Краткое содержание страницы № 1
Basic Useful
Introduction Easy Start Setup Connections Appendix
Operation Features
DATA PROJECTOR
MODEL
XG-PH80W-N
XG-PH80X-N
OPERATION MANUAL
Краткое содержание страницы № 2
IMPORTANT • For your assistance in reporting the loss or theft of your Projector, please record Model No.: the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packag ing, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 11. ii
Краткое содержание страницы № 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted. In the unlikely event of the socket outlet in your home not being com
Краткое содержание страницы № 4
The supplied CD-ROM contains operation instructions in English, German, French, Spanish, Italian, Dutch, Swedish, Portuguese, Chinese, Korean and Arabic. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Spanisch, Italienisch, Niederländisch, Schwedisch, Portugiesisch, Chinesisch, Koreanisch und Arabisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Proj
Краткое содержание страницы № 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Project or, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefi t of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptl
Краткое содержание страницы № 6
INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications.
Краткое содержание страницы № 7
Introduction Useful Features How to Read this Operation Manual ■ The specifi cations are slightly different, depending on the model. However, you can connect and operate all models in the same manner. • In this operation manual, the illustration and the screen display are simplifi ed for explanation, and may differ slightly from the actual display. Using the Menu Screen Adjustment buttons ( // / ) MENU button Buttons used in Adjustment buttons ( // / ) this operation MENU button RETURN
Краткое содержание страницы № 8
Contents Preparing Switching the Input Mode ....................... 33 Introduction Adjusting the Volume .............................. 33 Displaying the Black Screen and How to Read this Operation Manual ......3 Turning Off the Sound Temporarily ....... 33 Contents .................................................4 Resize Mode .......................................... 34 IMPORTANT SAFEGUARDS ..................6 How to Access the PDF Operation Useful Features Manuals..........................
Краткое содержание страницы № 9
Introduction Adjusting the Projector Function (“PRJ - ADJ” Menu) ...........................52 Detecting the Input Signals Automatically .. 52 Auto Power Off Function ........................ 52 Auto Restart Function ............................. 52 Eco+Quiet .............................................. 52 Setting the Lamp Mode .......................... 53 Setting the Audio .................................... 53 Using the Ex. Setting .............................. 53 Fan Mode Setting ......
Краткое содержание страницы № 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing.
Краткое содержание страницы № 11
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, When replacement parts are required, be or integral convenience receptacles as this sure the service technician has used can result in a risk of fi re or electric shock. replace ment parts specifi ed by the manufacturer or have the same 16. Object and Liquid Entry characteristics as the original part. Never push objects of any kind into this Unauthorized substitutions may result in product thro
Краткое содержание страницы № 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high- ■ Potential hazard of glass particles if lamp altitude areas such as mountains (at ruptures. In case of lamp rupture, contact altitudes of approximately 1,200 your nearest Sharp Authorized Projector meters (4,000 feet) or more) Dealer or Service Center ■ When you use the projector in high-altitude for replacement. areas with thin air, set “Fan Mode” to See
Краткое содержание страницы № 13
Introduction Caution regarding usage of the projector Temperature monitor function ■ If you are not to use the projector for a long ■ If the temperature inside the projector time or before moving the projector, make increases, due to blockage of the air vents, certain you unplug the power cord from the or the setting location, the lamp will turn wall outlet, and disconnect any other off, the cooling fan will run and then the cables connected to it. projector will enter Standby mode, and ■ D
Краткое содержание страницы № 14
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM. To ® ® utilize these manuals, you need to install Adobe Reader on your computer ® ® (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : Insert the CD-ROM in the CD-ROM drive. Insert the CD-ROM in the CD-ROM drive. Double click the “My Computer” icon. Double click the “CD-ROM
Краткое содержание страницы № 15
Introduction Accessories Supplied accessories Dustproof cap <9NK3392038200> Two R-6 batteries RGB cable Remote control (“AAA” size, UM/SUM-4, (6' (1.8 m)) Anti-theft screw <9NK5041821400> HP-7 or similar) <9NK3081405002> <9NK3100132500> Power cord* (1) (2) (3) (4) For U.S., Canada, etc. For Europe, except U.K. For U.K., Hong Kong For Australia, New (6n (1.8 m)) (6n (1.8 m)) and Singapore Zealand and Oceania <9NK3090204900> <9NK3090152701> (6n (1.8 m)) (6n (1.8 m)) <9NK3090152901> <9NK30901
Краткое содержание страницы № 16
Accessories (Continued) Optional accessories Projection Distance for 100" Screen Size Lens Type XG-PH80W-N XG-PH80X-N Fixed wide lens (× 0.8) AN-PH808EX 5'6" (1.7 m) 5'2" (1.6 m) Wide-zoom lens (× 1.3 – 1.8) AN-PH814EZ 9'5" (2.9 m) – 12'8" (3.9 m) 8'10" (2.7 m) – 11'11" (3.6 m) Standard zoom lens (× 1.8 – 2.4) AN-PH818EZ 12'7" (3.8 m) – 16'7" (5.1 m) 11'10" (3.6 m) – 15'8" (4.8 m) Tele-zoom lens (× 2.2 – 4.4) AN-PH823EZ 15'8" (4.8 m) – 31'4" (9.5 m) 14'10" (4.5 m) – 29'6" (9.0 m) Tele-zoom len
Краткое содержание страницы № 17
Introduction Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. Top View 1 1 9 9 31 1 FOCUS buttons For adjusting the focus. 2 H&V LENS SHIFT (P/R/O/Q) buttons 30 For shifting the lens horizontally and vertically. 2 2 3 MENU button 41 For displaying adjustment and setting screens. 4 Adjustment buttons (P/R/O/Q) 41 For selecting menu items. 3 3 5 ENTER button 33 For setting items selected or adjusted on the menu
Краткое содержание страницы № 18
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10 11 11 12 12 13 13 11 11 14 14 15 15 16 16 17 17 18 18 19 19 Side View (Terminals) 1 COMPUTER/COMPONENT1 input 9 Speaker 53 terminals 21, 23 10 Intake vent 62 Terminal for computer RGB and component signals and audio input terminal. 11 Dust fi lter 62 2 LAN terminal 25 12 AC socket 27 Terminal for controlling the proje
Краткое содержание страницы № 19
Introduction Z Numbers in refer to the main pages in this operation manual where the topic is explained. 7 AUTO SYNC button 36 For automatically adjusting images when connected to a computer. 8 LENS SHIFT button 30 For displaying the lens shift adjustment 1 screen. 10 9 3D MODE button 59 For displaying the 3D MODE menu screen. 2 10 INPUT button 33 For switching Input mode. 11 3 11 PAGE DOWN button 37 12 Same as the [Page Down] key on a computer keyboard, when with the USB 4 conn
Краткое содержание страницы № 20
Part Names and Functions (Continued) Inserting the Batteries Remove the cover by sliding towards the direction 1 1 of the arrow. Insert the batteries. 2 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Replace the cover. 3 3 Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below Caution • Danger of explosion if battery is incorrectly replaced. Replace only with alkaline or ma
