Руководство по эксплуатации Havis-Shields C-VS-1000-TAH

Краткое содержание страницы № 1

INSTALL INSTRUCTIONS C-VS-1000-TAH
VEHICLE SPECIFIC CONSOLE
2007 CHEVY/GMC SUBURBAN/TAHOE/YUKON XL/YUKON

TOOLS REQUIRED:
Ratcheting wrench Power drill w/ 1/8” drill bit (optional)
Metric/Standard Socket Set Screwdriver set
Standard Wrench Set T-20 torx bit

HARDWARE:
QTY DESCRIPTION PART #
1 OEM switch bracket CM001800-3
4 ¼-20 Serrated nut GSM30023
2 ¼-20 x ¾” Hex bolt GSM33001
2 #10 x ¾” Sheet metal screw GSM33195
1 Torx screw hardware kit C-HK-1
C-VS-1000-TAH
Switch cu

Краткое содержание страницы № 2

#1 #2 View of factory full-length console Remove factory cup holder/accessory with C-VS-1000-TAH pocket from console Note: #3 CAREFULLY separate trim bezel If your console is not equipped with from dashboard adjustable pedal, tow package, and power brake switches proceed to step #13 C-VS-1000-TAH-INST-1-07

Краткое содержание страницы № 3

#4 #5 #6 Using a flat head screwdriver Remove entire bezel and put aside. Remove factory trim screws to concentrate pressure on or around remove the lower switch panel on the trim bezels “J” clips dashboard #7 #8 #9 Remove factory switch box from Using a small flat head Unplug switch and set aside for trim panel screwdriver, unclip fastener later install #10 #11 #12 View of factory console at this time Install switch box into Attach switch box to console C-VS-1000-TAH (if necessary

Краткое содержание страницы № 4

#13 #14 #15 Install lighter plugs and extend Slide C-VS-1000-TAH, front side Carefully drop backside of wires as necessary. first, as shown above. console as shown #16 #18 #17 Re-attach factory plug into Be sure plug is secure and Align rear-mounting studs into switch box wires are carefully routed so factory console holes and attach not to chafe using ¼” Serrated nuts. For added #20 #19 support install #10 x ¾” screws Attach middle of VS console to factory console Route all w