Руководство по эксплуатации Bowens InternationalBWL-0353/2 (05/07)

Краткое содержание страницы № 1

ESPRIT GEMINI INSTRUCTIONS BWL-0353/2 (05/07)
BOWENS INTERNATIONAL LIMITED
355 Old Road
Clacton on Sea
Essex CO15 3RH UK
Tel: +44 (0)1255 422807
Fax: +44 (0)1255 436342
www.bowens.co.uk

Краткое содержание страницы № 2

Table of Contents Specifications GM200 GM250 GM500 GM750+ Description Page 200Ws 250Ws 500Ws 750Ws BW3650 BW3600 BW3610 BW3630 BW3655 BW3605 BW3615 N/A Introduction and Safety Notes 3 5V 5V 5V 5V 5600K ±300K 5600K ±300K 5600K ±300K 5600K ±300K Control Panels 4 230V - 5A (F) 230V - 5A (F) 230V - 5A (F) 10A (T) Fuse Connecting & Using the Esprit Gemini 5 (115V - 10A (T)) (115V - 10A (T)) (115V - 10A (T)) 190-250V AC 50Hz 190-250V AC 50Hz 190-250V AC 50Hz 190-250V AC 50Hz Mounting 5 (95-130V A

Краткое содержание страницы № 3

Introduction Dear Valued Customer, Unit Thank you for choosing the Bowens Esprit Gemini professional flash system. Stored Energy (max) Accurate, ergonomic, powerful and simple to use, the Esprit Gemini was designed by working closely with photographers to develop a flash that meets the standards demanded in professional Part Code (230V) studios today. Part Code (117V) All ʻS-Typeʼ accessories from the Bowens range can be used with the Esprit Gemini. For details Sync Voltage of all related pr

Краткое содержание страницы № 4

Control Panel Guide Accessories The Bowens Explorer 1500 represents the state-of-the-art in portable battery generator technology. Weighing just under 12kg, this petite power-pack boasts an enviable power-to-size ratio and recycling Rear Control Panel capacity while providing photographers with the flexibility of two independent digitally controlled channels 1 for use with Bowens Quad heads, both with /10 stop increment and accuracy. Carry handle In addition, two Bowens Gemini sockets allow th

Краткое содержание страницы № 5

Flash Tube Replacement Connecting & Using the Esprit Gemini Ensure that the unit is switched off and disconnected from the !!! WARNING HIGH VOLTAGE !!! mains supply and then wait thirty minutes before touching / removing flashtube. Remove the protective cap and unwind the twisted Trigger wire NEVER CONNECT THE ESPRIT GEMINI TO BOTH A MAINS SUPPLY AND A from the flashtube support. BATTERY SUPPLY AT THE SAME TIME. Gently pull the flashtube assembly out of the unit. THIS APPLIANCE MUST BE EAR

Краткое содержание страницы № 6

Fitting the Modelling Lamp Modelling Lamp Control Switch off and disconnect from the supply. Screw modelling lamp into ES lampholder in the centre of the With the modelling lamp control switch (Fig.1. 3) in the upper position the modelling light is OFF. With reflector. Allow lamp to cool before removing. the modelling light set to centre the modelling light will go out when the unit is flashed and come back on when the unit comes to ready. This enables the photographer to see from the camera