Краткое содержание страницы № 1
Introduction
IMPORTANT:
The VT2420 is an Accessory Handset for use with the VT2431 GIGAPHONE
system. You must have the VT2431 in order to use the VT2420 Accessory Handset.
This manual is designed to familiarize you with the VT2420 Accessory Handset
setup, registration and basic functions. For detailed operational instructions,
please refer to the VT2431 manual.
To order additional system Handsets (model# VT 2420), battery packs, or
headsets, call VTech Communications Inc at 1-800-595-9511.
1
Краткое содержание страницы № 2
Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use this product near water (for exa
Краткое содержание страницы № 3
12. Unplug this product from the wall outlet and refer servicing to a VTECH authorized service facility under the following conditions: A. When the power supply cord or plug is damaged or frayed. B. If liquid has been spilled into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, because improper adjustment of other cont
Краткое содержание страницы № 4
Setup Registration And Operation Of The VTECH VT2420 Accessory Handset Your VTECH GIGAPHONE system can operate up to 4 Handsets. The VTECH accessory Handset consists of the following: Belt Clip Battery Pack Charger Unit Handset Setup Of The VT2420 1 Accessory Handset 1. Plug the AC power adapter into an electrical outlet. 2. Remove the Handset battery cover by pressing on the indent and sliding downward. 3. Place the new battery pack in the Handset, with the metal contacts aligned with the charg
Краткое содержание страницы № 5
Installation of Battery Pack in Handset Follow the steps below: 1 1. Remove the battery cover by pressing on the indent and sliding downward. 3 2. Place the new battery pack in the handset with the metal contacts aligned with the charge contacts in the battery compartment. 3. Replace the battery cover by sliding it upwards. 4. If the new battery pack is not already charged, place the handset in the base unit, or a remote charging stand, and allow it to charge for 12 hours. After initial charge,
Краткое содержание страницы № 6
Registration Enter Base ID Code 1. After charging the Handset, remove it from its Charge Cradle, the screen will display: 2. Press NEW, then enter the 15 digit Base Unit ID code, located on the underside of the Base Unit. 3. Press OK. The Handset will display: PLEASE WAIT!! 4. Wait approximately 15 seconds. The Handset will display: FOUND BASE If the Handset displays: BASE BUSY TRY LATER, this indicates that the system is in use. Wait until the Base Unit is in the idle (on hook) mode, and re
Краткое содержание страницы № 7
The Handset Layout 1 2 3 9 4 10 5 11 6 12 7 13 8 14 1. Antenna 8. Handsfree Speakerphone 2. Message Waiting Indicator 9. LCD Display 3. Earpiece 10. Select 4. Headset Jack (2.5mm) 11. Off (Clear) 5. Scroll Keys 12. Battery Compartment 6. On (Flash) 13. Intercom 7. Dialing Key (0-9) 14. Microphone 7 Getting Started
Краткое содержание страницы № 8
Handset Indicators Handset Icons Icon Description Line In Use indicator On steady with no number next to it when a parallel set is in use. On steady with one or more numbers next to it, indicating which extensions are using the line. For example, 12 indicates that Handset 1 and Handset 2 are on an outside call. Intercom indicator On steady with the extension numbers currently on an intercom call. For example, 02 indicates that the Base and Handset 2 are on an intercom call. Battery
Краткое содержание страницы № 9
Headset Operation Your GIGAPHONE cordless telephone is equipped with a 2.5mm Headset Jack for use with an optional accessory Headset for hands-free operation. If you choose to use the Headset option, you must obtain an optional accessory Headset, which is compatible with the GIGAPHONE. To purchase a Headset, call VTECH Customer Service at 1-800-595-9511. Once you have a compatible 2.5mm Headset, locate the Headset Jack on the GIGAPHONE Handset. Connect the plug on the Headset cord to the jack o
Краткое содержание страницы № 10
Maintenance Taking Care Of Your Telephone Your GIGAPHONE cordless telephone contains sophisticated electronic parts, so it must be treated with care. Avoid rough treatment Place the Handset down gently. Save the original packing materials to protect your telephone if you ever need to ship it. Avoid water Your telephone can be damaged if it gets wet. Do not use the Handset outdoors in the rain, or handle it with wet hands. Do not install your Base Unit near a sink, bathtub or shower. Electrical s
Краткое содержание страницы № 11
In Case Of Difficulty If you have difficulty operating your phone, the suggestions below should solve the problem. If you still have difficulty after trying these suggestions, call VTECH Communications at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800- 267-7377. The Phone Doesn't Work At All • Make sure the Power Cord is plugged • Make sure the telephone line cord is plugged firmly into the Base Unit and the telephone wall jack. • Make sure the batteries are properly charged
Краткое содержание страницы № 12
In Case Of Difficulty You Hear Other Calls While Using Your Phone • Disconnect your Base Unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company. You Hear Noise In The Handset, And None Of The Keys Or Buttons Work • Make sure the power cord is plugged in. Common Cure For Electronic Equipment If the unit does not seem to be responding normally, then try putting the Hand
Краткое содержание страницы № 13
Warranty Statement WHAT DOES OUR WARRANTY COVER? • Any defect in material or workmanship. FOR HOW LONG AFTER THE ORIGINAL PURCHASE? • To the original purchaser only - ONE YEAR. WHAT WILL VTECH DO? • At our option, repair or replace your unit. HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY? • In the U.S. Call VTech Communications Inc customer service for Return Authorization at: 1-800-595-9511. In Canada, call VTech Electronics Ltd at 1- 800-267-7377 • Properly pack your unit. lnclude an
Краткое содержание страницы № 14
Warranty Statement WHAT DOES OUR WARRANTY NOT COVER? • Batteries • Damage from misuse, neglect, or acts of nature (lightning, floods, power surges, etc.) • Products which may have been modified or incorporated into other products • Products purchased and/or operated outside the USA, its territories, or Canada. • Products serviced by the owner or a service facility not expressly authorized by VTECH Communications • Products purchased more than 12 months from current date • Units purchased in "AS
Краткое содержание страницы № 15
FCC and IC Regulations This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS- 03 of Industry and Science Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. A label is located on the underside of the Base Unit con
Краткое содержание страницы № 16
FCC and IC Regulations FCC Part 68 The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C, RJ11W or RJ14). Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint with the FCC. Occasionally, your telephone company may make c
Краткое содержание страницы № 17
FCC and IC Regulations Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of services in some situations. Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the sup
Краткое содержание страницы № 18
Technical Specifications WEIGHT FREQUENCY CONTROL Crystal controlled Handset : 185 grams PLL synthesizer Charger : 200 grams TRANSMIT FREQUENCY POWER REQUIREMENTS 2401.056 - 2481.408 MHz Handset : 2.4 VDC NiMH Battery Pack RECEIVE FREQUENCY 2401.056 - 2481.408 MHz Charger : 6 VDC @ 300mA CHANNELS 94 Channels MEMORY Speed Dial: 50 Memory locations, into NOMINAL EFFECTIVE 32 digits per location. RANGE CID : Alpha Numeric Display Maximum power allowed by FCC and IC. Actual operating range may vary
Краткое содержание страницы № 19
19
Краткое содержание страницы № 20
Table Of Contents 1. Introduction 2. Important Safety Instructions 4. Getting Started 4. Setup 5. Installation of Battery Pack in Handset 6. Registration 7. The Handset layout 8. Handset Operation 8. Handset Indicators 9. Additional Information 9. Headset Operation 10. Maintenance 11. In Case Of Difficulty 13. Warranty Statement 15. FCC and IC Regulations 18. Technical Specifications
