Руководство по эксплуатации American Standard NEW SAVONA 2097.012

Краткое содержание страницы № 1

T
H
I
S

S
I
INSTALLATION INSTRUCTIONS
NEW SAVONA 1.6 GPF ONE-PIECE TOILET
Model 2097.012
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure
your installation conforms to local codes.
! CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pict

Краткое содержание страницы № 2

6 INSTALL TOILET a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor. ! CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED! b. Install bolt covers: 1. Make sure that the bolt cover area on the toilet is clean and dry (see figure). Use a dry piece of cloth or soap and water if needed. 2. Take plastic bolt cover and peel the brown protective film off on both ends

Краткое содержание страницы № 3

9 10 ARM TOP REFILL NIPPLE ADJUSTMENTS TUBE a. Adjust water level. Water level TANK should be adjusted to level indicated LEVER CRITICAL LEVEL on tank by adjusting float cup. Fig. 9A MARK ("C.L.") MUST BE 1" ABOVE "S" OVERFLOW PIPE FLOAT CLIP See Step 10 for water level adjustment CUP method. b. If bowl fails to siphon, an adjustment FILL FLUSH may be required with the lift chain. VALVE VALVE Simply remove the bead chain from VALVE the retainment clip (see Fig. 9A)

Краткое содержание страницы № 4

TROUBLESHOOTING 12 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 12. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: LEVER LE • The end of the refill tube is inserted into overflow pipe, below BRAS EN water level in tank. Attach refill tube to overflow pipe using "S" PREMIER clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)