Руководство по эксплуатации Canon ip3000

Краткое содержание страницы № 1

Краткое содержание страницы № 2

2. Installation Procedure: st 1) 1 Step: Pull the rubber plug out of the bottom tray (Picture 9). Keep the Ink Filling Hole of the ink tank opened (Picture 10). Insert it into the bottom tray as following: 1) let Point 2 slide into the tray (Picture 11). 2) Tear the other side of the tray to let the Point 1 clip into the tray (Picture 12). Make sure that the ink tank fit into the tray well (Picture 13/14). (9) (10) (11) (12) (13) (14)

Краткое содержание страницы № 3

After that: Put the CISS at the right side of Pull out the rubber plug from Insert the Air Filter. the printer. the Air Hole. nd 2) 2 Step: Remove the Original cartridge Open the cover and move the cartridge carriage to the below position, and then take off the Power Cord. Then take out the original cartridge. 3) 3rd step: Place the CISS cartridge Take off the cover from the CISS cartridge, and then install the CISS cartridge inside the

Краткое содержание страницы № 4

6) 6th Step: Insert the power cord. Put something in the Sensor. Then turn on the power button. 7) 7th step: Check the Printer Head If there is broken lines, please clean your printer head. It is possible that the air has entered the printer head. If it still shows little broken lines, especially in one color, pls stop cleaning the printer head. Just stop using the printer for about one hour, then this problem may be solved. If after this, it is still a

Краткое содержание страницы № 5

bottles on the same level with the printer. 2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge. 3. Don’t place the Reservoir Bottles higher or lower much than the printer. 4. To be used in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight. 5. Don’t put the continuous ink supply systems reversed or leaning during the shipment. Please make sure all the ink filling holes and Ventilation holes are