Руководство по эксплуатации Amphony 1000

Краткое содержание страницы № 1

User and Installation
Guide
2.4 GHz DIGITAL
Wireless Headphones
Model 1000
R

Краткое содержание страницы № 2

R User and Installation Guide Unpacking: Check that this package contains: One set of 2.4 GHz Digital Wireless Headphones, one 2.4 GHz Digital Audio transmitter, one AC adapter, one dual RCA audio cable.
 Connecting the transmitter The transmitter connects to a line-out interface via the supplied RCA cable. Most audio devices provide a line-out interface. If no line-out interface is available, the transmitter can also be connected to other audio outputs by using an appropriate adapter. It

Краткое содержание страницы № 3

R User and Installation Guide
 Placing the transmitter The operating range essentially depends on how many obstacles there are between the transmitter and the headphones. Therefore, it should be carefully considered where to place the transmitter. Below, two examples are given. In the first example, there are 4 walls between the transmitter and the receiver. The transmission may be interrupted. By locating the transmitter such as in the second example, reliable transmission to all of the 6

Краткое содержание страницы № 4

R User and Installation Guide
 Installing the headphone batteries Two AA (UM-3, R6, Mignon - 1.5 V) batteries are required to operate the headphones. Rechargable batteries with a sufficiently high voltage can be used as well. Choosing batteries with a high capacity (mAh) will extend operating time. There are two battery compartments, located on both sides, each housing one battery. To access each battery compartment, push on the outer edge of the battery lid. This will release the battery

Краткое содержание страницы № 5

R User and Installation Guide
 Operating the headphones After powering up the transmitter, the transmit light will light for approximately 5 seconds while the transmitter initializes. After initialization, the transmit light will go out. Once audio is detected at the audio input, the transmit light will light and the transmitter will transmit the audio signal. Set the volume control of the headphones to minimum. Then, switch on the headphones and slowly increase volume. After each use, be

Краткое содержание страницы № 6

R User and Installation Guide Problems and Solutions Table What Is Possible Why What to Do Happening Transmit light of Faulty AC adapter Check the power outlet and the transmitter does or faulty power outlet AC adapter, if possible, check for not light when correct voltage of the adapter. DC power is applied Transmit light No audio present at Check the audio connection to goes out after 5 audio input the transmitter and ensure that seconds and there is audio present. does not light Transmitter h

Краткое содержание страницы № 7

R User and Installation Guide Technical Specifications Transmitter: Audio transmission method: Digital Transmitter frequency: 2.4 GHz Signal-to-Noise ratio (A-weighted): typ. 93 dB Dynamic range: typ. 93 dB Channel separation: typ. 91 dB Harmonic distortion: typ. -88 dB Error correction: 1/2 rate FEC Audio sampling method: 64 times oversampling Transmitted data rate: > 3 Mbps Data available at high-speed data port Max. Transmitter output power:1mW Transmitter operating range (without RangeBooste

Краткое содержание страницы № 8

Limited warranty WHAT YOUR WARRANTY COVERS This warranty extends only to the original user of the equipment (“you”, ”your”) and is limited to the purchase price of each part. Amphony and it’s affiliated companies (”we”, ”our”, ”us”) warrant this Wireless Headphone Set against defects in materials or workmanship as follows. LABOR: For a period of ninety (90) days from the original date of purchase, if we determine that the equipment is defective subject to the limitations of this warranty, we wil