Краткое содержание страницы № 1
Краткое содержание страницы № 2
Welcome! Dear Customer, CONGRATULATIONS. The VR500CS-BT MP3/CD Player with AM/FM Receiver, USB Port and SD Card Slot, Electronic Anti-Shock (ESP) & Fold-down Detachable Face, when used as described, will give you years of dependable service in your car, truck, RV, or mini-van. We have taken numerous measures in quality control to ensure that your product arrives in top condition and will perform to your satisfaction. In the rare event that your VR500CS-BT MP3/CD Player with AM/FM Receiver,
Краткое содержание страницы № 3
Precautions • This unit will only play the following discs. • This unit does not play files that have Digital Rights Management(DRM). • If you have files that have Digital Rights Management(DRM) you should consult with the vendor that you purchased files from for instructions on proper use. Type of disc Label on the disc Recorded material Size of disc CD, MP3, & WMA Audio only 12 cm • Do not attempt to modify the unit. • Do not operate in extremely high or • Modifying the unit will void the wa
Краткое содержание страницы № 4
Notes On Installation • Disconnect negative battery terminal before starting installation. Consult the vehi- cle’s owner’s manual for proper instruction. • The unit is designed for a 12Volt DC negative ground operation system only. Before installing the unit, confirm that your vehicle is a 12Volt DC negative ground system. • Be sure to connect the color coded leads according to the diagram. Incorrect con- nections may cause the unit to malfunction or damage the vehicle’s electrical sys- tem. •
Краткое содержание страницы № 5
Before You Install Automotive audio equipment installations can be challenging at times, even to the most experienced of installation technicians. If you are not confident working with electrical wiring, removing and re-installing interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed. IMPORTANT! BEFORE THE FINAL INSTALLATION OF THE HEAD UNIT, CONNECT THE WIRING TEMPORARILY, MAKING SURE THE UNIT
Краткое содержание страницы № 6
Installtion DIN FRONT-MOUNT (Method A) Bend the tabs to secure the 1. Dashboard Mounting Sleeve in the dashboard. After inserting the Mounting Sleeve into the dashboard, select tabs on top, bottom, and sides, then bend them to secure the mounting sleeve 3. Screw in the dash board.(Fig. 1) 2. Mounting Sleeve Fig. 1 Follow the diagram in Fig. 2 1. Dashboard 2. Nut (5mm) for installing the rear mounting 3. Spring washer strap to the head unit. The rear 4. Screw (5 x 25mm) mounting
Краткое содержание страницы № 7
Installation DIN REAR-MOUNT (Method B) Installation using the screw holes on both sides of the unit. 1. Screw holes on the side of the unit. 2. Screws. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 3. Vehicle’s Factory Mounting Bracket 4. Dashboard or Console 5. Hook (Remove this part) Note: The mounting sleeve, outer trim ring, and the mounting strap are not used for this method of installation. PARTS 2 Keys
Краткое содержание страницы № 8
Installation MICROPHONES The VR500CS-BT has the ability to use two microphones. One microphone is built-in, the other is a remote microphone. Built-In Microphone The built-in microphone is located on the front right side of the unit. There is no setup required for this microphone and it is tuned to pick-up the voices of the front and rear seat passengers. Built-In Microphone (not visible) Microphone Jack Microphone Jack The suppled microphone shall be used to ensure the sound quality of the
Краткое содержание страницы № 9
Wiring Connections Make sure you have good chassis ground. A good ground connection will eliminate most electrical noise problems. A good chassis ground requires a tight connection to the vehicle’s metal chassis. The area around the ground connection should be clean, bare metal without rust, paint, plastic, dust, or dirt for a good electrical connection. RCA Line Out ANTENNA SOCKET Red = Right White = Left Sub W. Out Hole For Mounting Bracket Red = Right White = Left Connect to Dimmer Switch
Краткое содержание страницы № 10
Location Of The Controls 1 2 3 4 5 6 7 8 9 10 11 12 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 1. Answer/ Green Phone 17. Scan/Star Sign 2. Volume/SEL/Enter 18. Auxiliary Input 3. Disc Slot 19. PHONE 4. Liquid Crystal Display (LCD) 20. Mode/Mute 5. 0-9, #, & * Key Pad buttons 21. FPS/Repeat 6. Random / No. 4 22. BND•ID3 7. No.1 / Top 23. Next Track/Fast Forward 8. No.5 / Down 10 24. Previous Track/Fast Reverse 9. Intro/No. 2 25. Power 10. Eject 26. Remove Faceplate 11. No. 6 / UP 10 27. Hang u
Краткое содержание страницы № 11
Remote Control Operating the Remote Control Aim at the front panel of the CD Receiver. The maximum operating distance is about 6M. Make sure that the signal path is not obstructed. Do not drop or throw the remote control. Do expose the remote control to direct sunlight or place next to a heating unit or other heat source. 1. Power On/Off 1 2 3 4 2. Volume Up 3. Select/Menu/Enter 4. Volume Down 5. Intro/No. 2 6. No.1/Top 15 7. No. 5/Down 10 5 16 8. No. 4/Random 6 17 9. No. 8/TA Control 7
Краткое содержание страницы № 12
Basic Operation available. 1. Tuning the Unit On / Off Press any Button to turn the unit on, the dis- play will show a message WELCOME to in- 8. Treble dicate it is ready for use. Press the POWER Press Volume Knob until the display shows button for 2 seconds to turn the unit off. “TRE”. Use the Volume Knob to adjust. When DSP is ON, treble control is not avail- able. 2. Mode Selection Press the BAND Button to select Radio Mode. Press and hold the MOD/MUT But- 9. Balance ton to cycle the Play
Краткое содержание страницы № 13
Bluetooth Connection quick reference. Before Connecting Turn the VR500CS-BT ON, then turn your 5. Answering a Call cell phone’s Bluetooth Function ON. When there is an incoming phone call, press the GREEN PHONE Button on the front 1. Pairing panel or on the remote control to receive 1. Press the “PHONE” button. the call through your car radio. 2. Press and hold the Volume Knob until you see “DISP OFF”, 6. Ending a Call 3. Press the Volume Knob repeatedly to When you have finished or wish
Краткое содержание страницы № 14
Bluetooth Connection Press and hold to disconnect the current 10. Recently Received Calls phone call so that you can connect with an- After connecting with cell phone; other call. 1. Press the “PHONE” button. 2. Press and hold the Volume Knob until you see “OUT NUM”, then press the Volume 14. Ringtones Knob until the display shows “IN NUM”. 1. Press the “PHONE” button. 3. Press and hold the Volume Knob and the 2. Press and hold the Volume Knob until display will show the most recent received
Краткое содержание страницы № 15
Radio Operation 1. Choose Radio Band 5. Automatic Store/Preset Scan Press the BND•ID3 Button anytime to ac- A. Automatic Scan & Store cess the radio function. While listening to the FM Radio, press and The unit comes with five bands - three FM hold the F/PS Button for more than 3 sec- (FM1, FM2, and FM3) and two AM (AM1 and onds. The receiver will automatically scan AM2) Band selects. Each of the five bands and save stations to one of the FM Bands. can store up to six preset stations, for a
Краткое содержание страницы № 16
Radio Operation (Cont) MASK ALL modes. Then leave the unit idle 1. AF - Alternative Frequency for the mode to take effect. During MASK Press the AF button and the unit will choose DPI mode, the unit will mask only the AF the strongest FM signal for the selected which has different PI (Program Identifica- station, so that you do not have to re-tune tion), this is the default mode; during MASK the station when driving between different ALL mode, the unit will mask the AF which transmitter
Краткое содержание страницы № 17
CD Operation (Cont) cally switch to Radio Mode. display. Press this button again to cancel the repeat function. 2. Multi-Session CD Reading This unit can read multi-session CDs. 8. Random The multi-session reading will be activated On the Remote or Head Unit, press the automatically if the player detects a file that RDM/4 Button to play all the tracks in ran- is written in multi-session format. Press and dom order. “RDM ON” will appear on the hold the Volume Knob until “DSP OFF” is display.
Краткое содержание страницы № 18
USB/SD/MMC Card Operation Press the |<< Button to go to a previous memory, insert a USB flash memory into the track. Track numbers will be shown on the USB port on the left side of the unit. The display. Press and hold the |<< Button to unit will start playing MP3/WMA files on the fast reverse. Disc will play normally when USB flash memory automatically. Or press the >>| or |<< Button is released. the MODE Button to select USB after press- ing POWER Button to turn on the unit. 4. Play/ Pause
Краткое содержание страницы № 19
Search Modes For MP3/WMA Files 4. Scanning Tracks 2. Track Search On the Remote or Head Unit, press the Press the F/PS Button and the display will 2/INT Button to play the first 10 seconds show “TRK SCH”. Press the Volume Knob of each track. Press this button again to so that “TRK” will blink on the display. resume playback. Then use the Volume Knob to choose your desired track and press the Volume Knob again to confirm the selection. The selected 5. Repeat track will be searched for and th
Краткое содержание страницы № 20
RCA Out, SUB Out & ID3 Tag SCROLL 1 displays the ID3 information 8 1. RCA Output characters at a time. The RCA Output Jacks are on the back of SCROLL 2 displays the ID3 information by dis- the unit. (Refer to Wiring Diagram) This out- playing the first 8 characters, then scrolls the put is for connecting an amplifier, equalizer, information across the LCD from left to right. or other audio componement that requires To choose a scroll mode, press and hold a pre-amp out connection. (Red =
