Краткое содержание страницы № 1
For assistance and information
call toll free I-800-BUY-AIWA
(United States and Puerto Rico)
toil!?
8Z-MA4-903-I 1
DIGITALAUDIO
981 115BKM-Y-9
Краткое содержание страницы № 2
4 Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry — Take care that objects or liquid do not get inside
Краткое содержание страницы № 3
Outdoor Antenna 1 Power lines — When connecting an outdoor antenna, make sure it is located away from power lines. 2 Outdoor antenna grounding — Be sure the antenna system is properly grounded to provide protection against unexpected PREPARATIONS voltage surges or static electricity build-up. Article 810 of the National Electrical Code, ANS1/NFPA 70, provides information CONNECTIONS ................................................................. 4 on proper grounding of the mast, supporting st
Краткое содержание страницы № 4
7 Connect the right speaker to the main unit. @ Connect the speaker cord with the plug to the SPEAKERS HIGH FREQ R terminal. Check your system and accessories I-zEi61 o 1 1 Q@ . CX-ZL30 Compact disc stereo cassette receiver e“ @ .’. SX-WZL60 Front speakers Ii@!$@’ SX-R276 Surround speakers Remote control AM antenna FM antenna @ Connect the speaker cord with the white stripe to the SPEAKERS LOW FREQ R (3 terminal and the black cord QQ :C , to the O terminal. 0’ J .0 0: o ‘IQ 0s.0) D Operating Ins
Краткое содержание страницы № 5
3 Connect the Surround speakers to the main unit. Connect the right Surround ~peaker cord to SURROUND “ Be sure to connect the speaker cords correctlv. lmcwo~er ~ SPEAKERS R terminal, and the left to SURROUND connections can cause short circuits in SPEAKERS SPEAKERS L terminal. 4 Connect the supplied antennas. Connect the FM aritenna to FM 75$2 terminals and the AM ● Do not leave objects generating magnetism, such as credit antenna to AM LOOP terminals. cards, near the speakers, as the objects m
Краткое содержание страницы № 6
Inserting batteries Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries. R6(AA) When to replace the batteries The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters To turn the unit on Press one of the function buttons (TAPE, TUNER/BAND, (16 feet). When this distance decreases, replace the batteries with new ones. PHONO, VIDEO/AUX, CD). Playback of the inserted disc begins, or the p
Краткое содержание страницы № 7
P %!-.,.’.”.! !?F’,... ,!, =’. !. ,’-!,-, !,’ ... ,’J 4-CHANNEL MULTI-AMPLIFIER SYSTEM To provide reinforcement for the ultra-low frequencies, in addition to the Left/Right 2-channel amplifier used to reproduce mid-to- high-range frequencies, this system incorporates a second UR 2-channel amplifier just for reproduction of ultra-low frequencies — making it, in effect, a 4-amplifier system. By utilizing discrete amplifiers for mid to-high-frequencies and low frequencies, high- quality sonic repro
Краткое содержание страницы № 8
To reset the game Demo Press DEMO twice, then press ~. The game starts again. To change the probability of equalizing the three numbers Press ++ or F+ repeatedly to select one of the three probability levels when playing the game Demo. The tray number indicator in the display changes between 1 and 3. As the tray number increases from 1 to 3, the higher the probability of equalizing. ● During the game Demo, ■ , +, - and - are available When the AC cord is plugged into an AC outlet for the first t
Краткое содержание страницы № 9
This unit provides the following three different equalization curves: ROCK: Powerful sound emphasizing treble and bass VOLUME CONTROL POP: More presence in the vocals and midrange CLASSIC: Enriched sound with heavy bass and fine treble Turn VOLUME on the main unit, or press VOL A or V on the remote control. Press GEQ repeatedly to select the equalization The volume level is displayed as a number from Oto MAX (50). mode. The volume level is automatically set to 20 when the power is The GEQ mode i
Краткое содержание страницы № 10
To search for a station quickly (Auto Search) Press TUNER PRESET repeatedly to display “SEARCH” (auto search mode), and turn MULTI JOG clockwise or counterclockwise until the frequency starts to change rapidly. After tuning in to a station, the search stops. SEARCH To stop the Auto Search manually, turn MULTI JOG a little in either direction. c The Auto Search may not stop at the stations with very weak signals. ● ++ DOWN and -UP are also available to search for a station. Keep + DOWN or -UP pre
Краткое содержание страницы № 11
MULTI JOG ) ,, .— ~, ; i,~ ‘- . ...---..2 The unit can store a total of 32 preset stations. When a station is (Deck 1) (Deck 2) stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly. Usable tapes Use Type I (normal) tapes only. 1 Press TUNER/BAND to select a band, and press ++ DOWN or ~UP to select a station. 1 PressTAPE, then press 9/4 to open the cassette holder. 2 Press II SET to store the station. A preset number beginning from 1 in
Краткое содержание страницы № 12
Load discs. To plav all discs in the disc compartment, press F. Play begins with the disc on tray 1. Number of track being played Elapsed playing time To tNav one disc only, press one of DISC DIRECT PLAY 1- 5. The selected disc is played once. Selected disc tray, number Elaps~d playing time Number of track being played Press CD, then press A OPEN/CLOSE to open the To stop play, press ■ . To pause play, press II. To resume play, press again. disc compartment. Load disc(s) with the label side To s
Краткое содержание страницы № 13
ImH ● When loading an 8-cm (3-inch) disc. make sure to place it onto the inner circle of the trav mecisely. Otherwise, the disc may The silent portions between tracks recorded on a CD can be “’~ be damaged or the disc compartment will not open. If it does skipped during playback. ‘&, not open, please consult your Aiwa dealer for repair. h: ● Do not place more than one compact disc on one disc tray. @ 7 Press CD/CD BLANK SKIP on the main unit. ● Do not tilt the unit with discs loaded. Doing so ma
Краткое содержание страницы № 14
To check the program Each time 44 or - is pressed in stop mode, a disc number, track number, and program number will be displayed. To clear the program Up to 30 tracks can be programmed from any of the inserted Press ■ CLEAR in stop mode. discs. To add tracks to the program Repeat steps 2 and 3 in stop mode. The track will be programmed after the last track. To change the programmed tracks Clear the program and repeat all the steps again. To play the programmed tracks repeatedly After programmin
Краткое содержание страницы № 15
To record part of the CD When ● is pressed, recording always starts from the first track. ‘,:’: To start in the middle of a track, play the CD first and press II SET ‘$. for CD at the point you wish to start recording from. Then, press %& ● .The pause mode for CD button is released automatically and ‘~, recording starts. & Q Sound adjustment during recording The output volume and tone of the speakers or headphones are @ freely varied without affecting the recording. ,g:, M nEEEl :;;# ; ● Do not
Краткое содержание страницы № 16
6 Press ● on Deck 1 to start recording on the first side. ~ flashes for 10 seconds, and then CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, DeFk 1 enters the recording [ DIRECT DI Av 1-K stop mode. After entering the recording stop mode go to step ‘ULT1 ‘OG ~ r~ni I-u 7. 7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to display the program for the second recording. “B” is displayed. 8 Turn over the tape in De
Краткое содержание страницы № 17
Remaining Programmed time on side A track numbers Selected track number Prog;am number 6 Repeat step 5 for the rest of the tracks for side A. A track whose playing time is longer than the remaining time cannot be programmed. 7 Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side B and program the tracks for side B. Tape side B (reverse side) 8;10 u In the programmed edit recording function the tracks can be programmed while checking the remaining time on each side of the
Краткое содержание страницы № 18
~ The unit can be turned off automatically at a specified time. When the clock is set, the “:” between the hours and minutes flashes. When the clock setting is canceled due to a power failure, Use the remote control. the entire clock display flashes. 1 Press SLEEP while pressing SHIFT on the remote 1 Press Il. control. When using the remote control, press CLOCK while pressing 2 Within 4 seconds, turn MULTI JOG or press ++ or -to specify the time until the power is turned 2 Within 4 seconds, turn
Краткое содержание страницы № 19
Adjust the volume. 5 The source sound will play at the volume level set in this step when the power is turned cm by the timer. If the volume level is set to 21 or higher, however, it will automatically be set to 20 when the power is turned on. Prepare the source. 6 To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2. To listen to the radio, tune into a station. Press POWER to turn off the power. 7 @ remains on the display after the
Краткое содержание страницы № 20
To check the timer setting Press TIMER. The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 4 seconds. To change any of the previous setting Carry out from step 1. E 1 CD DIGITAL OUT However, if you do not change the timer-on time, in step 3 just (OPTICAL) press ENTER twice and continue from step 4. RaHa To cancel the timer standby mode temporarily Press TIMER so that 0 disappears. — VIDEO/AUX IN To restore the timer standby mode, press T
