Краткое содержание страницы № 1 
                    
                         
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                  
                    
                    Краткое содержание страницы № 2 
                    
                                                       Product name: Video Receiver (RX7101)  Release Date: 2007/09/21   Manual Revision: 1.10   Web site: www.vivotek.com    Email: technical@vivotek.com   sales@vivotek.com  Made in Taiwan. ©Copyright 2000-2006. All rights reserved       - 1 -      www.vivotek.com    T: 886-2-82455282    F: 886-2-82455532                                                                                                                                                                        
                    
                    Краткое содержание страницы № 3 
                    
                               Before You Use This Product  The use of surveillance devices may be prohibited by law in your country. It is the  user’s responsibility to ensure that the operation of such devices is legal before  installing this unit for its intended use.     It is important to first verify that all contents received are complete according to the  list in the "Package Contents" chapter. Take notice of the warnings in “Quick  installation guide” before the Video Receiver is installed, then carefully read
                    
                    Краткое содержание страницы № 4 
                    
                                Table of Contents   Before You Use This Product......................................................................2  Package Contents....................................................................................5  Installation.............................................................................................6  Physical Description............................................................................6  Front Panel...................................................
                    
                    Краткое содержание страницы № 5 
                    
                               Maintenance.................................................................................... 28  Appendix.............................................................................................. 29  A. Troubleshooting ........................................................................... 29  Status LED ................................................................................ 29  Reset and restore ....................................................................... 3
                    
                    Краткое содержание страницы № 6 
                    
                               Package Contents RX7101 Software CD     Power adapter Quick installation guide        Terminal connector Warranty card                 - 5 -      www.vivotek.com    T: 886-2-82455282    F: 886-2-82455532                                                                                                                                                                                                                                                                                                  
                    
                    Краткое содержание страницы № 7 
                    
                              Installation  The Video Receiver only supports one privileged account to access and configure it. In  this manual, "Administrator" refers to the person.  Physical Description  Front Panel    “Status LEDs” Two LEDs show the status of Video Receiver. Please refer to the  Appendix Troubleshooting for details.  “Talk” The button is reserved to support two way audio.  “Switch channel”   (1) In the multiple channel mode and “Sequential display” were set, to push the button  to stop or start the 
                    
                    Краткое содержание страницы № 8 
                    
                              Rear Panel    “Power cord socket” Plug the power jack of the included power adapter to Video  Receiver. Connecting the power adapter should be the last operation while physically  installing Video Receiver.  “Reset button” Refer to the Appendix Troubleshooting for the detailed usage of  system recovery.  “General I/O terminal block” Video Receiver provides a very flexible general I/O  interface to combine with the user’s security devices such as alarms, lighting or door  locks. One green c
                    
                    Краткое содержание страницы № 9 
                    
                              Hardware Installation      Please verify that your product package contains all the accessories listed in the  foregoing Package Contents.  Depending on the user’s application, an Ethernet cable  may be needed. The Ethernet cable should meet the specs of UTP Category 5 and not  exceed 100 meters in length.       Connect the power adapter jack to the Video Receiver    before plugging in to the power socket. This will reduce    the risk of accidental electric shock.        Shut down all the 
                    
                    Краткое содержание страницы № 10 
                    
                              Address, the green LED will blink every second.    The Video Receiver will first detect Ethernet. If it does not connect to Ethernet, the  system booting will fail. Please connect the Ethernet cable and power on again. When  system boot up, the green LED will flash every second as heartbeat to indicate alive. If  the green LED is off, please check the network connections. When system is alive, go  to next paragraph “Software installation”.    Software installation  At the end of the hardwa
                    
                    Краткое содержание страницы № 11 
                    
                              Initial Access to the Video Receiver  Check Network Settings  The Video Receiver can be connected either before or immediately after software  installation onto the Local Area Network. The Administrator should complete the  network settings on the configuration page, including the correct subnet mask and IP  address of gateway and DNS. Ask your network administrator or Internet service  provider for the detail information. By default the Video Receiver requires the  Administrator to run in
                    
                    Краткое содержание страницы № 12 
                    
                              the following figure is displayed.     The foreground is the login window and the background shows the message if  authentication fails. The option box can be checked to save the password for future  convenience.  But it is not available to the Administrator for obvious reason.    *If the administrator (root user) assigns no password, everybody can access the  homepage directly.       - 11 -      www.vivotek.com    T: 886-2-82455282    F: 886-2-82455532                                     
                    
                    Краткое содержание страницы № 13 
                    
                              Primary capability of Video Receiver  Video  The Video Receiver supports maximum four video sources. The display mode can be  single channel and multiple channels. And the multiple channel display can be display  four channel simultaneously or sequentially. In sequential mode the period of showing  a channel can be adjusted.     When single channel mode is selected, only channel 1 is effective.   In single channel mode, the video resolution can be set up to D1, the receiver  automatically 
                    
                    Краткое содержание страницы № 14 
                    
                              series.    OSD  The Video Receiver provides the following information for showing the connection or  display status.   If the IP address is empty, the video output shows "No Video" on the top-right  corner.   If the IP address is configured but the channel is disconnected, the video output  shows the IP address on the top-right corner.   In sequential multi-channel mode, if the periodic channel switch is stopped, there  should be a channel ID on the top-right corner.       - 13 -      www.
                    
                    Краткое содержание страницы № 15 
                    
                              Administrator’s capability  Software revision upgrade  Customers can obtain the up-to-date software from the web site of Vivotek. An  easy-to-use Installation Wizard is provided to upgrade the Video Receiver with just a  few clicks. The upgrade function is opened to the Administrator only. To upgrade the  system, follow the procedures below.  1. Download the firmware file named “rx7101_xxxxx.zip” and upgrade the firmware  from HTTP web page.  2. The whole process will finish in a few minut
                    
                    Краткое содержание страницы № 16 
                    
                              Definitions in Configuration  The Administrator can access system configuration. Each category in the left column  will be explained in the following pages. The bold texts are the specific phrases on the  Option pages. The Administrator may type the URL below the figure to directly enter  the frame page of configuration. If the Administrator also wants to set certain options  through the URL, read the reference appendix for details.    Overview  If the sources have been set, the overview p
                    
                    Краткое содержание страницы № 17 
                    
                              System settings  "Host name" The text displays the title at the top of the banner.   "Keep current date and time" Click on this to reserve the current date and time of  the Video Receiver. An internal real-time clock maintains the date and time even when  the power of the system is turned off.  "Sync with computer time" Synchronizes the date and time of the Video Receiver  with the local computer. The read-only date and time of the PC is displayed as updated.  “Manual” Adjust the date and 
                    
                    Краткое содержание страницы № 18 
                    
                                 http://
                    Краткое содержание страницы № 19 
                    
                              Video and audio settings  "Single channel mode" Video Receiver shows Channel 1 in video output. The video  resolution can be set up to D1, the receiver automatically scale all other resolutions to  full D1 at display.  "Multiple channel mode" Video Receiver shows four channels in video output.  "Sequential display" Video Receiver shows Channel 1, 2, 3, 4 in order. The period of  showing a channel can be adjusted below this item. The receiver automatically scales  all other resolutions to f
                    
                    Краткое содержание страницы № 20 
                    
                                     - 19 -      www.vivotek.com    T: 886-2-82455282    F: 886-2-82455532