Краткое содержание страницы № 1
WT600
Projector
User’s Manual
Краткое содержание страницы № 2
WT600 User’s Manual Supplement This document provides updated information that supplements the WT600 User’s Manual. Read this supplement as well as the User's Manual. Correction to “What’s in the Box?” 1 Although a Quick Connect Guide is shown on page iii of the user’s manual, the WT600 SETUP GUIDE is actually included with the projector. First read the WT600 SETUP GUIDE before operating the projector. 2 Change in [3D Reform] Operation The procedures in the user's manual are different from the
Краткое содержание страницы № 3
[Bottom] Correct the bottom side on a projected image to level as shown the drawing. Screen (solid line) Projected area (dotted line) NOTE: • In the [Pincushion] screen, when the [Top] adjustment value is "0", adjustment of [Bottom] will not be possible* . Also note that when the adjustment value of the [Top] is a small value (on the order of +5), there will be almost no change of the image even when the [Bottom] is adjusted*. • In [Pincushion] screen, when the [Bottom] adjustment value is less
Краткое содержание страницы № 4
LIMITED WARRANTY GARANZIA LIMITATA Except as specified below, the warranty that may be provided by the A parte la specificazione seguente, la graanzia che potrebbe essere dealer covers all defects in material or workmanship in this product. fornita dal rivenditore copre tutti i difetti di materiali o nella lavorazione The following are not covered by the warranty: in questo prodotto. I seguenti non sono coperti dalla garanzia : 1. Any product on which the serial number has been defaced, modified
Краткое содержание страницы № 5
WT600 Projector English User’s Manual Deutsch Français Italiano Español Svenska WARNING TO CALIFORNIA RESIDENTS: Handling the cables supplied with this product, will expose you to lead, a chemi- cal known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.
Краткое содержание страницы № 6
Important Information RF Interference Safety Cautions Precautions WARNING Please read this manual carefully before using your NEC WT600 The Federal Communications Commission does not al- Projector and keep the manual handy for future reference. Your low any modifications or changes to the unit EXCEPT serial number is located on the right side of your projector. Record those specified by NEC Soluctions (America), Inc. in this it here: manual. Failure to comply with this government regula- tion co
Краткое содержание страницы № 7
OFF ON POWER VIDEO RGB VIEWER AUTO ADJ. LASER SELECT PJ ASPECT FREEZE 3D REFORM HELP POINTER PIC-MUTE SLIDE VOLUME MAGNIFY ZOOM FOCUS FOLDER SLIDE LIST Setup Guide NEC Software Utility Installation Guide User's Manual Important Information 6. Do not eject the PC card or LAN card while its data is be- Fire and Shock Precautions ing accessed. Doing so can damage your PC card or LAN 1. Ensure that there is sufficient ventilation and that vents are card. unobstructed to prevent the build-up of heat
Краткое содержание страницы № 8
Table of Contents Important Information .....................................................ii Selecting Noise Reduction Level ........................................................... 6-9 Safety Cautions .................................................................................................. ii Signal Type ........................................................................................... 6-9 What's in the Box? ...............................................................
Краткое содержание страницы № 9
1. Introduction • Supports most IBM VGA, SVGA, XGA, Macintosh, compo- 1-1. Introduction to the Projector nent signal (YCbCr/YPbPr) or other RGB signals within a hori- zontal frequency range of 15 to 100 kHz and a vertical fre- This section introduces you to the WT600 Projector and describes quency range of 50 to 120 Hz. This includes NTSC, NTSC4.43, key features and controls. PAL, PAL-M, PAL-N, PAL60 and SECAM standard video sig- nals Congratulations on Your Purchase of The WT600 Projector NOTE:
Краткое содержание страницы № 10
1. Introduction 1-2. Part Names of the Projector Mirror cover Mirror cover lock switch Front indicator Lights blue to indicate that the projector is turned on or in the Idle mode. Speaker Ventilation (outlet) Foot Foot Remote sensor Lamp cover Lamp cover screw Speaker Foot Mirror face Carrying handle Bottom of the mirror Controls Terminal panel Ventilation (outlet) Ventilation (inlet) Main Power Switch AC Input Remote sensor 1-2 AUDIO IN R L /MONO REMOTE PCCONTROL PC CARD USB AUDIO IN AUDIO OUT
Краткое содержание страницы № 11
1. Introduction Opening and Closing the Mirror Cover To close the mirror cover: To open the mirror cover: 1. Slowly close the mirror cover while holding both ends. 1. Slide the mirror cover lock switch to the unlock position. 1 1 2. Slowly open the mirror cover holding both ends. NOTE: • Do not release your hold of the mirror cover until the mirror cover is fully closed. • Do not apply excessively strong pressure against the mirror cover 2 or mirror surface while closing it. • Keep finger prints
Краткое содержание страницы № 12
1. Introduction 6. PC CARD Access Indicator Top Features Lights while accessing a PC card. PC CARD 6 7. ENTER Button 13 FOCUS Executes your menu selection and activates items selected SOURCE from the menu. 4 MENU 10 8. CANCEL Button Press this button to exit "Menus". Press this button to return 9 the adjustments to the last condition while you are in the ad- SELECT justment or setting menu. 8 7 9. SELECT (+) (–) / Volume Buttons ENTER CANCEL : Use these buttons to select the menu of the i
Краткое содержание страницы № 13
1. Introduction Terminal Panel Features 10 11 14 15 13 12 4 2 6 REMOTE PCCONTROL PC CARD USB AUDIO IN AUDIO OUT IN DVI-I RGB S-VIDEO IN DVI-I IN RGB IN RGB OUT AUDIO IN VIDEO IN L R /MONO 9 8 7 3 1 5 1. RGB IN / Component Input Connector (Mini D-Sub 15 Pin) 9. VIDEO AUDIO IN Jacks (RCA) Connect your computer using the supplied RGB cable. This L/MONO: This is your monaural or left channel audio input connector also supports a component signal and SCART out- for stereo sound coming from the VIDEO
Краткое содержание страницы № 14
E N T E R U N 1. Introduction 6. POWER OFF Button 1-3. Part Names of the Remote Control You can use this button to turn your projector off. NOTE: If you are using a Macintosh computer, you can click either the right-click or left-click button to activate the mouse. NOTE: To turn off the projector, press and hold the POWER OFF but- ton for a minimum of two seconds. 7. VIDEO Button Press this button to toggle between Video and S-Video in- puts. 3 8. RGB Button 2 1 Press this button to select RGB,
Краткое содержание страницы № 15
E N T E R U N 1. Introduction 20. HELP Button 4 Provides the online help or the set information. 6 5 OFF ON POWER 8 VIDEO RGB VIEWER 21. POINTER Button 7 9 Press this button to display pointers; press again to hide the AUTO ADJ. LASER pointer. You can move your pointer icon to the area you want 10 11 on the screen using the Select button. See page 4-2. 12 13 SELECT 22. PIC-MUTE Button This button turns off the image and sound for a short period 14 15 of time. Press again to restore the imag
Краткое содержание страницы № 16
1. Introduction Battery Installation Remote Control Precautions 1. Press the catch and remove the battery cover. • Handle the remote control carefully. • If the remote control gets wet, wipe it dry immediately. • Avoid excessive heat and humidity. • If you will not be using the remote control for a long time, remove the batteries. • Do not place the batteries upside down. • Do not use new and old batteries together, or use different types of batteries together Operating Range for Wireless Remote
Краткое содержание страницы № 17
2. Installation and Connections This section describes how to set up your projector and how to connect video and audio sources. When installing the projector for the first time, read the WT600 Setup Guide carefully. Your projector is simple to set up and use. But before you get started you must first: 1. Set up a screen and the projector. NOTE: Using a warped screen can cause an image to appear distorted. 2. Connect your computer or video equipment to the projector. See page 2-3 to 2-7. 3. Conne
Краткое содержание страницы № 18
2. Installation and Connections 2-1. Setting Up the Screen and the Projector Selecting a Location The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is approximately 40" (1.0 m) measured diagonally when the pro- jector is roughly 2.5 inches (64mm) from the wall or screen. The largest the image can be is 100" (2.54m) when the projector is about 26 inches (660mm) from the wall or screen. Use the drawing below as a guide. Screen width Scre
Краткое содержание страницы № 19
2. Installation and Connections 2-2. Making Connections NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector. * If the screen goes blank while using your notebook PC, it may be the result of the computer's screen-saver or power management software. * If you accidentally hit the PO
Краткое содержание страницы № 20
2. Installation and Connections To connect SCART output (RGB) Before connections: An exclusive SCART adapter (ADP-SC1) and a commercially available SCART cable are required for this connection. NOTE: Audio signal is not available for this connection. Projector Video equipment such as DVD player RGB IN REMOTE PCCONTROL PC CARD USB AUDIO IN AUDIO OUT IN DVI-I RGB S-VIDEO IN DVI-I IN RGB IN RGB OUT AUDIO IN VIDEO IN L R /MONO To RGB IN Female Commercially available SCART cable ADP-SC1 1. Turn off t
