Краткое содержание страницы № 1
OPERATOR’S
MANUAL
Turf Tiger
Propane
Model: STT52V-25CH-LP
STT61V-25CH-LP
Congratulations on owning a Scag mower! This manual contains the operating
instructions and safety information for your Scag mower. Reading this manual
can provide you with assistance in maintenance and adjustment procedures to
keep your mower performing to maximum efficiency. The specific models that
this book covers are listed on the inside cover. Before operating your machine,
please read all the information encl
Краткое содержание страницы № 2
WARNING FAILURE TO FOLLOW SAFE OPERATING PRACTICES MAY RESULT IN SERIOUS INJURY OR DEATH. • Read this manual completely as well as other manuals that came with your mower. • DO NOT operate on steep slopes. To check a slope, attempt to back up it (with the cutter deck down). If the machine can back up the slope without the wheels slipping, reduce speed and use extreme caution. • Under no circumstances should the machine be operated on slopes greater than 15 degrees. ALWAYS FOLLOW OSHA APP
Краткое содержание страницы № 3
R Table of Contents Table of Contents SECTION 1 - GENERAL INFORMATION ...................................................................................1 1.1 INTRODUCTION ...........................................................................................................................................1 1.2 DIRECTION REFERENCE ...........................................................................................................................1 1.3 SERvICING THE ENGINE AND DRIvE TRA
Краткое содержание страницы № 4
R Table of Contents SECTION 5 - TROUBLESHOOTING CUTTING CONDITIONS ...............................................20 SECTION 6 - ADJUSTMENTS .................................................................................................23 6.1 PARkING BRAkE ADJUSTMENT ............................................................................................................23 6.2 TRAvEL ADJUSTMENTS ................................................................................................
Краткое содержание страницы № 5
R Section 1 GENERAL INFORMATION USE ONLY SCAG APPROvED ATTACHMENTS AND 1.1 INTRODUCTION ACCESSORIES. Your mower was built to the highest standards in the Attachments and accessories manufactured by companies industry. However, the prolonged life and maximum other than Scag Power Equipment are not approved for efficiency of your mower depends on you following the use on this machine. See Section 8-1. operating, maintenance and adjustment instructions in this manual. If additional informati
Краткое содержание страницы № 6
R Section 1 1.4 SYMBOLS SYMBOL DESCRIPTION SYMBOL DESCRIPTION Choke Transmission Parking Brake Spinning Blade 48071S On/Start Spring Tension on Idler Off/Stop Oil Falling Hazard Thrown Object Hazard Fast Slow Continuously Variable - Linear Cutting Element - Basic Symbol Pinch Point Cutting Element - Engage 481039S Hour meter/Elapsed Operating Hours Cutting Element - Disengage Thrown Object Hazard Read Operator's Manual Keep Bystanders Away 2
Краткое содержание страницы № 7
R Section 2 SAFETY INFORMATION 2.1 INTRODUCTION DANGER Your mower is only as safe as the operator. Carelessness or operator error may result in serious bodily injury or death. Hazard control and accident prevention are The signal word “DANGER” denotes that an extremely dependent upon the awareness, concern, prudence, and hazardous situation exists on or near the machine that proper training of the personnel involved in the operation, could result in high probability of death or irreparab
Краткое содержание страницы № 8
R Section 2 3. DO NOT allow children to ride or play on the 10. Be sure the interlock switches are functioning machine, it is not a toy. correctly. 4. Clear the area to be mowed of objects that could be 11. Fuel is flammable; handle it with care. Fill the LP picked up and thrown by the cutter blades. tank outdoors. Never fill it indoors. Clean up any spillage before starting the engine. 5. DO NOT carry passengers. 12. Keep flammable objects (cigarettes, matches, etc.), 6. DO NOT operate the
Краткое содержание страницы № 9
R Section 2 3. Stay two cut widths away from slopes, drop offs, 15. Disengage power to the attachments when ditches and retaining walls. transporting or when not in use. 4. To prevent tipping or loss of control, start and stop 16. The machine and attachments should be stopped smoothly, avoid unnecessary turns and travel at and inspected for damage after striking a foreign reduced speed. object, and damage should be repaired before restarting and operating the machine. 5. When using any attac
Краткое содержание страницы № 10
R Section 2 Lower the roll bar only when absolutely necessary. 2.5 ROLL-OvER PROTECTION SYSTEM 1. To lower the roll bar, loosen the tension knob on both the left hand and right hand bar. See Figure 2-1. WARNING 2. Remove the hairpin cotter pins and remove the two (2) lock pins. See Figure 2-2. k eep the roll bar in the raised and locked position 3. Lower the roll bar to the down position. and the seat belt securely fastened during 4. To raise the roll bar, lift the bar to the upright opera
Краткое содержание страницы № 11
R Section 2 The potential exposure of the seat belt to severe environmental conditions make it crucial to inspect the o seat belt system regularly. 20 o 15 It is recommended that the seat belt be inspected on a o daily basis for signs of damage. Any seat belt system 10 that shows cuts, fraying, extreme or unusual wear, o 5 significant discoloration due to UV exposure, dirt or stiffness, abrasion to the seat belt webbing, or damage Figure 2-4. to the buckle, latch plate, hardware or any o
Краткое содержание страницы № 12
R Section 2 2.6 MAINTENANCE CONSIDERATIONS & STORAGE WARNING 1. Never make adjustments to the machine with the Hydraulic fluid is under high pressure and can engine running unless specifically instructed to do penetrate skin causing injury. If hydraulic fluid so. If the engine is running, keep hands, feet, and is injected into the skin, it must be surgically clothing away from moving parts. removed within a few hours by a doctor or gangrene may result. 2. Disengage drives, lower implem
Краткое содержание страницы № 13
R Section 2 2.9 SAFETY AND INSTRUCTIONAL DECALS WARNING INSTALL BELT COVER BEFORE OPERATING MACHINE READ OPERATOR'S MANUAL 483402 483407 483402 483407 FORWARD R F REVERSE 481568 WARNING WARNING 483406 Operation of this equipment may create sparks that can start fires around dry vegetation. A spark arrestor may be required. The operator should contact local fire agencies for laws or regulations relating to fire prevention requirements. 483900 483900 (supplied with California 483633 models on
Краткое содержание страницы № 14
R Section 3 SPECIFICATIONS 3.1 ENGINE General Type ......................................................................................................... Heavy Duty Industrial/Commercial LP Brand ............................................................................................................................. Kohler [Spec. #PS-CH730-0220] Model ...........................................................................................................................................
Краткое содержание страницы № 15
R Section 3 3.4 CUTTER DECk Type ......................... Floating, Adjustable, Anti-Scalping, Hybrid Design Combines Out-Front and Belly-Mount Designs Construction ............................................................................................................................Tri-Plate deck construction Top of deck consists of three steel plates totaling nearly 1/2" of steel,7-gauge (3/16") deck skirt. True Cutting Width: 52V ........................................................
Краткое содержание страницы № 16
R Section 4 OPERATING INSTRUCTIONS 2. Mower Deck Switch (Figure 4-1). Used to engage and disengage the mower drive system. Pulling up CAUTION on the switch will engage the deck drive. Pushing down on the switch will disengage the deck drive. Do not attempt to operate this mower unless you 3. Engine Choke Control (Figure 4-1). Used to start have read this manual. Learn the location and a cold engine. purpose of all controls and instruments before 4. Engine Throttle Control (Figure 4-1).
Краткое содержание страницы № 17
R Section 4 6. Hourmeter (Figure 4-1). Indicates the number of 14. Deck Release Lever (Figure 4-1). Used to lock the hours the engine has been operated. It only operates cutter deck in the transport position. Push the foot when the engine is running. Has preset maintenance pedal forward and pull back on the release lever to reminders for engine and hydraulic system oil release the cutter deck for normal mowing. changes. Will start flashing scheduled maintenance 15. Seat Belt (Figure 4-1).
Краткое содержание страницы № 18
R Section 4 Learn the operation on flat ground before operating 4.4 STARTING THE ENGINE on slopes. Start practicing with a slow engine speed and slow forward travel. CAUTION Learn to feather the steering controls to obtain a smooth operating action. DO NOT USE STARTING FLUIDS. Use of starting fluids in the air intake system may be potentially Practice operating the mower until you are explosive or cause a “runaway” engine condition comfortable with the controls before proceeding that co
Краткое содержание страницы № 19
R Section 4 REvERSE TRAvEL 4.6 ENGAGING THE DECk DRIvE (CUTTER BLADES) 1. Set the throttle at about 3/4 speed. Do not attempt to CAUTION engage the deck drive at high speed as this shortens the electric clutch life — use only moderate engine speed when engaging the deck drive. Disengage power to the mower before backing up. Do not mow in reverse unless absolutely 2. Engage the deck drive by pulling out on the yellow necessary and then only after observation of the switch, located on the
Краткое содержание страницы № 20
R Section 4 4.7 HILLSIDE OPERATION 4.9 AFTER OPERATION 1. Wash the entire mower after each use. Do not use high pressure spray or direct the spray onto electrical components. WARNING - IMPORTANT - DO NOT operate on steep slopes. To check a slope, Do not wash a hot or running engine. Cold water attempt to back up it (with the cutter deck down). will damage the engine. Use compressed air to If the machine can back up the slope without the clean the engine if it is hot. wheels slipping, red
