sound Driver Utility …………………………………… 3-7 3-6 Intel Chipset Software Installation Utility …..……..….. 3-8 3-7 USB2.0 Softw
Streszczenie treści zawartej na stronie nr. 6
CHAPTER 1 INTRODUCTION This chapter gives you the information for PMB-601LF. It also outlines the System specifications. Section includes: About This Manual System Specifications Safety Precautions Experienced users can skip to chapter 2 on page 2-1 for a Quick Start. Page:1-1
Streszczenie treści zawartej na stronie nr. 7
Chapter 1 Introduction 1-1. ABOUT THIS MANUAL Thank you for purchasing our PMB-601LF Intel® Core 2 Duo ATX Motherboard enhanced with VGA/Sound/2LAN, which is fully PC / AT compatible. The PMB-601LF provides faster processing speed, greater expandability and can handle more tasks than before. This manual is designed to assist you how to install and set up the system. It contains four chapters. The user can apply this manual for configuration according to the following chapters
Streszczenie treści zawartej na stronie nr. 8
Chapter 1 Introduction 1-2. SYSTEM SPECIFICATIONS CPU (mPGA775): Intel® Celeron®-D, Pentium® 4, Pentium®-D, Core 2 Duo processor in mPGA775 Socket. 2.8~3.8 GHz clock generator for Pentium 4 1.86~2.66GHz clock generator for Core 2 Duo Front Side Bus 533/667/800/1066 MHZ. Auto detect voltage regulator. CHIPSET : Intel Q965 + ICH8DO+FWH MEMORY : Supports up to 8GB DDR SDRAM. Four 240-pin DDR2 DIMM sockets on board. CACHE : Built-in CPU. REAL-TIME CLOCK : Buil
Streszczenie treści zawartej na stronie nr. 9
Chapter 1 Introduction 1 ISA Slot DISPLAY : Built-in Intel Q965, support for CRT. Onboard 15-pin VGA D-SUB connector, support for resolution on SVGA Monitor. SATA INTERFACE : 6 SATA ports, support RAID 0,1,5,10. SERIAL PORT : Four serial connectors. COM1/3/4 for RS-232, COM2 for RS-232/422/485. COM3/4 can output +5V or +12V, and use jumper settings. FLOPPY DISK DRIVER INTERFACE : Support up to two Floppy Disk Drives, 3.5" and 5.25" (360K / 720K / 1.2M / 1.44M /
Streszczenie treści zawartej na stronie nr. 10
Chapter 1 Introduction HARDWARE MONITORING FUNCTION : Monitor Voltage, CPU temperature, & Cooling fan. If CPU Temperature is over setting, the buzzer will send out a warming (only under DOS system). IRDA PORT : 5-pin Infrared port, support IrDA v1.0 SIR protocol PARALLEL PORT : SPP / ECP / EPP Function. 1 port, bi-directional parallel port. GREEN FUNCTION : Controlled by hardware and software. LED INDICATOR : System power Hard Disk access (SATA) DMA CONTR
Streszczenie treści zawartej na stronie nr. 11
Chapter 1 Introduction 1-3. SAFETY PRECAUTIONS Follow the messages below to avoid your systems from damage: 1. Keep your system away from static electricity on all occasions. 2. Prevent electric shock. Don‘t touch any components of this card when the card is power-on. Always disconnect power when the system is not in use. 3. Disconnect power when you change any hardware devices. For instance, when you connect a jumper or install any cards, a surge of power may damage th
Streszczenie treści zawartej na stronie nr. 12
CHAPTER HARDWARE 2 CONFIGURATION ** QUICK START ** Helpful information describes the jumper & connector settings, and component locations. Section includes: Jumper & Connector Quick Reference Table Component Locations Configuration and Jumper settings Connector’s Pin Assignments Page 2-1
Streszczenie treści zawartej na stronie nr. 13
Chapter 2 Hardware Configuration 2-1. JUMPER & CONNECTOR QUICK REFERENCE TABLE COM1, COM2 COM Port Connector ....................…..................……… COM3, COM4 ………………………………….. JP6 COM3 Port RI/Voltage Selection …………………….. JP7 COM4 Port RI/Voltage Selection …………………… JP5 RS232/422/485 (COM2) Selection .....................……… KB_MS1 Keyboard/Mouse Connector ..........….....……………… JP8 (5, 7) Reset Connector .........................…...............
Streszczenie treści zawartej na stronie nr. 14
Chapter 2 Hardware Configuration 2-2. COMPONENT LOCATIONS PMB-601LF Connector, Jumper and Component locations Page: 2-3 PMB-601LF USER ′S MANUAL
Streszczenie treści zawartej na stronie nr. 15
Chapter 2 Hardware Configuration 2-3. HOW TO SET THE JUMPERS You can configure your board by setting jumpers. Jumper is consists of two or three metal pins with a plastic base mounted on the card, and by using a small plastic "cap", Also known as the jumper cap (with a metal contact inside), you are able to connect the pins. So you can set-up your hardware configuration by "open" or "close" pins. The jumper can be combined into sets that called jumper blocks. When the jump
Streszczenie treści zawartej na stronie nr. 16
Chapter 2 Hardware Configuration JUMPER DIAGRAMS Jumper Cap looks like this 2 pin Jumper looks like this 3 pin Jumper looks like this Jumper Block looks like this JUMPER SETTINGS 2 pin Jumper close(enabled) Looks like this 1 1 3 pin Jumper 2-3 pin close(enabled) Looks like this 1 1 Jumper Block 1-2 pin close(enabled) Looks like this 12 1 2 Page: 2-5 PMB-601LF USER ′S MANUAL
Streszczenie treści zawartej na stronie nr. 17
Chapter 2 Hardware Configuration 2-4. COM PORT CONNECTOR COM1 : COM1 Connector COM1 is fixed as RS-232. The pin assignment is as follows : PIN ASSIGNMENT 1 COM1_DCD# 2 COM1_RX 3 COM1_TX 4 COM1_DTR# 5 GND 6 COM1_DSR# 7 COM1_RTS# 8 COM1_CTS# 9 COM1_RI# COM2 : COM2 Connector The COM2 is selectable as RS-232/422/485. The pin assignment is as follows : ASSIGNMENT PIN RS-232 RS-422 RS-485 1 COM2_DCD# TX- TX- 2 COM2_RX TX+ TX+ 3 COM2_TX RX+ RX+ 4 COM2_DTR#
Streszczenie treści zawartej na stronie nr. 18
Chapter 2 Hardware Configuration COM3 : COM3 Connector COM3 is fixed as RS-232. The pin assignment is as follows : PIN ASSIGNMENT 1 COM3_DCD# 2 COM3_RX 3 COM3_TX 4 COM3_DTR# 5 GND 6 COM3_DSR# 7 COM3_RTS# 8 COM3_CTS# 9 COM3_RI# COM4 : COM4 Connector COM4 is fixed as RS-232. The pin assignment is as follows : PIN ASSIGNMENT 1 COM4_DCD# 2 COM4_RX 3 COM4_TX 4 COM4_DTR# 5 GND 6 COM4_DSR# 7 COM4_RTS# 8 COM4_CTS# 9 COM4_RI# Page: 2-7 PMB-601LF USE
Streszczenie treści zawartej na stronie nr. 19
Chapter 2 Hardware Configuration 2-5. COM3 RI & VOLTAGE SELECTION JP6 : COM3 RI & Voltage Selection The selections are as follows: JUMPER JUMPER SELECTION SETTINGS ILLUSTRATION 5V 5-6 12V 3-4 RI 1-2 ***Manufacturing Default -- RI. Page: 2-8 PMB-601LF USER ′S MANUAL
Streszczenie treści zawartej na stronie nr. 20
Chapter 2 Hardware Configuration 2-6. COM4 RI & VOLTAGE SELECTION JP7 : COM4 RI & Voltage Selection The selections are as follows: JUMPER JUMPER SELECTION SETTINGS ILLUSTRATION 5V 5-6 12V 3-4 RI 1-2 ***Manufacturing Default -- RI. Page: 2-9 PMB-601LF USER ′S MANUAL
