Руководство по эксплуатации Genesis Advanced Technologies Cables Servo/Bass

Краткое содержание страницы № 1

Genesis Servo Bass Cable
Owner’s Manual
Rev.1.0

Краткое содержание страницы № 2

The Genesis Servo/Bass Cable The concept of our servo-bass system is an easy one to understand. It employs an accelerometer in the woofer to constantly monitor the movement of the cone and instantaneously compare it to the input signal. This comparison circuit identifies any deviation from the input signal and applies a corrective signal to compensate; resulting in the virtual elimination of the inherent distortion of the woofer. In the Genesis products with an external ampli

Краткое содержание страницы № 3

Instructions For Grounding the Shield On Genesis Servo Cables Step 1.- Remove the grounding screw from the amplifier chassis. This screw is located on the rear left hand corner of the chassis bottom. Figure 1 Step 2. – Using a small piece of 240 grit sandpaper sand the paint around the screw hole until the chassis metal is exposed. Figure 2 Figure 3

Краткое содержание страницы № 4

Step 3. – Using the screw removed in step 1, attach the ring terminal connector on the Y-cable to the chassis. Figure 4 Step 4. – Connect the male 1/8” mini jack connector on the ground lead of the left channel cable pair to one of the female 1/8” mini jack connectors on the Y- cable.

Краткое содержание страницы № 5

Step 5. – Connect the male 1/8” mini jack connector on the ground lead of the right channel servo cable pair to the second female 1/8” mini jack connector on the Y-cable. Figure 6