Краткое содержание страницы № 15
P AGE 14 of M TI984 T ELEPHONE I NTERFACE Specifications ................................ ................................ ..................... ................................ ................................ ................................ ................ 0.4B .................. ................................ ............. ................................ ................................ ................................ .......................... DTMF ................................ ...
Краткое содержание страницы № 16
Warranty Equipment. Services. hereunder. Warranty Periods. Limitations / Exclusions. equipment. THE WARRANTIES AND REMEDIES CONTAINED HEREIN ARE IN LIEU OF AND EXCLUDE ALL OTHER WARRANTIES AND REMEDIES, WHETHER EXPRESS OR IMPLIED BY OPERATION OF LAW OR OTHERWISE, INCLUDING ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Return Policy Call 800-492-1212 (inside the USA) or 610-777-1374 (outside the USA) for help identifying the (Rev. 1/97) Regional Service Center closest to
Краткое содержание страницы № 1
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
Model TI984 Telephone Interface
TABLE OF CONTENTS
General Information ................................ ................................ ................................ .................. 1
Installation ................................ ................................ ................................ ................................ . 2
................................ ................................ ................................ ...................
Краткое содержание страницы № 2
Model TI984 Telephone Interface Confidentiality Notice General Information ® ® night mode ® ® 1. 2. 3. 4. 5. n n V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS Fax: 610-775-6540 800-492-1212 610-777-1374 GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA Ringer Equivalence Number (REN): 0.4B -E -VH -16816 FCC Registration Number: ADG9ZP Model: GAI-Tronics’ TI984 Programmable Telephone Interface The particular telephone numbers to be used. Not
Краткое содержание страницы № 3
P AGE 2 14 M TI984 T ELEPHONE I NTERFACE Installation Site Requirements ® ® F to +158º F). Wiring Instructions 1. 2. f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 use with either a chassis punch or hole saw. Determine which of the 4 available conduit locations is to be used. Drill spots have been provided for enclosure. Disconnect the ribbon cable and the telephone cable, and pull the hinges out of the holes in the rear Remove the front cover by loosening the 4
Краткое содержание страницы № 4
P AGE 3 14 M TI984 T ELEPHONE I NTERFACE • • • 3. 1 4. 2 . 1 f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 . Mounting Details Figure Figure lines to the proper terminals as shown in Connect the conduit to the TI984, and run the wires through the conduit to connect power and signal of these holes. for the location Figure Install the rear enclosure on the wall using screws in the 4 corner holes. See inch) and Myers ST-4 (1.25 inch). The recommended hubs ar
Краткое содержание страницы № 5
P AGE 4 14 M TI984 T ELEPHONE I NTERFACE 2 Telephone Line Connections Figure 3 ® 3 Power 4 4 f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 . Power Connections Figure switch at the lower right of the power supply to the proper voltage setting (115 or 230 V). ground wire (green or green/yellow stripe) should be connected to terminal 4. Set the Power Selector . The earth Figure neutral wire (white) to terminal 6 and the ac hot wire (black) to terminal 2. See The
Краткое содержание страницы № 6
P AGE 5 14 M TI984 T ELEPHONE I NTERFACE Figure 4 1 ® Page/Party Connections ® 5 . 5 , ® 5 ® Remote Connections A , R D /N 6 . ® A R D /N IGHT : D /N IGHT Day Mode Night Mode In Use Not in Use f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 Flashing, mostly off Constant Off Flashing, mostly on Constant On switch. AY A programming change is required to use the remote Note between the two modes of operation. switch is used to switch the unit AY switch can be used to
Краткое содержание страницы № 7
P AGE 6 14 M TI984 T ELEPHONE I NTERFACE 6 A R D / N IGHT A and R D / N IGHT Programming: General Instructions 13 ® ® A ® D /N f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 and if the unit is in use. switch on the front panel; the LEDs on the front panel indicate day/night mode IGHT AY toggling the night mode parameters must be programmed with the unit in night mode. The mode is chosen by day mode and night mode. Day mode parameters must be programmed with the
Краткое содержание страницы № 8
P AGE 7 14 M TI984 T ELEPHONE I NTERFACE Programming Procedure 11 13 Entering and Exiting the Programming Mode 1. D /N IGHT 2. ® ® 8 ® 3. #*92 4. User Programming Programming Table 11 5. 6. Programming Example: Day Mode Dial Sequence Description #3007601 #43 #907 #10 #81 f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 Puts the unit back into operating mode #* Sets Day/Night switch for internal operation Sets dialing mode to tone Sets hang up delay to 7 seconds
Краткое содержание страницы № 9
P AGE 8 14 M TI984 T ELEPHONE I NTERFACE Programming Example: Night Mode Dial Sequence Description #31 #40 #907 Selecting an Incoming Access Method 11 Voice Access Method ® • • • : Ring Access Method ® : Selective Access Method and f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 the Ring Access method. the Voice Access method Access method is the most flexible option because it can provide the same access options available with numbers, because the user must
Краткое содержание страницы № 10
P AGE 9 14 M TI984 T ELEPHONE I NTERFACE X Y X Y , but note that X Y 11 • • • • Manual Access Method A A Operating Instructions 7 ), ® Answering Incoming Calls • • f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 number of rings and a preset paging period has elapsed. designated party line, even if the party line is in use. The call is connected after a programmed With the voice access method selected, the TI984 can be programmed to automatically connect to t
Краткое содержание страницы № 11
P AGE 10 of M TI984 T ELEPHONE I NTERFACE Terminating Calls ® • 7 • R R • Number of Incoming Rings Hang-up Delay ® ® ® Universal Parameters Internal/External Day/Night Switch f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 is to ensure that the day and night modes can be marked on the remote switch. mode. This EXTERNAL To operate the day/night mode remotely, wire a two-position switch and select the steady off means the unit is in day mode, while a blinking LED
Краткое содержание страницы № 12
P AGE 11 of M TI984 T ELEPHONE I NTERFACE Programming Table Function RESET UNIT TO FACTORY CODES (DEFAULT) # # *Function SELECT INCOMING CALL - MANUAL ACCESS METHOD # 3 3 ® A *Function SELECT INCOMING CALL - VOICE ACCESS METHOD # 3 0 P P M M A A 1 0 *Function SELECT INCOMING CALL - RING ACCESS METHOD # 3 1 ® f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 station off-hook on the designated party line. a Page/Party programmed number of rings have elapsed. To answer
Краткое содержание страницы № 13
P AGE 12 of M TI984 T ELEPHONE I NTERFACE Programming Table *Function SELECT INCOMING CALL - SELECTIVE ACCESS METHOD # 3 2 P P M M 8 . MM A X Y X ) Function SET NUMBER OF INCOMING RINGS # 4 4 Function SET HANG UP DELAY N ® NN Function SET DAY/NIGHT SWITCH (INTERNAL/EXTERNAL) # 8 X # 8 1 . # 8 0 f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 of these functions for each mode: one for Day mode and one for Night mode. only one *Choose To select external Day/Nig
Краткое содержание страницы № 14
P AGE 13 of M TI984 T ELEPHONE I NTERFACE Adjustments Sidetone ® ® Programming Summary Chart Factory Setting Factory Setting User Description for Day Mode for Night Mode Programming 4 1 f:\standard ioms - current release\42004 instr. manuals\42004-071f.doc 05/03 Day/Night Switch Internal Internal 7 seconds 7 seconds Hang-up Delay Incoming Rings in Ring Access Method Not applicable with unit Enabled Auto-connect Option in Ring Access Method Not applicable with unit Page to Answer Duration 60 se
