Streszczenie treści zawartej na stronie nr. 1
DO NOT
DISCARD
Installation & Operation
Instructions
Model:
VRTIKL-AU
FREESTANDING STOVE
AUSTRALIAN GAS ASSOCIATION CERTIFIED
Certifi cate Number: 7153
CAUTION
DO NOT DISCARD THIS MANUAL
• Important operating • Read, understand and follow • Leave this manual with
and maintenance these instructions for safe
party responsible for use
instructions included. installation and operation.
and operation.
WARNING
WARNING: If the information in these
HOT! DO NOT TOUCH.
instructions is not followed ex
Streszczenie treści zawartej na stronie nr. 2
Table of Contents 7 Appliance Setup 1 Listing and Code Approvals A. Remove Glass Door . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 A. Design and Installation Considerations . . . . . . . . . . . . . . . 4 B. Remove Shipping Materials . . . . . . . . . . . . . . . . . . . . . . . 23 B. Non-Combustible Materials Specifi cation. . . . . . . . . . . . . . 4 C. Unbolting Appliance from the Pallet . . . . . . . . . . . . . . . . . 23 C. Combustible Materials Specifi cation . . . . .
Streszczenie treści zawartej na stronie nr. 3
Gas Information 5 5 A. Gas Pressure Requirements B. Gas Connection Pressure requirements for VRTIKL-AU Stoves are shown in Table 1 below. Note: Have the gas supply line installed in accordance with local building codes by a qualifi ed installer approved and/or Two taps are provided on the right hand side of the gas licensed as required by the locality. control for a test gauge connection to measure the inlet and outlet pressures. See Section 10: Maintaining and Servicing the Appliance.
Streszczenie treści zawartej na stronie nr. 4
Electrical Information 6 6 A. Ignition System Wiring WARNING • This gas stove is equipped with an electronic ignition Shock hazard. system which operates on a 6 volt system. • Replace damaged wire with type 105º C rated • The batteries are located within the ignition module wire. which is located behind the glass door assembly. A wiring • Wire must have high temperature insulation. diagram is shown in Figure 7.1. • The ignition module requires four AA batteries (not included). CAUTION L
Streszczenie treści zawartej na stronie nr. 5
Appliance Setup 7 7 A. Remove Glass Door D. Leveling and Lagging Down the Appliance Remove the front door assembly by pulling bottom of front SECURING THE GAS STOVE away from gas stove and lifting it off of the hooks on top of IS REQUIRED. the stove. Set door assembly aside. WARNING B. Remove Shipping Materials Fire Risk. Remove shipping materials from inside or underneath the Odor Risk. fi rebox. Tipping Risk The gas line is shipped inside back panel. To access the • Install gas stove
Streszczenie treści zawartej na stronie nr. 6
F. Top to Rear Flue Conversion CLEARANCE HOLE KIT CONTENTS: Top cover (without hole); Back panel (with hole). 1. Remove the front door assembly by pulling bottom of front away from gas stove and lifting it off of the hooks on top of the gas stove. Set door aside. ON TOP OF APPLIANCE: 2. Remove the top plate with hole and discard. (Figure 7.7) Figure 7.4 The manufacturer recommends securing the lag bolt from the component bag in the center hole in the bottom plate (clearance hole).
Streszczenie treści zawartej na stronie nr. 7
ON BACK OF APPLIANCE: ON TOP OF APPLIANCE: 6. Remove the four screws from the cover plate on rear 8. Install the new back panel (without hole) to the rear of of gas stove. Set cover plate aside. Retain screws. gas stove. Replace the Allen head screws removed (See Figure 7.9). Attach DV adapter collar in its in Step 3 to hold the back panel in place. place. Install the inner extension collar. 9. Install the new top as shown in Figure 7.11. IIN NNER EXTENSION COLLAR NER EXTENSION COLLAR F
Streszczenie treści zawartej na stronie nr. 8
G. Positioning the Logs While still breakable, the logs do not become fragile until after the gas stove is burned and they have cured. After curing, any handling must be done with care as breakage can easily occur. PLEASE NOTE: Logs have been designed to work specifically with the burner of this gas stove. Exact placement will ensure proper operation of your gas stove. Figure 7.15 Locate log #2 over the pin in log #1 and into notch in log #1. Lean the log back toward the left corner
Streszczenie treści zawartej na stronie nr. 9
Operating Instructions 8 8 A. Before Lighting Appliance WARNING Read this entire manual prior to using the appliance. Failure to follow the instructions may result in property HOT! DO NOT TOUCH. damage, bodily injury, or even death. SEVERE BURNS MAY RESULT. CLOTHING IGNITION MAY RESULT. • Remove all shipping materials from inside and/or Glass and other surfaces are hot during operation and cool underneath the fi rebox. down. • Keep children away. • Review proper placement of logs an
Streszczenie treści zawartej na stronie nr. 10
B. Lighting the Appliance Electronic Ignition FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS WARNING: If you do not follow these instructions 1. This heater is equipped with an igni- exactly, a fi re or explosion may result causing property tion device which automatically lights damage, personal injury or loss of life. the burner. Do not try to light the A. This heater is equipped with an • Do not touch any electric switch; do burner by hand. electronic pilot ignition device not
Streszczenie treści zawartej na stronie nr. 11
C. After Appliance is Lit CAUTION Initial Break-in Procedure • Prevent accidental appliance operation when not When you light the appliance, you may notice that it pro- attended. duces heat which does have an associated odor or smell. • Unplug or remove batteries from remote control if absent If you feel this odor is excessive it may require the initial or if appliance will not be used for an extended period of time. three to four hour continuous burn on high followed by a second burn up t
Streszczenie treści zawartej na stronie nr. 12
Maintaining and Servicing Appliance 9 9 Although the frequency of appliance servicing and maintenance will depend on use and the type of installation, a qualifi ed service technician should perform an appliance checkup at the beginning of each heating season. WARNING WARNING Annual inspection by qualifi ed technician recommended. Risk of injury or property damage. Before servicing: Check: • Condition of glass, glass assembly and glass seal. • Turn off gas. • Obstructions of combustion and ve
Streszczenie treści zawartej na stronie nr. 13
B. Maintenance Tasks Inspect Maintenance Tasks Doors 1. Inspect for scratches, dents or other damage and repair as necessary. 2. Verify no obstructions to air fl ow. 3. Verify maintenance of proper clearance to combustible household objects. Gasket Seal, Glass 1. Inspect gasket seal and its condition. Assembly and Glass 2. Inspect glass for scratches and nicks that can lead to breakage when exposed to heat. 3. Confi rm there is no damage to glass or glass frame, Replace as necessary. 4. Ver
Streszczenie treści zawartej na stronie nr. 14
Troubleshooting 10 10 With proper installation, operation, and maintenance your gas appliance will provide years of trouble-free service. If you do experience a problem, this troubleshooting guide will assist a qualifi ed service person in the diagnosis of a problem and the corrective action to be taken. This troubleshooting guide can only be used by a qualifi ed service technician. A. Electronic Ignition System Symptom Possible Causes Corrective Actions 1. No transmission, motor Receiver
Streszczenie treści zawartej na stronie nr. 15
Reference Materials 1 11 1 A. Appliance Dimension Diagram Without Stone Surround Dimensions are actual appliance dimensions. Use for reference only. For framing dimensions and clearances refer to Section 3. A C B D Height includes 9.53 mm hearth pad. E F I G Hearth Pad H AB C D E F G H I Millimeters 479 1045 1035 403 76 181 762 733 867 Figure 11.1 Appliance Dimensions 33 Heat & Glo • VRTIKL-AU • 2123-900 • 7/07
Streszczenie treści zawartej na stronie nr. 16
B. Appliance Dimension with Stone Surround Diagram A B D F E C Hearth Pad Height includes 9.53 mm hearth pad. G Height includes 9.53 mm hearth pad. A BCD E F G Millimeters 753 620 768 83 428 867 1126 Figure 11.2 Appliance Dimensions with Stone Surround 34 Heat & Glo • VRTIKL-AU • 2123-900 • 7/07
Streszczenie treści zawartej na stronie nr. 17
C. Flue Components List COMPONENTS Ceiling Support / Wall Thimble, Black 656-230 150 mm Pipe Length, Black 908B 220 mm Pipe Length, Black 907B 310 mm Pipe Length, Black 906B 600 mm Pipe Length, Black 904B 910 mm Pipe Length, Black 903B 1210 mm Pipe Length, Black 902B 280 - 370 mm Pipe Length, Black 911B 310 - 430 mm Pipe, Adjustable, Black 912B 90 degree Elbow, Black 990B 150 mm Pipe SL-06D 220 mm Pipe SL-09D 310 mm Pipe SL-12D 600 mm Pipe SL-24D 910 mm Pipe SL-36D 1210 mm Pipe SL-48D 90 degre
Streszczenie treści zawartej na stronie nr. 18
D. Service Parts VRTIKL-AU Beginning Manufacturing Date: July 2007 Service Parts Diagram VRT-GY-N-AU, VRT-BZ-N-AU Ending Manufacturing Date: ______ VRT-GY-P-AU, VRT-BZ-P-AU 1 2 19 20 3 4 5 6 7 8 18 9 10 17 16 15 Log Set Assembly 14 11 13 12 Part number list on following page. 36 Heat & Glo • VRTIKL-AU • 2123-900 • 7/07
Streszczenie treści zawartej na stronie nr. 19
Service Parts VRTIKL-AU Service Parts List IMPORTANT: THIS IS DATED INFORMATION. The most current information is located on your dealers’ VIP site. When ordering, supply serial and model numbers to ensure correct service parts. ITEM DESCRIPTION SERIAL # PART NUMBER 7031-033 Log Set Assembly 2123-012 1 Removable Top 7031-013 2 Top Assembly 200-2470 3 Adaptor 4 inch fl ue collar 7000-162 4 DV Adaptor 460-0610 5 Adaptor Gasket 2123-027 6 Side Assembly Left 7 Firebox Assembly 2123-004 2123-124 He
Streszczenie treści zawartej na stronie nr. 20
VRTIKL-AU Service Parts Valve Assembly Parts List Beginning Manufacturing Date: July 2007 Ending Manufacturing Date: ______ Valve Assembly 1 2 3 4 5 13 7 6 8 12 11 10 9 IMPORTANT: THIS IS DATED INFORMATION. The most current information is located on your dealers’ VIP site. When ordering, supply serial and model numbers to ensure correct service parts. ITEM DESCRIPTION SERIAL # PART NUMBER 1 Log Bracket 7031-282 Pilot Assembly N 2098-050 2 Pilot Assembly P 2098-051 3 Pilot Bracket 7031-280 4 Bu
