Resumo do conteúdo contido na página número 1
VBD 1800
OWNER’S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Automatically Memory Storing
• Turn Upside Down Detachable Panel
• Preset Equalization
Resumo do conteúdo contido na página número 2
CONTENTS Installation .....................................................................................................3 DIN Front-Mount (Method A) ..................................................................................3 Installing the unit...............................................................................................3 Removing the unit .............................................................................................4 DIN Rear-Mount (Method B) .........
Resumo do conteúdo contido na página número 3
INSTALLATION Notes: DIN FRONT-MOUNT (Method A) • Choose the mounting location where Installing the unit the unit will not interfere with the normal driving function of the driver. 1 2 • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up 53 properly and the unit and the system 3 work properly. • Use only the parts included with the unit to ensure proper installation. (Fig. 1) The use of unauthorized parts can cause malfunctions. 1. Dash
Resumo do conteúdo contido na página número 4
INSTALLATION Removing the unit 1. Factory-installed radio bracket 2. Car radio mounting bracket 1 3. Screw 4. After aligning the car radio mounting bracket with the factory-installed radio bracket, tighten the screws (5 x 5mm) at 2 places on each side. 2 5. When fixed factory-installed radio 3 bracket with the screws, use a standard-tipped screwdriver to pry the tabs of the car radio mounting bracket to make them fit into the holes in the factory-installed radio bracket. 6. Movable panel fra
Resumo do conteúdo contido na página número 5
USING THE DETACHABLE FRONT PANEL 3. When the front panel is in State 3, To Detach the Front Panel press button, the front panel will slide down to State 2. Press button 1. Press the left-top inside button of the again, the panel will slide up. When back of the front panel, the front panel the front panel is in State 2, slide the will turn upside down from State 1 to bottom button of the front panel State 2 to State 3. leftward and pull it out from the panel bracket. And the panel b
Resumo do conteúdo contido na página número 6
USING THE DETACHABLE FRONT PANEL 5. Do not expose the front panel to high To Reinstall the Front Panel temperatures or direct sunlight in anywhere. 1. When the panel bracket is in slide up position, insert left side of the front 6. Keep away any volatile agents (e.g. panel to its proper position and push benzene, thinner or insecticides) from right side into the panel bracket, a touching the surface of the front panel. ‘click’ sound should be heard. 7. Do not attempt to disassemble the fro
Resumo do conteúdo contido na página número 7
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR (GREEN) SUBWOOFER IGNITION RED CABLE SWITCH (B+) YELLOW MEMORY CHOKE BACK-UP BOX (BROWN) BLACK Rch RED FRONT RCA CABLE GROUND (B–) Lch WHITE (GREY) BLUE POWER Rch RED REAR RCA CABLE ANTENNA Lch WHITE WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK 7
Resumo do conteúdo contido na página número 8
OPERATION 10 24 7 11 12 8 23 16 17 4 1 25 2 6 15 26 19 20 21 14 22 13 18 9 3 5 removable faceplate. GENERAL OPERATION • SOUND ADJUSTMENT • ON/OFF Press SEL button (10) to select the Switch on the unit by pressing the left- desired adjustment mode. top inside button of the back of them The adjustment mode will change in front panel. And the front panel will the following order: turn upside down from State 1 to State Volume Bass Treble Balance Fader 2 to State 3. When system is on, press POW
Resumo do conteúdo contido na página número 9
OPERATION • LOUDNESS • RESET Press BND/LOUD button (13) for RESET button (26) must be activated several seconds to increase bass with either a ball point pen or thin metal output and display will show “LOUD object. RESET button (26) is to be ON”. Press it again for several activated for the following reasons: seconds to release this function. - Initial installation of the unit when all wiring is completed. • SET THE CLOCK - All the function buttons do not Press the DSP button (15), and the
Resumo do conteúdo contido na página número 10
OPERATION You can sometimes improve reception When there is a disc in, press button of distant stations by selecting mono (7), the panel will slide down. operation. Then press EJECT button (4) to stop CD playing and eject the disc from the • SCAN disc slot (5). Press button (7) again Press SCAN button (25) to set function to slide up the front panel. to scan mode, which scanning to higher frequency station with receivable signal and keep on each station for several seconds. Button •
Resumo do conteúdo contido na página número 11
OPERATION • PREVIEW ALL TRACKS Press SCN button (20) to play first several seconds of each track on the current disc. Press again to stop intro and listen to track. • PLAY ALL TRACKS Press SHF button (22) to play all tracks on CD in random order. Press again to cancel the function. NOTE ON CD-R/CD-RW DISCS • On this unit, in addition to an audio CD, you can play your original CD-R or CD-RW that contain audio titles. • However, depending on the conditions of the recording equipment or the
Resumo do conteúdo contido na página número 12
REMOTE CONTROL HANDSET 1 7 4 3 8 9 6 5 13 2 12 10 11 14 15 FUNCTION KEYS & CONTROL 1. PWR = Power ON/OFF Button 2. DSP = Display Button 3. SEL = Select Button 4. VOL = Volume Up Button 5. VOL = Volume Down Button 6. BND = Band Select Button 7. MOD = Mode Button 8. TUNE/SEEK = Tune/Seek Down Button 9. TUNE/SEEK = Tune/Seek Up Button 10. AMS = Automatic Storing & Program Scanning Button 11. M1 - M6 = Preset Buttons 12. PAU = Pause Button 13. SCN = Scanning Button 14. RPT = Repeat Button 15. SHF =
Resumo do conteúdo contido na página número 13
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output Power : 4 x 60 Watts Current Drain : 15 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB Frequency Response : 20 Hz - 20 KHz RADIO FM Frequency Coverage : 87.5 to 107.9 MHz IF : 10.71 MHz Sensitivity (S/N = 30 dB) : 3 µ V Stereo Sep
Resumo do conteúdo contido na página número 14
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot be Presence of CD disc inside Remove the disc in the player, load
Resumo do conteúdo contido na página número 15
Resumo do conteúdo contido na página número 16
www.lanzar.com 88-C1580-09
