Краткое содержание страницы № 1
Preparation Basics Caller ID/Call waiting
Additional Information
*SG-1800.qx 7/11/0 7:03 PM Page 1
Краткое содержание страницы № 2
*SG-1800.qx 7/11/0 7:03 PM Page 2 GETTING STARTED: DO THIS FIRST! FIRST, • Before you can take advantage of the Caller ID and Call Waiting features, you must subscribe to these services from your local telephone company. • Name and number caller ID only work in conjunction with service provided by your local telephone company. SECOND, after unpacking your new cordless phone: CHARGE THE HANDSET BATTERY! • Set your new phone in an out-of-the-way place near a power outlet where it will not be dis
Краткое содержание страницы № 3
*SG-1800.qx 7/11/0 7:03 PM Page 3 TABLE OF CONTENTS Preparation IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . .5 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 Parts identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 LOCATION OF CONTROLS . . . . . . . . . . . . . . . .
Краткое содержание страницы № 4
*SG-1800.qx 7/11/0 7:03 PM Page 4 TABLE OF CONTENTS MEMORY DIALING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 Storing numbers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 Dialing a stored number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25 Changing and deleting stored numbers . . . . . . . . . . . . . . . . . . . . . .26 Caller ID/Call waiting CALLER ID/CALL WAITING . . . . . . . . . . . . . . . .
Краткое содержание страницы № 5
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 5 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, 9 Never push objects of any kind into this product through cabinet slots as basic safety precautions should always they may touch dangerous voltage be followed to reduce the risk of fire, points or short out parts that could electric shock and injury. result in a risk of fire or electric shock. 1 Read and understand all instructions. Never spill liquid of any kind on the 2 Follow al
Краткое содержание страницы № 6
*SG-1800.qx 7/11/0 7:03 PM Page 6 IMPORTANT SAFETY INSTRUCTIONS TM The RBRC Seal TM The RBRC Seal on the (easily removable) nickel-cadmium battery (contained in our product) indicates that Toshiba America Consumer Products, Inc. (TACP) is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful lives, TM when taken out of service within the United States. The RBRC program provides a convenient alternative to placing used nickel- cadmiu
Краткое содержание страницы № 7
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 7 INTRODUCTION FEATURES Toshiba America Consumer Products, Inc., takes pride in presenting the SG-1600/1800 digital spread spectrum cordless telephone. The Toshiba SG-1600/1800 handset features a 16-digit x 3-line dot matrix liquid crystal display (LCD) for caller ID on Call Waiting and speed dial programming and calling. The sleek new design provides face-up battery charging even when wall mounted. Other features are summarized below. • 2.4GHz dig
Краткое содержание страницы № 8
1800 *SG-1800.qx 7/11/0 7:03 PM Page 8 INTRODUCTION PARTS IDENTIFICATION Handset Base Unit SUPPLIED ACCESSORIES: Wall Mount Bracket Modular Line Cord Part #.RC009262 Part #.RC008231 Rechargeable Battery Pack Toshiba TRB-8000 Part #.RC004931 AC Adaptor TAC-1700 Belt Clip Part #.RC009258 Part #.RC009263 Owner’s manual Quick Reference Guide Part #.RC009260 Part #.RC009261 For purchase of accessories, please call 1-877-644-7373. 8
Краткое содержание страницы № 9
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 9 LOCATION OF CONTROLS HANDSET Antenna VOL (VOLUME/RINGER) button (Up Headset jack arrow button) VOL (VOLUME/RINGER) button (Down arrow button) (page 20) MEM (Memory) button (page 23) CID (Caller ID) button (page 30 to 35) TALK button (page 18 to 19) CID L.D./1 button (page 32) FLASH button (page 29) L.D. LOCAL LOCAL/3 button (page 32) TONE/ (TONE) button (page 21) Dialpad ( ) button (Left arrow button) (page 23 to 27) # ( ) button (Right arrow b
Краткое содержание страницы № 10
*SG-1800.qx 7/11/0 7:03 PM Page 10 INSTALLATION SETTING UP THE BASE UNIT (DESK TOP MOUNTING) For setting up the base unit follow the instructions below. Snap the bracket’s tab into the notches on the base. Fasten the AC adaptor cord to prevent it from being disconnected. Raise the anntenna to vertical position. Single-Line Telephone Jack (RJ11C) Telephone Line Cord Power Outlet (AC 120 V, 60 Hz) AC Adaptor • USE ONLY WITH Supplied AC ADAPTOR (TAC-1700; power source AC 120V 60Hz/DC9V). • The
Краткое содержание страницы № 11
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 11 INSTALLATION SETTING UP THE BASE UNIT (WALL MOUNTING) MOUNTING ON A STANDARD WALL PLATE: Insert the bracket’s tabs into the base’s lower tab slots, then press down on the top of the bracket to snap it into the clip slots. Flip the switch hook tab over so the tab holds the handset. Raise the antenna. Single-Line Telephone Jack (RJ11C) Telephone Line Cord Power Outlet AC Adaptor (AC 120 V, 60 Hz) • Route the cords through the guides. • Place the bas
Краткое содержание страницы № 12
*SG-1800.qx 7/11/0 7:03 PM Page 12 INSTALLATION CHARGING THE BATTERY PACK 1 Remove the battery compartment Black Red cover on the back of the handset by sliding it down. 2 Plug the battery pack cord into the connector in the battery compartment by observing the correct polarity. It fits in only one way. 3 Place the battery pack in the battery compartment. 4 Put the battery compartment cover back by sliding until it snaps into place. Make sure not to get the wires of the battery pack caught in
Краткое содержание страницы № 13
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 13 INSTALLATION After the battery pack is fully charged; Operation Approx. battery life While in use (Talk mode) up to 6 hours While not in use (Standby mode) up to 7 days When "Low Battery"blinks on the LCD, the battery needs to be charged. Finish the call as soon as possible and place the handset on the base unit. Low Battery NOTE: If a call comes in when the battery is too low to operate properly, you will be unable to answer the call or the call
Краткое содержание страницы № 14
*SG-1800.qx 7/11/0 7:03 PM Page 14 INSTALLATION SETTING THE TONE/PULSE SWITCH Set the TONE/PULSE switch to TONE. If the call does not connect with the TONE setting, set the TONE/PULSE switch to PULSE. TONE/PULSE switch SETTING OR CANCELING THE AUTO TALK FUNCTION If the handset is placed on the base unit, you can answer a call by simply lifting the handset from the base unit (Auto Talk). If the handset is not on the base unit, you can answer a call by pressing any one of the buttons (Any-key A
Краткое содержание страницы № 15
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 15 INSTALLATION SETTING OR CANCELING CALLER ID ON CALL WAITING This function is preset to ON at the factory so that you will receive caller ID on Call Waiting when subscribing to both local telephone company services. If you do not subscribe to these services, be sure to set this function to OFF. SELECT FUNCTION 1 Press FUNCTION . The LCD displays the 1s sAuto Talk:Off current setting. 2 CIDCW :On 3 Area Code:615 2 2 Press or to move the pointer to 1
Краткое содержание страницы № 16
*SG-1800.qx 7/11/0 7:03 PM Page 16 INSTALLATION SETTING THE AREA CODE It is necessary to program your area code so that local calls will be properly displayed on caller ID. Dialpad SELECT FUNCTION 1 Press FUNCTION . The LCD displays the 1s sAuto Talk:Off following message. 2 CIDCW :On 3 Area Code: 3 2 Press or to move the pointer to Area 1 Auto Talk:Off Code. 2 CIDCW :On 3s sArea Code: 3Press . SELECT 1 Auto Talk:Off 2 CIDCW :On Enter a 3-digit area code. For example, enter 3 Area Code:615
Краткое содержание страницы № 17
Preparation *SG-1800.qx 7/11/0 7:03 PM Page 17 INSTALLATION CARRYING THE HANDSET IN THE BELT CLIP You can attach the Belt Clip to the handset in order to carry it on your belt. Attaching the Belt Clip to the Handset Insert the Belt Clip tabs into the holes on each side of the handset until they click. NOTE: Be sure to insert the tabs properly into each hole to prevent the Belt Clip from falling off. Removing the Belt Clip from the Handset Pull both sides of the Belt Clip to release the tabs
Краткое содержание страницы № 18
*SG-1800.qx 7/11/0 7:03 PM Page 18 BASIC OPERATION MAKING A CALL TALK Dialpad DELETE 1 Key-in the phone number. 1234567890123456 The LCD displays the entered numbers. 789 NOTE: DELETE To delete a wrong number, press . To delete all numbers, press and DELETE hold . TALK 2Press . “Talk” and the volume setting Talk appears on the LCD. The number is dialed. Talk 0:00 1234567890123456 789 After about 5 seconds, the LCD displays the duration of the call. TALK 3 To hang up, press or place th
Краткое содержание страницы № 19
Basics *SG-1800.qx 7/11/0 7:03 PM Page 19 BASIC OPERATION ANSWERING A CALL TALK 1 When a call is received, the phone rings and Incoming call the LCD displays as shown. 2 Press TALK to connect. Talk 0:00 “Talk” and the volume setting appears on the LCD. TALK 3 To hang up, press or place the handset 12:35 on the base unit. OUT OF RANGE During a call, as you begin to move too far from the base unit, you first hear a clicking sound. As you travel farther, the noise increases. Then, yo
Краткое содержание страницы № 20
*SG-1800.qx 7/11/0 7:03 PM Page 20 BASIC OPERATION CHANGING THE RINGER VOLUME Use the following procedure to set the ringer volume of the handset as desired. VOL VOL Press to select one of four ringer tone and volume combinations during standby mode. VOL Each time you press ( or ), the LCD will display the setting and the phone will ring using the selected ringer. CHANGING THE HANDSET SPEAKER VOLUME VOL During a telephone call, press VOL to select one of four speaker volume levels; Loud, Hig
