Краткое содержание страницы № 1
2-in-1
Headset
Black, HS201A
Blueberry, HS202A
Strawberry, HS203A
Grape, HS204A
Lime, HS205A
Краткое содержание страницы № 2
FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC rules, w
Краткое содержание страницы № 3
2-IN-1 HEADSET FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until the repair has been
Краткое содержание страницы № 4
CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring properly. 6. In the event of an equipment malfunction, all repairs should be performed by your supplier or an authorized agent. It is the responsibility of users requi
Краткое содержание страницы № 5
2-IN-1 HEADSET CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of devices, subject only to the requirement that the total of the load numb
Краткое содержание страницы № 6
NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado. 9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso. La colocación del aparato eléctrico sobre una cama, sofá, alfombra o superficie
Краткое содержание страницы № 7
2-IN-1 HEADSET 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato; o C: El aparato ha sido expuesto a la lluvia; o D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o E: El aparato ha sido tirado o su cubi
Краткое содержание страницы № 8
TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL ® UL is a registered trademark of Underwriters Laboratories Incorporated. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners. 7
Краткое содержание страницы № 9
2-IN-1 HEADSET Contents 1. Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 2. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 2.1 About This Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 2.2 2-in-1 Headset Components
Краткое содержание страницы № 10
CHAPTER 1: Specifications Speaker—Dynamic 1. Specifications Volume Control Range— Transmit: 18 dB (typical) Distortion—Less than 5% General: Frequency Response—300 to 3000 Hz Compliance—Registered to ® UL 1459; FCC Part 68 Microphone—Noise- registered; OSHA Part 1910 canceling electret subpart S; CSA C22.2 No. 225-M90 Power—Current consumption: 250 µa @ Weight—1.09 oz. (30.9 g) 3 VDC; Operating voltage: 1.5 to 10 VDC Receive: Automatic Gain Control (AGC)— -41 dBV with 1 kHz input Frequency Respo
Краткое содержание страницы № 11
2-IN-1 HEADSET ™ 4. Adjustable Lobe Hinge 2. Introduction 6. 5. Ear Capsule 2.1 About This Guide 6. Flexible Wire Headband This guide contains instructions 5. for the 2-in-1 Headset. To derive 7. Ear Cushion (for Headband maximum benefit from this 8. Wearing) 7. versatile product, please take a few 4. minutes to review this user’s 8. Foam Windscreen guide. 3. 2. 9. Clothing Clip 1. If after reviewing this guide you 10. Quick Disconnect have any questions concerning the 2-in 1 Headset, please cal
Краткое содержание страницы № 12
CHAPTER 3: Ear Capsule 3. With your thumb, close the 3. Ear Capsule ear lobe hinge until it is The 2-in-1 Headset comes out of snug, secure and comfortable to wear, but not the box with the ear capsule tight on your ear. installed ready to be worn on the right ear (see Figure 3-1). It 4. Lightly press the speaker features an Adjustable Lobe against the ear for proper Hinge for a custom fit. To change positioning. to the left ear, see Section 3.2. To remove, simply lift the 2-in-1 Headset off you
Краткое содержание страницы № 13
2-IN-1 HEADSET 4. Push the C-ring onto the receiver housing until it springs into place in the groove (see Figure 3-5). Figure 3-3. Changing Ears. Figure 3-4. Removing Ear Capsule. 3. Rotate 180° clockwise if you 4. Pull down and out with your are going from right ear to right hand, releasing the C- left ear, counterclockwise if ring from the receiver you are going from left ear housing. Figure 3-5. Installing Ear Capsule. to right ear. 3.4 Installation 3.3 Removal 1. Remove the headband. 1. Re
Краткое содержание страницы № 14
CHAPTER 4: Headband pointing to the left. 4. Headband 3. With your right hand, hold The 2-in-1 Headset can also be the headband between your equipped with a lightweight thumb and index finger. flexible headband. 4. Pull up on the receiver and 4.1 Installation push down on the Figure 4-1. Installing Headband. headband until the C-ring 1. Remove the ear capsule. snaps off of the receiver 4. Push the C-ring of the housing (see Figure 4-2). headband onto the receiver 2. With the corded side of the h
Краткое содержание страницы № 15
2-IN-1 HEADSET Figure 4-4. Headband Wearing. Figure 4-3. Changing Ears. Refer to the Microphone Positioning 4.4 Headband Wearing section (Chapter 5) for additional information. Position the headset lightly on your head (see Figure 4-4). The 2-in-1 Headset headband is extremely lightweight, ensuring a comfortable fit that lasts all day. The stabilizer cushion rests just above the ear on the side of your head opposite the receiver. 14
Краткое содержание страницы № 16
CHAPTER 5: Microphone Positioning The 2-in-1 Headset has a flexible 5. Microphone boom that can be reshaped until Positioning the microphone is correctly positioned in front of your mouth. To take advantage of the noise- One hand should grasp and canceling qualities of the steady the receiver end of the microphone, position the 2-in-1 boom. The other hand can then Headset with the flat side of the flex the boom (see Figure 5-2). microphone, marked with an F, facing you. The microphone boom shoul
Краткое содержание страницы № 17
2-IN-1 HEADSET 6. Clothing Clip The clothing clip should be fastened for comfortable wearing (see Figure 6-1). Figure 6-1. Clothing Clip. It is designed to prevent the weight of the cord from dislodging the headset. Position the clip conveniently on your clothing. To reduce excess slack, reposition the clip by sliding it up and down the cord. 16
Краткое содержание страницы № 18
CHAPTER 7: Connecting to Your Telephone your headset. If you are on a call, 7. Connecting to disconnecting at the Quick Your Telephone Disconnect effectively puts the other party on hold until you An amplifier is needed to connect return. the headset to the telephone or telephone system. The headset is equipped with a Quick Disconnect plug which mates to a Quick Disconnect jack on the amplifier. Follow the instructions supplied Figure 7-1. Amplified Configuration. with the amplifier to connect
Краткое содержание страницы № 19
2-IN-1 HEADSET A user in close proximity to or • Install static-dissipative 8. Maintenance carpets or floor coverings touching the computer may feel a The foam covers on the receiver (anti-static sprays can be common “shock” sensation, helpful). and microphone can be washed in similar to touching a doorknob mild soap and water. Replacement after walking across a carpet, • Remove the headset before covers are available from Black causing no harm to the user. This turning the computer on or Box. C
Краткое содержание страницы № 20
CHAPTER 9: Troubleshooting • any particular application 9. Troubleshooting that, when used, appears to create the problem or make 9.1 Calling Black Box it worse. If you determine that your 2-in-1 Headset is malfunctioning, do not 9.2 Shipping and Packaging attempt to alter or repair the unit. If you need to transport or ship It contains no user-serviceable your 2-in-1 Headset: parts. Contact Black Box at 724-746-5500. • Package it carefully. We recommend that you use Before you do, make a record
