Краткое содержание страницы № 1
ENGLISH FRANÇAIS ESPAÑOL PORTUGUÊS
XV-Z15000
XV-Z15000
PROJECTOR OPERATION MANUAL
PROJECTEUR MODE D’EMPLOI
PROYECTOR MANUAL DE MANEJO
PROJETOR MANUAL DE OPERAÇÃO
SHARP CORPORATION
Printed in China
Imprimé en Chine
Impreso en China
Impresso na China
TINS-E012WJZZ
09P01-CH-NM
Краткое содержание страницы № 2
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted. In the unlikely event of the socket outlet in your home not being comp
Краткое содержание страницы № 3
ENGLISH Before using the projector, please read this operation manual carefully. Introduction IMPORTANT • For your assistance in reporting the loss or theft of your Projector, please record the Serial Number lo- Model No.: XV-Z15000 cated on the bottom of the projector and retain this information. Serial No.: • Before recycling the packag ing, please ensure that you have checked the con tents of the carton thor- oughly against the list of “Supplied accessories” on page 8. High brightness li
Краткое содержание страницы № 4
INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications. However, there is no guarantee
Краткое содержание страницы № 5
Introduction Contents Preparing Introduction Setup Contents ...........................................................3 Setting Up the Projector ...............................15 Setting Up the Projector ...................................... 15 How to Read this Operation Manual .............4 Standard Setup (Front Projection) ........................ 15 IMPORTANT SAFEGUARDS............................5 Projection (PRJ) Mode ......................................... 16 Accessories .............
Краткое содержание страницы № 6
How to Read this Operation Manual ■ The specifi cations are slightly different, depending on the model. However, you can connect and operate all models in the same manner. • In this operation manual, the illustration and the screen display are simplifi ed for explanation, and may differ slightly from the actual display. Using the Menu Screen Adjustment buttons MENU button ( / / / ) Adjustment buttons ( / / / ) RETURN button ENTER button ENTER button Buttons used in this operation RETURN button M
Краткое содержание страницы № 7
Introduction IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to as- sure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use a
Краткое содержание страницы № 8
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit Warning about placing the projector in a high ■ Potential hazard of glass particles position if lamp ruptures. In case of lamp ■ When placing the projector in a high position, make cer- rupture, contact your nearest Sharp tain it is carefully secure to avoid personal injury caused Authorized Projector Dealer or Service by the projector falling down. Center for replacement. See “Regarding the Lamp
Краткое содержание страницы № 9
Introduction Other connected equipment Info ■ When connecting a computer or other audio-visual • The cooling fan regulates the internal temperature, equipment to the projector, make the connections AFTER and its performance is automatically controlled. unplugging the power cord of the projector from the AC outlet and turning off the equipment to be connected. The sound of the fan may change during projector ■ Please read the operation manuals of the projector and operation due to changes
Краткое содержание страницы № 10
Accessories Supplied accessories Remote control Two AA size batteries Operation manual Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, Canada, etc. except U.K. Singapore New Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) * Use the power cord that corresponds to the wall outlet in your country. Note Codes in “< >” are Replacement parts code
Краткое содержание страницы № 11
Introduction Part Names and Functions Numbers in refer to the main pages in this operation manual where the topic is explained. Projector Top View PICTURE MODE button 27 For selecting the appropriate picture. AUTO V-KEYSTONE 25 button ENTER button 34 Vertical keystone correction is For setting items selected or adjusted performed automatically. on the menu. INPUT buttons (P/R) 26 STANDBY/ON button For switching input mode. 13, 22 For turning the power on and putting the projector Adjustmen
Краткое содержание страницы № 12
Part Names and Functions (Continued) Projector (Rear View) Terminals COMPONENT terminals HDMI1, 2 terminals 18 18, 19 Terminal for connecting video Terminal for connecting video equipment with component equipment with HDMI output output terminal. terminal. RS-232C terminal S-VIDEO input 21 18, 19 Terminal for terminal controlling the Terminal for projector using a connecting video computer. equipment with an S-video terminal. COMPUTER/COMPONENT VIDEO input 18, 20 18 input terminal term
Краткое содержание страницы № 13
Introduction Numbers in refer to the main pages in this operation manual where the topic is explained. Remote Control STANDBY button ON button 14, 22 13, 22 For putting the projector into For turning the power on. the standby mode. AUTO SYNC button 27 HDMI1, 2, COMPONENT, 14, 26 For automatically adjusting images S-VIDEO, VIDEO, when connected to a computer. COMPUTER buttons For switching to the respective PICTURE MODE button 27 input modes. For selecting the appropriate picture. FREEZE b
Краткое содержание страницы № 14
Using the Remote Control Inserting the Batteries 1 Pull down the tab on the cover and remove the cover towards the direction of the arrow. 2 Insert the supplied batteries and put back the cover. • Make sure the polarities correctly match the m and n marks inside the battery compartment. • When putting back the cover, be sure that the cover clicks in place and settles. 30° 30° Usable Range 23' (7 m) The remote control can be used to control the projector within the ranges shown in the il
Краткое содержание страницы № 15
Quick Start Quick Start This section provides an example showing how to connect the projector to video equipment that has an HDMI output terminal with a brief explanation of the steps from connection through to image projection. For details, see the pages suggested in each step. 3, 7 STANDBY/ON 7 STANDBY button button 3 ON button 5 Input Mode Select buttons 6 Zoom ring 5 INPUT button 6 Focus ring 6 Adjustment feet Page 15 1. Place the projector facing a screen 2. Connect the projector t
Краткое содержание страницы № 16
Quick Start (Continued) 4. Turn the video equipment on and start playback Playback Page 26 5. Select the input mode Press HDMI1 on the remote control to select “HDMI1” for the Input mode. HDMI1 button HDMI1 Component 1080P • Press HDMI1, HDMI2, COMPONENT, S-VIDEO, VIDEO and COMPUTER on the remote control to switch the Input mode. • Press P or R to select your desired input mode when you press INPUT on the remote control or on the projector. Page 23 6. Adjust the projector angle, focus and zoo
Краткое содержание страницы № 17
Setup Setting Up the Projector Setting Up the Projector For optimal image quality, position the projector perpendicular to the screen with the projector’s feet fl at and level. Note • The projector lens should be centered in the middle of the screen. If the horizontal line passing through the lens center is not perpendicular to the screen, the image will be distorted, making viewing diffi cult. • For optimal image, position the screen so that it is not in direct sunlight or room light. Light fal
Краткое содержание страницы № 18
436"×245" 70"×39" 35"× 20" 87"×49" 174"×98" Setting Up the Projector (Continued) Projection (PRJ) Mode The projector can use any of the 4 projection modes, shown in the diagram below. Select the mode most ap- propriate for the projection setting in use. (You can set the PRJ Mode in “SCR-ADJ” menu. See page 44.) ■ Table mounted, front projection ■ Ceiling mounted, front projection Menu item ➞ “Front” Menu item ➞ “Ceiling + Front” ■ Table mounted, rear projection ■ Ceiling mounted, rear projec
Краткое содержание страницы № 19
Setup Screen Size and Projection Distance When using a wide screen (16:9): In case of displaying the 16:9 picture on the whole of the 16:9 screen. Picture (Screen) size Projection distance [L] Distance from the lens center to the bottom of the image [H] Diag. (x) Width Height Minimum [L1] Maximum [L2] 3 500" (1270 cm) 436" (1107 cm) 245" (623 cm) 51'6" (15.7 m) — 39 /8" (100 cm) 1 400" (1016 cm) 349" (886 cm) 196" (498 cm) 41'2" (12.6 m) 47'6" (14.5 m) 31 /2" (80 cm) 5 300" (762 cm) 2
Краткое содержание страницы № 20
Samples of Cables for Connection •For more details of connection and cables, refer to the operation manual of the connecting equipment. •You may need other cables or connectors not listed below. Terminal on Terminal on the Equipment connected Cable projector equipment Video equipment HDMI output HDMI cable (commercially available) HDMI1, 2 terminal ( Page 19) Component Component cable (commercially available) COMPONENT video output terminal 3 RCA to mini D-sub 15 pin cable COMPUTER/ (optional
