Краткое содержание страницы № 1
Operating Instructions
LCD Projector
Model No. PT-AX200E
Before operating this product, please read the instructions carefully and save this manual for future use.
TQBJ0236
ENGLISH
Краткое содержание страницы № 2
Important Information Important Safety Notice Dear Panasonic Customer: This instruction booklet provides all the necessary operating information that you might require. We hope it will help you to get the most out of your new product, and that you will be pleased with your Panasonic LCD projector. The serial number of your product may be found on its bottom. You should note it in the space provided below and retain this booklet in case service is required. Model number: PT-AX200E Serial numb
Краткое содержание страницы № 3
Important Safety Notice IMPORTANT: THE MOULDED PLUG (U.K. only) FOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark a or the BSI mark ` on the body of the fuse. If the plug contains a
Краткое содержание страницы № 4
Contents Quick steps Important Information Important Safety Notice........................................ 2 Precautions with regard to safety ....................... 6 1. Set up your projector WARNINGS.................................................................6 See “Setting up” on page 14. CAUTIONS..................................................................7 Cautions when transporting.........................................8 Cautions when installing................................
Краткое содержание страницы № 5
Contents Settings Maintenance Menu Navigation ..................................................27 TEMP and LAMP Indicators ............................... 40 Navigating through the MENU .................................. 27 Managing the indicated problems............................. 40 Main menu and sub-menu ........................................ 28 Care and Replacement ....................................... 41 PICTURE menu.....................................................30 Cleaning the
Краткое содержание страницы № 6
Important Information Precautions with regard to safety WARNINGS If you notice smoke, strange smells or noise coming Do not place the projector on top of surfaces which from the projector, disconnect the mains plug from are unstable. the mains socket. If the projector is placed on top of a surface which is Do not continue to use the projector in such cases, sloped or unstable, it may fall down or tip over, and otherwise fire or electric shocks could result. injury or damage could result.
Краткое содержание страницы № 7
Precautions with regard to safety Do not use the projector in a bath or shower. Replacement of the lamp is recommended to be Fire or electric shocks can result. carried out by a qualified technician. The lamp has high internal pressure. If improperly Do not place your skin into the light beam while the handled, explosion might result. projector is being used. The lamp can easily become damaged if struck Strong light is emitted from the projector’s lens. If you against hard objects or dr
Краткое содержание страницы № 8
Important Information Precautions with regard to safety Do not mix old and new batteries. Disconnect the mains plug from the mains socket as If the batteries are inserted incorrectly, they may a safety precaution before carrying out any cleaning. explode or leak, and fire, injury or contamination of Electric shocks can result if this is not done. the battery compartment and surrounding area may If the lamp has broken, ventilate the room result. immediately. Do not touch or bring your face
Краткое содержание страницы № 9
Precautions with regard to safety Cautions when installing Avoid setting up in places which are subject to If installing the projector to the ceiling, ask a vibration or shocks. qualified technician to carry out all installation work. The internal parts can be damaged, which may cause You will need to purchase the separate installation kit malfunctions or accidents. (Model No. ET-PKX100). Furthermore, all installation work is should only be carried out by a qualified Avoid setting up in pl
Краткое содержание страницы № 10
Important Information Precautions with regard to safety Accessories Make sure the following accessories are provided with your projector. Remote control for AA batteries for remote Safety cable Lens cover (x1) PT-AX200E (x1) control (x2) TTRA0140 TKKL5372 N2QAYB000194 Attachment screw (x1) Safety cable (x1) Mains lead for continental Europe (x1) Mains lead for UK (x1) K2CM3FR00002 K2CT3FR00003 * The protectors for enclosed products, such as a plug cover or foam cartons must be treated properly.
Краткое содержание страницы № 11
About Your Projector Remote control POWER button While the MAIN POWER button is on, switch between stand-by mode and projection mode. (page 19) Remote control signal emitter Remote control signal. (page 22) PICTURE MODE buttons Switch to the best setting Turn the button backlight for a darker room. of the remote control on/ off. (page 22) Switch to the best setting for a brighter room. Display the COLOUR MANAGEMENT menu. Display the FAVOURITE (page 24) LOAD menu. (page 22) Display the P
Краткое содержание страницы № 12
Preparation About Your Projector Projector body Top and front view POWER/LAMP/TEMP indicators (page 19/page 40) Luminance sensor Senses the luminance for the POWER LIGHT HARMONIZER feature. While the MAIN POWER is on, (page 31) switch between stand-by mode and project mode. (page 19) RETURN Return to the previous menu. (page 27) Control panel INPUT SELECT MENU Navigate through the menus with Switch to cycle through the Display the main menu. F G H I, and activate the menu input method. (
Краткое содержание страницы № 13
About Your Projector Back and bottom view SERIAL Connect a compatible cable for COMPUTER IN controlling the projector Connect an RGB signal cable remotely via your computer. from your PC. S-VIDEO IN Connect a S-VIDEO signal cable. VIDEO IN Connect an RCA composite video cable. Connecting terminals (page 18/page 46) HDMI IN COMPONENT IN Connect HDMI signal cables. Connect YPBPR signal cables. MAIN POWER Switch the projector on/off (page 19) AC IN Lamp unit compartment Connect the mains lea
Краткое содержание страницы № 14
Getting Started SD Setting up Screen size and throw distance You can adjust the projection size with 2.0x zoom lens. Calculate and define the throw distance as follows. Projected image SW Screen Projection size (16 : 9) Throw distance (L) Screen Diagonal Minimum distance Maximum distance Screen height (SH) Screen width (SW) (SD) (LW) (LT) 1.02 m (40") 0.50 m (1'7") 0.89 m (2'11") 1.2 m (3'11") 2.4 m (7'10") 1.27 m (50") 0.62 m (2') 1.11 m (3'7") 1.5 m (4'11") 3.0 m (9'10") 1.52 m (60") 0.75 m (
Краткое содержание страницы № 15
Setting up Projection method You can use the projector with any of the following 4 projection methods. To set the desired method in the projector, See “INSTALLATION” on page 38. Setting on a desk/floor and Setting on a desk/floor and projecting from front projecting from rear INSTALLATION: FRONT/DESK INSTALLATION: REAR/DESK Mounting in the ceiling and Mounting in the ceiling and projecting from front projecting from rear INSTALLATION: FRONT/CEILING INSTALLATION: REAR/CEILING NOTE: • A tra
Краткое содержание страницы № 16
Getting Started Setting up Lens shift and positioning If the projector is not positioned right in front of the centre of the screen, you can adjust the projected image position by moving the lens shift dials within the shift range of the lens. Adjusting the lens shift lever 1.Screw the shift lever counterclockwise to unlock. 2.Move the shift lever to adjust the projected image position. 3.Screw the shift lever clockwise to lock. Horizontal shift You can place the projector where the projector
Краткое содержание страницы № 17
Setting up Projector location range You can determine where to locate the screen and the projector by considering the lens shift possibilities. See “Positioning the image” on page 21. When the screen position is fixed Projector Vertical centre of screen Placement SH Centre of lens SW When the projector position is fixed Shift range 63% 63% 25% 25% Projector NOTE: • When the projector is located right in front of the screen and the lens shift dials is centred, you will get the best quality o
Краткое содержание страницы № 18
Getting Started Connections Before connecting to the projector Read and follow the operating and connecting instructions of each peripheral device. The peripheral devices must be turned off. Use cables that match each peripheral device to be connected. Confirm the type of video signals. See “List of compatible signals” on page 45. Audio cables must be connected from each peripheral device directly to the audio reproduction system. Connecting to COMPONENT IN/VIDEO IN/S-VIDEO IN \ DVD player
Краткое содержание страницы № 19
Switching the projector on/off Mains lead Connecting Disconnecting 1. Make sure the shape of 1. Make sure the MAIN POWER is switched off and the mains plug and the unplug the mains lead from the mains socket. AC IN connector on the 2. Hold the plug and unplug the mains lead from the back of the projector AC IN connector on the side of the projector. match, then push the plug all the way in. 2. Connect the mains lead to a mains socket. NOTE: • Do not use other than the provided mains lead. •
Краткое содержание страницы № 20
Basic Operation Switching the projector on/off Switching on the projector POWER indicator 1. Switch the MAIN POWER button on. 3. Press the POWER button. The power indicator lights up in red. The power indicator lights up in green after flashing 2. Remove the lens cover from the lens. for a while. The STARTUP LOGO is displayed on the screen. See “STARTUP LOGO” on page 38. NOTE: • • When starting up the projector, some small rattling or tinkling sound may be heard, or the display may flicker
