Руководство по эксплуатации Metra Electronics 95-7330

Краткое содержание страницы № 1

INSTALLATION INSTRUCTIONS FOR PART 95-7330
APPLICATIONS
KIA Spectra/Spectra 5 2007
95-7330
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Mount Mount Units Provision
KIT COMPONENTS
A) Double DIN Trim Plate B) Double DIN Brackets
A B
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
• Phillips Screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION

Краткое содержание страницы № 2

95-7330 TABLE OF CONTENTS Dash Disassembly - KIA Spectra/Spectra 5 2007 .... ....... ........ ........ ....... ......1 Kit Assembly - Double DIN/Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . . . . . .2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 *Note: Refer also to the instructions included with the aftermarket radio.

Краткое содержание страницы № 3

95-7330 DASH DISASSEMBLY KIA SPECTRA/SPECTRA 5 2007 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove the trim panel sur- rounding the radio and including the a/c vents. (Figure A) Remove (4) Phillips screws securing 3 the radio. Unplug and remove radio. (Figure B) B Continue to kit assembly. 1

Краткое содержание страницы № 4

95-7330 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 2 Slide the Double DIN radio or the stacked ISO mount units into the bracket/trim plate assembly and secure the radio or ISO mount units to the assembly using the screws supplied with the radio or ISO mount units. (Figure B) Continue to final assem

Краткое содержание страницы № 5

95-7330 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disas

Краткое содержание страницы № 6

95-7330 NOTES 4

Краткое содержание страницы № 7

95-7330 NOTES 5

Краткое содержание страницы № 8

95-7330 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 09/11/07 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST95-7330