Краткое содержание страницы № 1
Operator ’s Manual
RT380H T ractor
with Recycling/Side Discharge Deck
G006889
Code 135E
Serial No. 280000001
Manual Part No. 1 1 1-2091 Rev C
Краткое содержание страницы № 2
Contents Introduction Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 R ead this infor mation carefully to lear n ho w to operate Safe Operation Practices for Ride-on (Riding) and maintain y our product properly and to a v oid injur y R otar y
Краткое содержание страницы № 3
Fuel System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Safety Draining the Fuel T ank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 R e placing the Fuel Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Safe Operation Practices for Electrical System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Ser vicing the Batter y . . . . . . . . . . . . . .
Краткое содержание страницы № 4
• T horoughly inspect the area where the equipment • Use care when pulling loads or using hea vy is to be used and remo v e all objects whic h ma y be equipment. thro wn b y the mac hine . – Use only appro v ed dra wbar hitc h points . • W ar ning —Fuel is highly flammable . – Limit loads to those y ou can safely control. – Store fuel in containers specifically designed for – Do not tur n shar ply . Use care when rev ersing . this pur pose . – Use counterw eight(s) or wheel w eights when – R efu
Краткое содержание страницы № 5
• R educe the throttle setting during engine r un-out and, if the engine is pro vided with a shut-off v alv e , tur n the fuel off at the conclusion of mo wing . • Use only Ha yter -appro v ed attac hments . T he w ar ranty ma y be v oided if y ou use the tractor with unappro v ed attac hments . Maintenance and Storage • K ee p all n uts , bolts and screws tight to be sure the equipment is in safe w orking condition. • Nev er store the equipment with fuel in the tank inside a building where fume
Краткое содержание страницы № 6
Slope Chart 6
Краткое содержание страницы № 7
Safety and Instructional Decals Safety decals and instr uctions are easily visible to the operator and are located near any area of potential dang er . R e place any decal that is damag ed or lost. 92-5730 1. Choke 3. Continuous variable setting 2. Fast 4. Slow 1 14-3236 1. Parking brake—to engage, press the brake/clutch pedal and lift the parking brake lever; to disengage press and release the brake/clutch pedal. 2. Brake and clutch—to engage, press the brake/clutch pedal. 3. T raction drive—to
Краткое содержание страницы № 8
93-6677 1. W arning—don’t operate the mower with the deflector up or removed; keep the deflector in place. 99-2986 2. Cutting/dismemberment hazard of hand or foot, mower blade—stay away from moving parts. 1. Crushing/dismemberment hazard of bystanders—do not turn the key while children are present; keep children a safe distance from the machine. 99-5340 1. Reverse interlock key—turn to enable reverse mowing. 93-6679 1. Engine 93-7009 1. W arning—don’t operate the mower with the deflector up or r
Краткое содержание страницы № 9
Battery Symbols Some or all of these symbols are on your battery 1. Explosion hazard 6. Keep bystanders a safe distance from the battery . 2. No fire, open flame, or 7. W ear eye protection; smoking. explosive gases can 100-7449 cause blindness and other injuries 1. Pull the lever out to push 3. Read the instructions the machine. before servicing or 3. Caustic liquid/chemical 8. Battery acid can cause blindness or severe burns. performing maintenance. burn hazard 4. W ear eye protection 9. Flush
Краткое содержание страницы № 10
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty . Use Front wheels 2 Shim washers (as required) 2 Flat washers 2 Install the front wheels. 1 Cotter pins 2 Hub caps 2 No parts required – Check the tyre pressure. 2 Steering wheel 1 Install the steering wheel. 3 Spirol pin 1 Seat 1 Knobs 2 Install the seat. 4 Flat-washer 2 Bulk electrolyte, 1.260 specific gravity As (purchase separately) needed Activate the battery . 5 Bolt (1/4 x 3/4 inch
Краткое содержание страницы № 11
1 2 Installing the Front Wheels Checking the T yre Pressure Parts needed for this procedure: No Parts Required 2 Front wheels Procedure 2 Shim washers (as required) Ensure that the air pressure in the front and rear tyres 2 Flat washers are 20 psi (138 kP a). Chec k the pressure at the v alv e 2 Cotter pins stem ( Figure 4 ). 2 Hub caps Procedure 1. Install the shim w ashers onto the axle . 2. Install the wheel onto the axle with the v alv e stem facing out. Figure 4 1. V alve stem 3. Slide the
Краткое содержание страницы № 12
Figure 6 Figure 5 1. Seat 4. Seat switch 1. Steering wheel 2. Spirol pin 2. Shoulder bolts 5. Seat base 3. Knobs and flat washers 3. Align the holes b y inser ting a punc h or a long nail 2. T hread the knobs and flat w ashers through the slots par tially through the holes in the steering wheel and and into the rear center holes in the seat ( Figure 6 ). shaft. 4. Inser t the spirol pin into the hole on the opposite 3. Adjust the seat and tighten the knobs . side ( Figure 5 ). 4. Connect the sea
Краткое содержание страницы № 13
Batter y electr ol yte contains sulfuric acid, a deadl y poison that can sev er el y bur n y ou and other s. • Do not drink electr ol yte and a v oid contact with skin, ey es, or clothing . W ear safety g lasses to shield y our ey es and r ub ber g lo v es to pr otect y our hands. Figure 8 • Fill the batter y wher e clean w ater is al w ays a v aila ble f or flushing the skin. 1. Positive post 3. Charger red (+) wire 2. Negative post 4. Charger black (–) wire • F ollo w all instr uctions and com
Краткое содержание страницы № 14
7 9 Installing the Anti-Scalp Lubricating the T ractor Wheels No Parts Required Parts needed for this procedure: Procedure 2 Anti-scalp wheels Ensure that all of the necessar y points on the tractor are 2 Wheel bolt lubricated; refer to Greasing and Lubricating the T ractor 2 Locknut in Maintenance . Procedure Mount the anti-scalp wheels onto the wheel brac k ets 10 with the wheel bolts and loc kn ut ( Figure 9 ). Checking the Safety Interlock System No Parts Required Procedure Chec k the safety
Краткое содержание страницы № 15
4. Stop the engine and w ait for all mo ving par ts to stop . 5. R emo v e the ignition k ey . 6. Raise the right rear wheel off the g round and suppor t it with a jac k stand. Note: Ensure that the left rear wheel sta ys on the g round. Mechanical or h y draulic jacks may f ail to suppor t the tractor and cause a serious injur y . • Use jack stands when suppor ting the tractor . Figure 10 2. Push position 1. Operate position • Do not use h y draulic jacks. Note: T o g ain access to the adjustin
Краткое содержание страницы № 16
Product Overview 13 Controls Checking the T raction Control Become familiar with the controls ( Figure 13 ) before y ou star t the engine and operate the tractor . Pedal No Parts Required Procedure If the tractor dri v es too fast or slo w with the traction control pedal fully pressed in either direction, y ou can adjust it to set the optim um forw ard and rev erse speeds , as follo ws: 1. Loosen the screws belo w the right footrest. 2. Slide the pedal forw ard for a faster rev erse speed or bac
Краткое содержание страницы № 17
Operation In cer tain conditions, petr ol is extr emel y Note: Deter mine the left and right sides of the flamma ble and highl y explosi v e. A fir e or mac hine from the nor mal operating position. explosion fr om petr ol can bur n y ou and other s and can dama ge pr oper ty . Petrol and Oil • Fill the fuel tank outdoor s in an open ar ea Use unleaded petrol suitable for automoti v e use (85 when the engine is cold. W ipe up an y petr ol pump octane minim um). that spills. • Do not fill the fue
Краткое содержание страницы № 18
• It cleans the engine while it r uns . • It eliminates gum-lik e v ar nish buildup in the fuel system, whic h causes hard star ting . Important: Do not use fuel additi v es containing methanol or ethanol. Add the cor rect amount of fuel stabilizer/conditioner to the petrol. Note: A fuel stabilizer/conditioner is most effecti v e Figure 14 when it is mix ed with fresh petrol. T o minimize the 1. Brake pedal 2. Parking brake lever c hance of v ar nish de posits in the fuel system, use a fuel stab
Краткое содержание страницы № 19
Operating the Blade Control Starting the Engine (PT O) 1. Sit do wn on the seat. 2. Set the parking brak e; refer to Setting the P arking T he blade control (PTO) eng ag es and diseng ag es Brak e . po w er to the electric clutc h. Note: T he engine does not star t unless y ou set the Engaging the Power T ake Off (PT O) parking brak e or fully de press the brak e pedal. 1. Press the clutc h/brak e pedal to stop the tractor . 3. Push the blade control (PTO) to off ( Figure 16 ). 2. Pull the blade
Краткое содержание страницы № 20
r unning), the engine will stop . Do not mo w in r ev er se Stopping the Engine unless it is a bsolutel y necessar y . 1. Shift the throttle lev er to F ast ( Figure 18 ). If y ou need to use the blade control (PTO) while 2. T ur n the ignition k ey to Off , w ait for all mo ving bac king up , tur n off the interloc k feature using the par ts to stop , and remo v e the k ey before lea ving the rev erse interloc k switc h located near the seat brac k et operating position. ( Figure 19 ). ( Figure
