Руководство по эксплуатации Skuttle Indoor Air Quality Products SK0-0055-001

Краткое содержание страницы № 1

SK0-0055-001 HUMIDISTAT
INSTALLATION INSTRUCTIONS
The humidistat is designed for either return air duct or wall
mounting. Packaged in a duct mount configuration, (For this type
mounting begin installation at the section labeled return air duct
installation on page 2.) for conversion to a wall mount configuration
simply pull off the knob and remove the mounting screws and rotate the
control 180° and reattach the mounting base, (For this type mounting
begin installation at the section labe

Краткое содержание страницы № 2

RETURN AIR DUCT INSTALLATION 1 Locate the humidistat in the return air duct at least 12 in. up stream prior to the humidifier or the humidifier by-bass tube. 2 Remove the backing and adhere the humidistat mounting template in a horizontal position, make sure it is level. 3 Drill four 7/64 in. mounting holes. 4 Drill 1/2 in. hole in the center of the template and use tin snips to cut the rectangular hole designated by the dotted lines then remove template. 5 Remove the backing and adhere

Краткое содержание страницы № 3

WALL MOUNT INSTALLATION 1 Locate the humidistat about 5 ft. above the floor, on an inside wall, away from discharge registers. Also, avoid areas with extreme variation in relative humidity levels; i.e. bathrooms and kitchens. When wall mounting, homeowners usually prefer the humidistat mounted beside, or in the vicinity of the heating thermostat. 2 For conversion to a wall mount configuration, simply pull the indicator knob off and remove the mounting screws, and rotate the control 180°

Краткое содержание страницы № 4

WIRING INSTRUCTIONS CAUTION: ∗ Use the wiring diagram shown for single speed blower operation only. ∗ When wiring multispeed blower systems use a A50 relay or a fan sail switch to prevent premature component failure. ∗ Consult the instructions included with the humidifier and any additional controls for instructions on wiring. ∗ Fatal electrocution is possible if you contact a live wire. ∗ Electrical power can cause electrical shock ∗ Disconnect all electrical power supplied to th