Руководство по эксплуатации Aprilaire 8062

Краткое содержание страницы № 1

Remove the circuit board from the base by pulling back the
4.
latch that holds it at the bottom center.
Installation Instructions
8062 TrH Support Module
Application
The Aprilaire 8062 is designed to offer versatility in climate
control. A set of onboard dip switches allows you to select
whether you want as many as two sensor inputs per support
module to control, monitor or even do a combination of both.
This temperature/humidity data is sent by digital
communications back to an Aprilaire 8870 C

Краткое содержание страницы № 2

If the support module is set to Address 1 and the Sensor 1 input is set to "monitor", then the monitored temperature will be displayed as the remote temperature in the lower left Multiple Support Module Installation hand corner of the thermostat. Otherwise, the monitored value will only be available through software that supports up to 4 support modules can be connected to provide this specific function. temperature or humidity averaging in a large area or for several zones being controlled by t

Краткое содержание страницы № 3

Configure the temperature sensor (TIm) that you are using to In order to set your thermostat up as a humidity controller, you sense outdoor temperature to the "Monitor" mode by setting the will need at least one (up to four for averaging) dipswitch 3 to the "off' position and the module address to temperature/humidity support module(s) wired to the number I. The high and low balance points are set at the thermostat. thermostat. Refer to the thermostat Installation Instructions for more details.