Краткое содержание страницы № 1
XDM7510
INSTALLATION/OWNER’S MANUAL
AM/FM/CD/MP3/WMA Receiver with Detach Face
Краткое содержание страницы № 2
XDM7510 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Remove 2 transit screws located on top of the unit. • Insert the supplied keys into the
Краткое содержание страницы № 3
XDM7510 INSTALLATION Wiring Diagram FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDM7510 uses one 10 amp ATM fuse located beside the wiring connector. 3
Краткое содержание страницы № 4
XDM7510 OPERATION Control Locations 1 2 3 4 8 11 13 5 6 7 9 10 12 23 22 21 20 19 18 17 16 15 14 Open Eject 1 13 Tune/Track Down Mute 2 14 AS/PS/Enter Preset 6/Folder Up 3 15 Mode/Search Preset 5/Folder Down 4 16 Tune/Track Up Preset 4 5 17 Audio Preset 3/Intro 6 18 Volume Preset 2/Random 7 19 Loudness Preset 1/Repeat 8 20 9 Tuner Scan/*8 21 Band/Play/Pause 10 Local/Distance/*7 22 Power 23 11 Display/*0 Reset 12 EQ/*9 *Function buttons 7, 8, 9 and 0 apply to MP3/WMA operation only. 4
Краткое содержание страницы № 5
XDM7510 OPERATION General Operation The front panel is semi-permanently attached during Front Panel Note: assembly. Please refer to the separate yellow instructions (before installation) to make the front panel removable. With the unit off, press OPEN to allow the front panel to slide Front Panel Removal down. Gently squeeze the release tab located on the bottom center underside and pull front panel down and away from unit to remove. To install, insert left side first, then push right side
Краткое содержание страницы № 6
XDM7510 OPERATION General Operation 12/24-hour Clock The clock will display 12-hour AM/PM time in USA frequency : spacing mode (PM 10 00). In European frequency spacing mode, the clock will display 24-hour time (22:00). Programmable Display In tuner mode, press and hold DISP then press TUNE ll Priority to select function priority display. “FREQ” will momentarily appear in the display. Note: "FUNC" will appear in CD or AUX modes. Radio frequency (tuner mode), CD elapsed time/track (CD mo
Краткое содержание страницы № 7
XDM7510 OPERATION General Operation Audio Press AUD to select between Volume (default), Bass, Treble, Balance & Fader. VOLUME BAS S TREBLE BALANCE F ADE R Bass Press AUD until BAS appears then rotate encoder left/right to adjust ( -6 minimum / +6 maximum). Treble Press AUD until TRE appears then rotate encoder left/right to adjust ( -6 minimum / +6 maximum). Balance Press AUD until BAL appears then rotate encoder left/right to adjust (BAL L 12-BAL 00-BAL R 12). BAL 00 represents equal balance
Краткое содержание страницы № 8
XDM7510 OPERATION Tuner Operation Seek Tuning Press TUNE or TUNE momentarily to seek the nn ll next strong station. Manual Tuning Press TUNE or TUNE for more than 2 seconds, nn ll then release. "MANUAL" will momentarily appear in the display. Press TUNE or TUNE momentarily to nn ll move radio frequency up or down one step at a time. Press and hold to advance quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning mode (default). "AUTO" will momentarily
Краткое содержание страницы № 9
XDM7510 OPERATION CD Player Operation With the label facing up, insert a standard size CD into the Insert CD CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous Eject CD mode of operation (AM, FM, or auxiliary input). If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD. Press TRACK to skip to the beginning of the next track. Track Select ll Press TRACK t
Краткое содержание страницы № 10
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. MP3 Icon The icon will illuminate anytime a valid MP3 encoded disc is inserted and flash in MP3 search/navigate modes. WMA Icon The icon will illuminate anytime a valid WMA encoded disc is inserted and flash in WMA search/navigate modes. Fold
Краткое содержание страницы № 11
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Refer to the following button function table when selecting, searching or navigating MP3/WMA files and folders: MP3/WMA Button Function Table Button Function SEARCH Direct Select, Search and Navigate Modes Enter/Confirm Preset 1 A, B, C, 1 Preset 2 D, E, F, 2 Preset 3 G, H, I, 3 Preset 4 J, K, L, 4 Preset 5 M, N, O, 5 Preset 6 P, Q, R, 6 7 S, T, U, 7 8 V, W, X, 8 9 Y, Z, /, 9 0 -, _, +, 0 AUD Character Shift Rotary Encoder Character Sele
Краткое содержание страницы № 12
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Alphanumeric File Press SEARCH for more than 3 seconds, then release. or Folder Search Press SEARCH again, an " " will flash in the display. * Step 1 Use the buttons in the table on page 11 (32 character maximum input) or the rotary encoder to enter the desired alphanumeric search characters. Press AUD to advance one character to the right. Step 2 Press to initiate the selected alphanumeric search. Step 3 Turn the rotary encoder to
Краткое содержание страницы № 13
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Navigating Note After navigating by direct select, alphanumeric search or file/folder navigate modes, the track number and elapsed time will be displayed by default. Press DISP momentarily to select clock, track name, directory name, title, artist, album, year or comment. *Folder Access Press to select the previous folder. Press to select the next folder. *Folder access is only available on MP3/WMA discs recorded with more
Краткое содержание страницы № 14
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management). • WMA lossless format • Discs recorded with Track At Once or packet writing • MP3 PRO format • MP3 playlists • WAV format Playback Order MP3/WMA playback sequence is based on recorded order
Краткое содержание страницы № 15
XDM7510 OPERATION CD Player Operation - MP3/WMA Files Additional MP3/WMA An internal buffer provides ESP (Electronic Skip Protection) to Information virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only. Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play discs which contain non-MP3/WMA files w
Краткое содержание страницы № 16
XDM7510 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. What to do? You may also have other rights which vary from 1. Before you call for service, check the state to state. troubleshooting guide in your owner’s manual. A slight adjustment of any custom Dual Electronics Corp. warrants this product to controls or connections discussed in your the original purchaser to be free from defects in instruction booklet may save you a service material and workmanship
Краткое содержание страницы № 17
XDM7510 OPERATION Specifications CD Player Frequency response: 10Hz-20kHz Channel separation @ 1kHz: >65dB D/A converter: 1 Bit FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz General Operating voltage: 11-16 VDC, negative ground Speaker output impedance: 4~8 ohms Line output v
Краткое содержание страницы № 18
XDM7510 OPERATION Troubleshooting Problem Cause Action Unit will not turn on Yellow wire not connected or incorrect voltage Check connections for proper voltage (no power) Red wire not connected or incorrect voltage (11~16VDC) Black wire not connected Check connection to ground Fuse blown Replace fuse Unit has power Speaker wires not connected Check connections at speakers (but no sound) One or more speaker wires touching each Insulate all bare speaker wires from other or touching chassis gro
Краткое содержание страницы № 19
XDM7510 OPERATION Notes 19
Краткое содержание страницы № 20
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2006 Dual Electronics Corp. All rights reserved. Windows Media and the Windows logo are trademarks, or registered trademarks of Microsoft Corporation in the United States and or other countries. NSA0206-V02
